33
72
Starting – Riding – Parkingd Warning:
If the BMW Integral ABS fails 
in both brake circuits, a 
RESIDUAL BRAKING 
FUNCTION only is available 
(b 69).
d Warning:
If the RESIDUAL BRAKING 
FUNCTION is active (
b 69), 
maintain a defensive riding 
style and proceed immediate-
ly to a specialist workshop, 
preferably an authorised BMW 
motorcycle dealer.
d Warning:
If there is a fault in the ABS 
system, the reserves of safety 
normally afforded by ABS are 
not available until the defect 
has been put right.
There is a risk of dropping the 
machine if the brakes are ap-
plied too hard and the front 
wheel locks or the rear wheel 
lifts clear of the ground as a 
result of a high level of front 
tyre adhesion. Do not ride the 
motorcycle if you have any 
doubts about the safety of the 
brake system.
OE Optional extra
Brake system - with BMW Integral ABSOE
10r28FUNbkg1.book  Seite 72  Dienstag, 24. Januar 2006  9:31 09 
3
73
3
Starting – Riding – Parking
General 
warning 
lighte ABS warning 
light
l/
brake failure Malfunctions
OFF ON Only RESIDUAL BRAKING FUNCTION 
available in both circuits (
b 69)
OFF Flashes at 1 Hz ABS not available Pull-away test not completed (
b 70)
OFF Flashes at 4 Hz Only RESIDUAL BRAKING FUNCTION  available in both circuits (
b 69)
Self-diagnosis not completed (b 70)
ON OFF Tail light/brake light defective 
(Maintenance Instructions, ( b Chapter 2)
ON Flashes at 1 Hz At least one brake circuit without
ABS (
b 70)
ON Flashes at 4 Hz At least one brake circuit in RESIDUAL  BRAKING FUNCTION mode (
b 69)
Alternate 
flashing at 
1Hz Alternate flash-
ing at 1 Hz
Fluid level in BMW Integral ABS too low.
Check the motorcycle as follows:
– Ignition OFF: is brake pressure OK at 
the brake levers?
– Are the brakes acting on both wheels?
– Is the brake system leaktight, no signs  of brake fluid escaping?
The brake system is defective if the test 
outcome is negative.
Alternate 
flashing at 4 
Hz Alternate flas-
hing at 4 Hz
Fluid level in the BMW Integral ABS is too 
low, perform the checks listed above.
Only RESIDUAL BRAKING FUNCTION 
available in at least one circuit (
b 69)
 
d Warning:
Do not ride the motorcycle if you 
have any doubts about the 
dependability of the brake system.
BMW Integral ABSOE - Fault table
10r28FUNbkg1.book  Seite 73  Dienstag, 24. Januar 2006  9:31 09 
44
80
Arrive safely
Training means extra safety
Cornering and braking 
need to be practiced
Develop a “sixth sense” for 
potentially dangerous situa-
tions. What this means: look 
ahead, plan how to avoid possi-
bly dangerous situations and 
study other road users’ behav-
iour with a degree of healthy 
scepticism.
– Take bends smoothly and  rhythmically, avoiding violent 
braking and acceleration
– Approach bends slower than  you feel they can be taken; a 
neat riding style will get you to 
your destination more safely 
than sheer speed
– Ride at the inner edge of the  ideal line, look ahead and plan 
to leave the bend as smoothly 
as you entered it Allow for reaction time when 
judging braking distances.
– At a speed of 50 km/h 
(31 mph), for instance, 
one second’s hesitation 
means that about 14 metres 
(46 feet) are covered addition-
ally before the brakes are 
applied
– At 90 km/h (56 mph), this dis- tance grows to 25 metres 
(82 feet)
Practice applying the brakes 
with and without an extra load 
on the motorcycle, and study its 
reactions on various kinds of 
road surface.
Work up to the wheel lock limit 
gradually.
BMW has a worthwhile safety 
contribution to make in this area 
too – BMW Safety Training.
These programmes are a won-
derful opportunity: systematic 
basic and follow-up training 
enables you to master situa-
tions close to the limit and keep 
your motorcycle under 
supreme control whatever hap-
pens.
10r28FUNbkg1.book  Seite 80  Dienstag, 24. Januar 2006  9:31 09 
i
84
Index
Riding,  62
Risk of overheating,  49
Running in,  55
SSafety check,  19
Safety instructionscatalytic converter,  49
general,  48,  49
Seat,  15 adjusting,  13,  14
closing the storage 
compartment,  15
lock,  5
single,  15
Service worldwide,  76
Shock absorbers,  40
Side stand,  50,  51
Spring strut,  4
Starter button,  11
Starting the engine,  58
Storage compartment,  15
System case,  16
TTelltale and warning lights ABS,  7
battery charge,  7
engine oil pressure,  6
fuel level,  6
high (main) headlight beam,  7
neutral indicators,  7 Telltale lights
ABS,  61
battery charge,  61
engine oil pressure,  60
fuel tank level,  60
Toolkit,  5,  15
Tread depth, tyres,  42
Troubleshooting chart,  73
Troubleshooting, ABS,  73
Turn indicator switch left,  10
right,  11
Turn indicators
telltale lights,  7
Turn-indicator cancel switch,  11
Type plate,  5
Tyre pressures,  43
Tyre valve caps,  42
Tyres running-in,  55
VValve caps,  42
WWarning lightsABS,  61
battery charge,  61
engine oil pressure,  60
fuel tank content,  60
general,  61
Wheels,  42
R - Z
10r28FUNbkg1.book  Seite 84  Dienstag, 24. Januar 2006  9:31 09