2002.5 Peugeot 406 check engine

YOUR 406 AT A GLANCE
14
FUEL FILLER FLAP
To open: firmly pull the handle
on the floor on the right of the dri
ver's seat.
To close: from outside the
vehicle, push back the flap and
check that it is secured correctly.
Filling with fuel
Switch off the engine.
A filler cap hook is provided.
A label on the inside of the flap shows which fuels are pe rmitted and
which are not.
The capacity of the tank is approximately 15.4 gallons (7 0 litres).
Low fuel level warning light
From the time this light comes on, the range remaining is
approximately 30 miles (50 km). OPENING THE BONNET
Inside the vehicle:
Pull the
handle.
Outside the vehicle: Lift
the catch and open the
bonnet.
29-07-2002
11 011 0

PEUGEOT SERVICING
Your vehicle benefits from extended service intervals.
•For petrol engines: every 20,000 miles (30 000 km) or every two years.
• For direct injection diesel engines: every 12,000 miles (20 000 km) or every two years.
The extension of the service intervals means that the engi ne oil level must be checked regularly: topping up of the
oil between oil changes is normal.
It is for this reason, and for your complete peace of min d, that your Peugeot dealer will carry out a levels check and
topup midway between each routine service, at the time or distance intervals specified.
This will be undertaken free of charge, provided that the maintenance of your vehicle has been carried out within the
PEUGEOT network. At the same time, your Peugeot dealer will offer you a Peugeot safety check, for a nominal fee.
A Peugeot professional will carry out a quick check, and will top up the levels if necessary (oil up to 1 litre, coolant
and screen wash).
The date of the intermediate visit is not shown by the serv ice indicator.
It is to be carried out at least every 10,000 miles (15 0 00 km) for petrol engines and every 6,000 miles (10 000 km) for
direct injection diesel engines.
If the oil level is too low there is a risk of serious d amage to the engine: check the engine oil level at least every
2,000 miles (3 000 km) or 3,000 miles (5 000 km), depen ding on the conditions of use.
The extended service intervals have been made possible by technica l modifications to the vehicles and lubricants:
THUS IT IS ESSENTIALTO ONLY USE ENGINE LUBRICANTS WHICH ARE APPROVED AND REC OMMENDED BY THE
MANUFACTURER
MAINTENANCE OF YOUR 406
18
29-07-2002

SPECIAL FEATURES
Some of your vehicle's vital components have specific servicing schedules.
The air bags and the pretensioning seat belts must be checked every 10 years by a PEUGEOT dealer.
The brake fluid must be replaced every 36/40,000 miles (60 000 km) or every 2 years.
The pollen filter must be checked at each visit to the PEUGEOT dealer (intermediate vi sits and regular services).
Replacement of the timing belt: consult your Peugeot dealer.
MAINTENANCE OF YOUR 406 19
Arduous conditions of use
If the vehicle is used in certain particularly arduous condition
s:
• Continuous doortodoor use.
• Town use (e.g. taxi).
• Repeated short journeys, with the engine cold in low te mperatures.
or for long stays in the following conditions: • Hot countries with temperatures often above 30°C.
• Cold countries with temperatures often below minus 15°C.
• Countries with a dusty atmosphere.
• Countries whose lubricants or fuels do not conform to our recommen dations,
it is necessary to follow an "Arduous conditions" servicing schedule, which includes special operations and shorter ser
vice intervals:
• Every 12,000 miles (20 000 km) or every year for petrol engine vehicle s.
• Every 9,000 miles (15 000 km) or every year for Direct Injection Diesel engine vehicles.
29-07-2002

29-07-2002
MAINTENANCE OF YOUR 40623

All driving conditions. o Arduous conditions
A AND C SERVICES AND THE INTERMEDIATE VISIT
Oil filter Fuel filter (Petrol only) Fuel filter element (Diesel only) Air filter element Spark plugs (Petrol only)HPI
Operation of lights and indicators Condition of glass, headlamp & light lenses and mirrors Horn Windscreen washer jets Condition of wiper blades Condition and tension of the ancillary drive belts Handbrake Condition of hydraulic circuits (hoses and covers) Condition of rubber boots and gaiters Brake pads o Play in hubs, link rods, ball joints, flexible mountings Shock absorbers Rear drum brake lining wear Condition and pressure of tyres (including spare wheel) Emission control check (Petrol only) Smoke opacity (Diesel only) Pollen filter (according to specification)o Visual check of the whole vehicle
DRAIN and REFILL
REPLACE
LEVELS
CHECK

ROAD TEST
Courtesy vehicle
SERVICE
Level
Operation Description of Operation First Service
A C Intermediate
Engine oil Bleed fuel filter (Diesel only)
Engine oil (check + topup) Gearbox level (check + topup) Battery level (check + topup) if cap is removable Front/rear screen wash level (check + topup) Coolant level (check + topup) Brake fluid level (check + topup) Power steering fluid level (check + topup, according to specifica tion)

29-07-2002
Lighting
rheostat
With the lights on, press the button to
vary the intensity of the lighting of the
instruments and controls. When the
lighting reaches the minimum (or
maximum) setting, release the but
ton then press it again to increase (or
reduce) the brightness.
As soon as the lighting is of the
required brightness, release the
button.
Trip recorder
zero reset
With the ignition on, press the button. Instrument panel display
After switching on the ignition, three functions are shown i
n succession:
engine oil level indicator,
service indicator,
total distance recorder.
Engine oil level
When the ignition is switched on, the engine oil level indicator is displayed
for approximately five seconds, then the service indicator is displa yed for
five seconds.
Maximum
Use the dipstick to confirm the level on the indicator; a surpl us of
oil can cause damage to the engine.
Contact a PEUGEOT dealer as soon as possible.
Minimum
Check the level with the dipstick and top it up. The indi cation is
only correct if the vehicle has been on stable, level ground, with
the engine stopped, for 10 minutes.
No oil
It is essential to top up the oil to the correct level, oth erwise there
is a risk engine will be damaged.
YOUR 406 IN DETAIL
132

29-07-2002
OPENING THE BONNET
From inside:pull the handle on the
lefthand side under the fascia.
From outside: lift the catch and
raise the bonnet.
Bonnet struts
These open the bonnet and hold it
open.
To close
Lower the bonnet and release it at
the end of its travel. Check that the
bonnet is properly locked. FILLING WITH FUEL
Fill with fuel with the engine switched
off.
To open the fuel filler flap, firmly pull
the handle on the floor on the left of
the driver's seat.
If you are filling up your tank, do not
continue after the 3rd cutoff of the
pump; this could cause your vehicle
to malfunction.
The capacity of the tank is approxi
mately 15.4 gallons (70 litres).
A filler cap hook is provided on
the inside of the fuel filler flap.
YOUR 406 IN DETAIL
110

29-07-2002
AUTOMATIC SWITCHING ON
OF THE LIGHTS
Side lights and dipped beam head
lamps switch on automatically if the
light is poor, or during continuous
operation of the windscreen wipers.
They switch off as soon as the light
becomes bright enough or the wind
screen wipers stop.
This function is active when the vehi
cle is supplied to the customer.
To disarm or activate the function: Place the key in the accessories
position (1st notch),
 Press the end of the lights stalk
for more than two seconds.
Note: In foggy weather, the bright
ness sensor can detect sufficient
light. Because of this, the lights do
not come on automatically.
Do not cover the brightness sen
sor connected to the rain sensor,
located in the windscreen behind
the mirror. It is used for automatic
switching on of the lights. Operating check
Activation
Activation of this function is accom
panied by an audible signal and the
message
"Automatic lighting of
the headlamps activated" on the
multifunction display.
Note: Always operate the lighting
controls manually where this is pos
sible.
Disarming
Disarming of the function is accom
panied by an audible signal.
When driving, if this function is
switched off when the headlamps
would switch on in automatic mode,
the lights remain on.
It is however possible to disarm this
function and switch off the lights by:
manually switching off the lights using the lights stalk,
switching off the engine.
YOUR 406 IN DETAIL 123
If the brightness sensor does not
function correctly, the system acti
vates the function (the lights come
on).The driver is alerted by the flash
ing of the ''dipped beam'' warning
light on the instrument panel.
Contact a PEUGEOT dealer to have
the system checked.
Follow me Home
When there is a low level of bright
ness or at night, if you leave your
vehicle, the side lights and the
dipped beam lights may remain on
for approximately one minute.
To do this: place the lights stalk in the AUTO
position,
 place the key in the accessories
position (first notch),
 press the end of the lights stalk for
more than two seconds,
 place the lights stalk in the 0posi
tion,
 flash the headlamps,
 get out of the car and lock it.

29-07-2002
The ESPsystem offers
increased safety during
normal driving, but should
not incite the driver to take
risks or to drive at high speed.
The operation of the system is
assured to the extent to which the
recommendations of the manufac
turer regarding the wheels (tyres
and wheel rims), the braking com
ponents, the electronic compo
nents and the assembly and repair
procedures within the PEUGEOT
network are respected.
After an accident or impact, have
the system checked by a
PEUGEOT dealer.
DRIVING YOUR 406
150
TRACTION CONTROL (ASR)
AND DYNAMIC STABILITY
CONTROL (ESP)
These systems are linked and com
plement the ABS.
The ASR system optimises drive to
prevent the wheels skidding, by act
ing on the brakes of the drive wheels
and on the engine. It also allows the
directional stability of the vehicle to
be improved on acceleration.
If there is a variation between the tra
jectory followed by the vehicle and
that required by the driver, the ESP
system automatically acts on the
engine and the brake of one or more
wheels, in order to put the vehicle
back on course.
Operation of the ASR and ESP
systems
When one of these two sys
tems is operating, this light
flashes. Handbrake
Applying
When parking, pull the handbrake to
immobilise your vehicle.
W
arning: when parking on a slope,
direct your wheels towards the pave
ment and apply the handbrake.
Releasing
Pull the handle and press the button
to release the handbrake.
Disarming the ESP / ASR systems
In certain conditions (vehicle stuck in
mud or snow, or on loose ground...),
it could prove useful to disarm the
ASR system to make the wheels
spin and regain grip. 
Press the switch "ESP OFF", sit
uated to the left of the steering
wheel.
The switch lights up and the indicator
lights come on, accompanied by the
message '' ASR/ESP deactivated''
on the multifunction display: the
ESP and ASR systems no longer
affect the operation of the engine or
the brakes.
They engage again: automatically when the ignition is
switched off,
 manually by pressing the switch
again.
Operating check When a system malfunction
occurs, the switch light
flashes and the indicator
light comes on.
Contact a PEUGEOT dealer to
check the system.