29 07 2002
CHANGING A FUSE
The fuse boxes are under the fascia
and in the engine compartment.
Fascia fuse box
Turn the three screws a quarter turn
with a coin.
Pull at Aand tilt the cover to access
the fuses. Removing and changing a fuse
Before changing a fuse you must find out the cause of the fa
ult and have it put
right. The fuse numbers are indicated on the fuse box.
Use the special pliers Aattached to the box.
Always change a faulty fuse for one of the same rating.
Correct Incorrect Pliers A
Remove the fascia panel lower trim to access the built in systems in terface.
Fuse no
. Rating Functions
A 20 A Locking/Unlocking, Deadlocking.
B 10 A Rear fog lamps.
.
C 40 A Demisting the mirrors.
D 15 A Rear screen wiper.
E 30 A Electric windows.
F15 A Supply to instrument panel
Display Audio equipment
Satellite navigation system
Air conditioning.
MAINTENANCE OF YOUR 406 41
29-07-2002
PETROL / LPG DUAL FUEL VERSION167
Puncture
Insulated storage compartment
This is located in the boot and con
tains:
the temporary tyre repair cans 1
(your 406 LPG does not have a
spare wheel),
the adaptors 2 necessary for
filling the LPG tank in some
countries,
the towing eye 3.
Fuses
The LPG functions are protected
by the two fuses Ain the fuse box
located in the engine compartment.
Using the repair cans
(Refer to the directions on the cans
also)
if possible, remove the object
which caused the puncture,
rotate the wheel so that the valve is in the same position as the
figures 2 or 10 on a clock,
shake the cans vigorously before use. In very cold weather, warm
the cans between your hands for
few minutes,
hold the valve with one hand and with the other press the injection
nozzle on the can firmly onto the
valve, holding it straight,
maintain the pressure firmly for one minute, carry out the same operation with
the second can, then drive imme
diately, at a moderate speed , to
the nearest garage.
The cans enable you to carry out
a temporary repair.
After use, the tyre must be
changed.
As the cans are pressurized, they
must not be exposed to a temper
ature above 50°C.
Store them away from heat in the
insulated storage compartment.
29 07 2002
CHANGING A FUSE
The fuse boxes are under the fascia
and in the engine compartment.
Fascia fuse box
Turn the three screws a quarter turn
with a coin.
Pull at Aand tilt the cover to access
the fuses. Removing and changing a fuse
Before changing a fuse you must find out the cause of the fa
ult and have it put
right. The fuse numbers are indicated on the fuse box.
Use the special pliers Aattached to the box.
Always change a faulty fuse for one of the same rating.
Correct Incorrect Pliers A
Remove the fascia panel lower trim to access the built in systems in terface.
Fuse no
. Rating Functions
A 20 A Locking/Unlocking, Deadlocking.
B 10 A Rear fog lamps.
.
C 40 A Demisting the mirrors.
D 15 A Rear screen wiper.
E 30 A Electric windows.
F15 A Supply to instrument panel
Display Audio equipment
Satellite navigation system
Air conditioning.
MAINTENANCE OF YOUR 406 41
29-07-2002
Special features of the
automatic gearbox
When towing with four wheels on the
ground, the following rules must be
obeyed:
gear lever in position N,
tow the vehicle at less than 30 m.p.h. (50 km/h) over a maxi
mum distance of 30 miles (50 km).
do not add oil to the gearbox.
MAINTENANCE OF YOUR 406
48
TOWING YOUR VEHICLE
Without lifting (4 wheels on the road)
You should always use a tow bar.
The towing eye is inside the spare wheel.
From the front:
Lift the cover using the flat part of the towing eye.
Screw in the towing eye until it locks.
From the rear:
Unclip the cover by passing your hand behind the bumper and pu shing.
Screw in the towing eye until it locks.
Lifting (2 wheels on the road only)
It is preferable to raise the vehicle by the wheels.
Never use the radiator crossmember.
