2002.5 Peugeot 406 lock

29-07-2002
10 Instrument dials.
11 Driver's air bag.
Horn.
12 Windscreen washwipe
stalk.
Trip computer stalk.
13 Radio remote control stalk.
14 Steering lock and ignition.
15 Electric mirror controls.
Window controls.
Rear window locking
control.
16 Electronic Stability
Programme (ASR/ESP)
switch.
17 Headlamp height adjust
ment.
18 Fuse box. 19
Steering wheel adjustment.
20 Cruise control
21 Rear ashtray.
22 Cupholder.
23 Handbrake.
24 Heated seat switches.
Passenger air bag
disarming switch.
Alarm button
25 Lighter.
26 Rear footwell heating vent.
27 Front ashtray.
28 Gear lever.
29 Radio.
30 Heating/ventilation controls.
31 Multifunction display.
YOUR 406 AT A GLANCE
3
1 Speaker (tweeter) location.
2 Window demisting vent.
3 Side adjustable heating/
ventilation vent and air flow
regulation.
4 Glove box.
5 Passenger air bag.
6 Windscreen demisting vents.
7 Central adjustable heating/
ventilation vents and air flow
regulation.
8 Hazard warning lights switch.
9 Lights and direction indica
tors stalk.
Arming/disarming of auto
matic switching on of lights.

THE KEYS
The keys allow you to switch on
the ignition and to independently
operate the locks on the front
doors, the glove box and the pas
senger air bag disarming switch.
Central locking
From the driver's door, the keys
allow you to lock, deadlock and
unlock the doors and the boot. If
one of the front doors is open, the
central locking does not work.
The remote control performs the
same functions at a distance.The remote control
Locking
Pressing button
Alocks the
vehicle.
This is confirmed by the fixed
lighting of the direction indicators
for approximately two seconds.
Unlocking
Pressing button Bunlocks the
vehicle.
This is confirmed by the rapid fla
shing of the direction indicators. STARTING
STOP position:
The ignition is off.
1st notch, Accessories position:
The ignition is off but the acces
sories can be used.
2nd notch, Running position:
The ignition is on.
Starting position:
Operates the starter.
YOUR 406 AT A GLANCE
4
Key without
remote control Key with
remote control
29-07-2002
105

SEAT BELTS
Front seat belt height
adjustment
Pinch control 1and slide it.
To lock the seat belts
Pull the strap, then insert the end
into the buckle. YOUR 406 AT A GLANCE
7
STEERING WHEEL
HEIGHT AND DEPTH
ADJUSTMENT  Pull handle Ato unlock the
steering wheel.
Adjust the height and depth of
the steering wheel then lock it
by pushing handle Ain fully. ELECTRIC MIRRORS
Turn knob
6to the right or left to
select the corresponding mirror.
Then move the knob in all four
directions to adjust.
Foldback electric mirrors
With the ignition switched on,
turn knob 6to position A.
29-07-2002
142121140

12YOUR 406 AT A GLANCE
THE AUTOMATIC AUTOADAPTIVE GEARBOX
Moving Off
To move off from position P:
 It is essential to press the brake pedal to exit position P(shift lock)
 Select the required function (R,D,3,2or 1), then gradually release the pressure on the brake pedal; the vehicle
will move off immediately.
You can also move off from position N:
 Release the handbrake, with your foot on the brake.
 Select the required function (R, D, 3, 2 or 1)then gradually release the pressure on the brake pedal; the ve hicle
will move off immediately.
The four speed automaticgearbox provides the comfort of integral automatic regulation, enhanced by a sport
programme (switch A) and a snowprogramme (switch B).
Gear selection gate  Move the lever in the gate to select one of the functions.
Once it has been selected, the indicator light for that fu nction illuminates on the instrument panel.
P ark (parking): for parkingthe vehicle and startingthe engine, with the handbrake on or off.
R everse: for reversing. Select this function with the vehicle stationary and the eng ine at idle.
N eutral: for startingthe engine and for parking,with the handbrake on.
D rive: for driving in autoadaptive mode (automatic changing of the four gears).
3: for urban driving or driving on winding roads,(automatic changing of the first three gears only).
2: for driving on mountain roads or for towing a trailer (automatic changing of the first two gears only).
1: for tackling steep gradients (selection of first gear only).
Special feature of the gearbox
(1.8 litre, 2 litre petrol and 2
litre turbo diesel HDI)
Selection of first gear is by pres
sing switch Cwith the gear lever
in position 2.
To change out of first gear, press
switch Cagain or operate the
lever.
V6 engine 1.8 litre, 2 litre petrol and 2 litre
turbo diesel HDI engines
29-07-2002
146

Handbrake, low brake fluid level and electronic brake force
distribution warning light.
This comes on each time the ignition is switched on.
It indicates either:
– that the handbrake is on or has not been released correctly,
and when coupled with the central (STOP) warning light:
– an excessive drop in the brake fluid level (if the light remai ns on even with the
handbrake released),
– lit at the same time as the ABS warning light, it indicates a malfunction of the
electronic brake force distribution system.
Stop immediately.
Contact a PEUGEOT dealer.
Antilock braking system (ABS) warning light
This comes on for 3 seconds each time the ignition is switched o n.
If it comes on at over 8 m.p.h. (12 km/h), it indicates a malfun ction of the
ABS.
However, the vehicle retains conventional servoassisted braking.
Contact a PEUGEOT dealer.
Clogging of the
particulate emission
filter warning light
(diesel engine)
Display of this warning light is
accompanied by an audible signal.
The flashing of this light while the
engine is running is caused either by
the particulate emission filter being
overloaded or by the engine running
too long at idle (white smoke from
the exhaust). There is a risk of the fil
ter clogging if the same conditions of
operation are maintained.
As soon as possible, drive for at
least three minutes at a speed
exceeding 37 m.p.h. (60 km/h), if dri
ving conditions allow this.
If the light comes on, contact a
PEUGEOT dealer as soon as
possible. Front brake pad wear warning light
For your safety, have the pads replaced as soon as this light co
mes on.
YOUR 406 IN DETAIL 129
ESP Electronic
Stability Programme
operation indicator
light
This flashes when the system is
operating.
It is lit continuously if disarmed or if
there is a fault.
29-07-2002

YOUR 406 IN DETAIL
62
AUDIO RB2
Angle your aerial, following
the line of the windscreen.
1 – Press (behind)
2 – Press (behind)
Recommended angle for
the aerial (saloon)
Function
Increase volume
Decrease volume
1+2 – Simultaneous press
3 – Press Cutting off the sound (mute); restoring the sound by pressing
any button
Automatic search of higher frequencies (radio)
Selection of next track (CD and cassette)
4 – Press Automatic search of lower frequencies (radio)
Selection of previous track (CD and cassette)
5 – Press the end Source selection
(radio, cassette, CD changer)
6 – Rotation
(clockwise) Selection of higher frequency station stored in memory (radio)
Selection of next CD Reversal of direction of play (cassette)
7 – Rotation
(anticlockwise) Selection of lower frequency station stored in memory (radio)
Selection of previous CD
Reversal of direction of play (cassette)Movement
29-07-2002

29-07-2002
YOUR 406 IN DETAIL
72
Angle your aerial, following
the line of the windscreen. Recommended angle for
the aerial (saloon)
AUDIO RM2
1 –
Press (behind)
2 – Press (behind) Function
Increase volume
Decrease volume
1+2 – Simultaneous
press
3 – Press Cutting off the sound (mute); restoring the sound
by pressing any button
Automatic search of higher frequencies (radio)
Selection of next track (CD and cassette)
4 – Press Automatic search of lower frequencies (radio)
Selection of previous track (CD and cassette)
5 – Press
the end Source selection (radio/cassette/CD changer)
6 – Rotation
(anticlockwise)
Selection of higher frequency station stored in memory (radio)
Selection of next CD Reversal of direction of play (cassette)
7 –Rotation
(anticlockwise) Selection of lower frequency station stored in
memory (radio) Selection of previous
CD Reversal of direction of play (cassette)
Movement

29-07-2002
YOUR 406 IN DETAIL
84
Angle your aerial, following
the line of the windscreen.Recommended angle for
the aerial (saloon)
AUDIO RD3
1 – Press (behind)
2 – Press (behind) Function
Increase volume
Decrease volume
1+2 – Simultaneous
press
3 – Press Cutting off the sound (mute); restoring the sound
by pressing any button
Automatic search of higher frequencies (radio)
Selection of next track (CD)
4 – Press Automatic search of lower frequencies (radio)
Selection of previous track (CD)
5 – Press the end Source selection (radio/CD/CD changer)
6 – Rotation
(anticlockwise) Selection of higher frequency station stored in
memory (radio) Selection of next CD (CD changer)
7 –Rotation
(anticlockwise) Selection of lower frequency station stored in
memory (radio) Selection of previous CD
(CD changer)
Movement