2002.5 Peugeot 406 remote control

29-07-2002
10 Instrument dials.
11 Driver's air bag.
Horn.
12 Windscreen washwipe
stalk.
Trip computer stalk.
13 Radio remote control stalk.
14 Steering lock and ignition.
15 Electric mirror controls.
Window controls.
Rear window locking
control.
16 Electronic Stability
Programme (ASR/ESP)
switch.
17 Headlamp height adjust
ment.
18 Fuse box. 19
Steering wheel adjustment.
20 Cruise control
21 Rear ashtray.
22 Cupholder.
23 Handbrake.
24 Heated seat switches.
Passenger air bag
disarming switch.
Alarm button
25 Lighter.
26 Rear footwell heating vent.
27 Front ashtray.
28 Gear lever.
29 Radio.
30 Heating/ventilation controls.
31 Multifunction display.
YOUR 406 AT A GLANCE
3
1 Speaker (tweeter) location.
2 Window demisting vent.
3 Side adjustable heating/
ventilation vent and air flow
regulation.
4 Glove box.
5 Passenger air bag.
6 Windscreen demisting vents.
7 Central adjustable heating/
ventilation vents and air flow
regulation.
8 Hazard warning lights switch.
9 Lights and direction indica
tors stalk.
Arming/disarming of auto
matic switching on of lights.

THE KEYS
The keys allow you to switch on
the ignition and to independently
operate the locks on the front
doors, the glove box and the pas
senger air bag disarming switch.
Central locking
From the driver's door, the keys
allow you to lock, deadlock and
unlock the doors and the boot. If
one of the front doors is open, the
central locking does not work.
The remote control performs the
same functions at a distance.The remote control
Locking
Pressing button
Alocks the
vehicle.
This is confirmed by the fixed
lighting of the direction indicators
for approximately two seconds.
Unlocking
Pressing button Bunlocks the
vehicle.
This is confirmed by the rapid fla
shing of the direction indicators. STARTING
STOP position:
The ignition is off.
1st notch, Accessories position:
The ignition is off but the acces
sories can be used.
2nd notch, Running position:
The ignition is on.
Starting position:
Operates the starter.
YOUR 406 AT A GLANCE
4
Key without
remote control Key with
remote control
29-07-2002
105

29-07-2002
Display CThis enables the following information to be displayed:
– the time,
– the date,
– the outside temperature (the °C symbol flashes when there is a risk of ice),
– the radio displays,
– the status of the doors. The display shows you whether a doo r, the boot or the
bonnet is open,
– the warning messages are displayed temporarily (e.g. "top up fue l tank'') and
can be cleared using the remote control,
– the trip computer (see following page),
– the satellite navigation system (see corresponding section).
Setting the parameters
The remote control allows you to access the settings. Accessing the different
menus is described in the section on the Satellite Navigation System.
YOUR 406 IN DETAIL
136

29-07-2002
THE SATELLITE NAVIGATION
SYSTEM
Introduction
The satellite navigation system guides
you to the destination of your choice
by means of vocal and visual instruc
tions.
The heart of the system lies in the use
of a map database and GPS (Global
Positioning System). This enables
your position to be located by means
of several satellites.
The satellite navigation system con
sists of the following components:
the remote control,
the display,
the control unit,
the last voice message recall control,
the CD ROM.
Some functions or services
described in this guide may vary depending on the CD ROM version or the country.The remote control
There is a storage compartment for the remote control in front of the ashtray.
Pointing the remote control at the screen enables the informat ion contained in
the various menus to be selected.
Direction arrows:
These enable you to move around the screen and
thus select a function.
On the welcome screen only, the Up and Down
buttons enable the brightness of the screen to be
adjusted.
menu : this button allows access to the main menu. It can
be used at any time.
esc : escape button
"Short press": cancels the current operation and
returns to the previous screen.
"Press for more than 2 seconds": returns to the
welcome screen.
This button can be used in any menu. It is inactive
during guidance.
mod : mode button
"Short press": changes between date, navigation
and radio.
val : Confirmation button
Confirms the function selected.
YOUR 406 IN DETAIL 95

29-07-2002
Main menu
Switch on the ignition.
Press the "Menu"button to access the main menu.
Select a function using the direction arrows, then confirm ( "VAL" button). The
"Navigation/guidance" menu offers various options
for selecting guidance:
By entering the address of a new destination.
By selecting a service (Hotel, station, airport...) available in a town.
By selecting an address stored in one of the two directo ries.
By resuming previously interrupted guidance or by stop ping current guidance. Two messages may be displayed
depending on the previous actions: "Resume guid
ance" or "Stop guidance" .
Radio functions are suspended when the system is in guidance mode.
YOUR 406 IN DETAIL
98
Navigation / Guidance
Following selection of the "Navigation/guidance"menu,
a screen warns you about the use of the navigation sys
tem. Follow the regulations in force and do not use the
remote control while driving.
Press the "VAL"button to access the next screen.

THE KEYS
The keys allow you to switch on the
ignition and to independently operate
the locks on the front door, the glove
box and the passenger air bag dis
arming switch.
Central locking
From the driver's door, the keys
allow you to lock, deadlock* and
unlock the doors and boot/tailgate.
If one of the front doors is open, the
central locking does not work.
The remote control performs the
same functions at a distance.
The remote control
Locking
Press button Ato lock the vehicle.
YOUR 406 IN DETAIL 105
This is confirmed by fixed lighting of
the direction indicators for approxi
mately two seconds.
Unlocking
Press button
B to unlock the vehicle.
This is confirmed by rapid flashing of
the direction indicators.
Note: do not repeatedly press the
button of your remote control out of
range of your vehicle. You risk caus
ing it not to work and the remote con
trol would have to be reprogrammed. ELECTRONIC ENGINE
IMMOBILISER
This locks the engine management
system as soon as the ignition has
been switched off and therefore pre
vents starting of the vehicle by any
one who does not have the key.
The ignition key has an electronic
chip which has a special code. When
the ignition is switched on, the code is
recognised and starting is possible.
If the system does not function
correctly,
an audible signal sounds,
accompanied by a message on the
multifunction display.
WARNING: your vehicle is no longer
protected in this event.
Contact a PEUGEOT dealer as soon
as possible.
Locating your car
To locate your car, if you have locked
it, in a car park: 
press button A. The courtesy
lights come on and the direction
indicators flash for a few seconds.
Key in ignition
A buzzer sounds on opening the dri
ver's door, if the key has been left in
the ignition.
29-07-2002

29-07-2002
YOUR 406 IN DETAIL
106
Changing the battery of the
remote control
The information 'battery flat' is
given by an audible signal accompa
nied by a message on the multi
function display.
To replace the battery, unclip the
casing using a coin at the ring
(CR2016/3 volt battery).
If the remote control does not work
after the battery has been changed,
reprogramme the remote control.
Confidential card
The confidential card contains the
identification code necessary for any
work carried out by a PEUGEOT
dealer on the system. This code is
hidden by a film, which should be
removed only if necessary.
Keep your card in a safe place,
never inside the vehicle.
Programming the remote
control Switch off the ignition.
 Switch the ignition on again.
 press button A.
 Switch off the ignition and
remove the remote control key
from the ignition lock. The remote
control is now working again.
DEADLOCKING
Deadlocking the doors is an addtional
safety device.
Warning:
The internal and external door
controls cannot operate when the vehi
cle is deadlocked.
There are two methods of operation:
With the the remote control
To deadlock: pressbutton A.
This is indicated by permanent lighting
of the direction indicators for approxi
mately two seconds.
Press button A within five seconds
of deadlocking to change this to lock
ing only.
This is indicated by permanent lighting
of the direction indicators for approxi
mately two seconds.
With the ignition key from the driver's
door
To deadlock: turn the key towards the
rear of the vehicle.
To lock: within five seconds of deadlock
ing, again turn the key towards the rear
of the vehicle. To unlock: turn the key
towards the front of the vehicle.
Do not operate the dead
locking if there is someone
inside the vehicle.
Do not operate the buttons
of yur remote control while it is in
your pocket, as there is a possibility
that it may unlock your vehicle.

29-07-2002
YOUR 406 IN DETAIL107
Make a careful note of the number on each key. The key number i s coded on the label attached to the key. If
the key is lost, your PEUGEOT dealer can rapidly supply you with ne w keys.
The highfrequency remote control is a highperformance system.
Do not operate it while it is in your pocket as there is a p ossibility that it may unlock your vehicle without your knowledge .
The remote control cannot operate if the key is in the ignit ion, even if the ignition is switched off, except for reprogram
ming.
Do not operate the deadlock if there is someone inside the vehicle.
As a safety measure (when there are children on board), remove the i gnition key when leaving the vehicle, even for a
short time.
Do not handle the buttons of your remote control when out of range of your vehicle as you run the risk of stopping it from
working.
It would then be necessary to reprogramme the remote control.
When buying a secondhand car:
– ensure that you are in possession of the confidential card;
– have the key codes memorised by a PEUGEOT dealer, to ensure that the keys in your possession are the only ones
that can start your vehicle.
Do not make any modifications to the electronic engine immobil iser system.