Page 320 of 372
8-69
EBU00570
Cable inspection and lubrication
WARNING
Inspect cables frequently and replace if dam-
aged. Corrosion can result when the outer
covering of control cables becomes damaged.
Cables can also become frayed or kinked. Op-
eration of controls could be restricted, which
could cause an accident or injury.
Lubricate the inner cables and the cable ends.
If the cables do not operate smoothly, ask a
Yamaha dealer to replace them.
EBU00717
Brake lever and brake pedal lubrication
Lubricate the pivoting parts.Recommended lubricant:
Engine oil
Recommended lubricant:
Lithium-soap-based grease
(all-purpose grease)
Page 338 of 372
8-87
EBU00440
Troubleshooting chart
1. Fuel
Check if there is fuel
in the fuel tank.Enough fuelTurn the fuel
cock to “OFF”.Remove the fuel pipe
from the fuel cock. No fuelFuel cock
clogged
Clean fuel
cock. Some fuelTurn the fuel
cock to “RES”.Restart engine.
No fuel
Supply fuel
2. Compression
Use the electric
starter to see if there
is compression.Compression
Compression normal
No compression
Ask a Yamaha dealer to inspect.
3. Ignition
Remove the plug and
check the electrode.WetWipe clean with
dry cloth.
DryAttach plug cap and
ground to chassis.Use the
electric starter.Spark goodIgnition system
normal
Spark weak
Adjust plug gap
or replace plug. No spark
Ask a Yamaha dealer to inspect. 4. Battery
Use the electric
starter.Engine turns over
quickly.Battery good
Engine turns over
slowly.
Recharge, check
connections.
Check fuel
flow Turn the fuel
cock to “ON”.
Page 342 of 372
9-1
EBU00420
CLEANING AND STORAGE
A. CLEANING
Frequent, thorough cleaning of your machine
will not only enhance its appearance but will
improve its general performance and extend
the useful life of many components.
1. Before cleaning the machine:
a. Block off the end of the exhaust pipe to
prevent water entry. A plastic bag and
strong rubber band may be used.
b. Make sure the spark plug and all filler caps
are properly installed.
2. If the engine case is excessively greasy,
apply degreaser with a paint brush. Do
not apply degreaser to the wheel axles.
3. Rinse the dirt and degreaser off with a
garden hose. Use only enough pressure
to do the job.
Page 346 of 372
9-5
7. Automotive type wax may be applied to
all painted and chrome plated surfaces.
Avoid combination cleaner-waxes. Many
contain abrasives which may mar the
paint or protective finish.
When finished, start the engine and let it
idle for several minutes.
WARNING
Wet brakes may have reduced stopping abili-
ty, increasing the chance of an accident. Test
the brakes after washing. Apply the brakes
several times at slow speeds to let friction dry
out the linings.
Page 348 of 372
9-7
EBU00427
B. STORAGE
Long term storage (60 days or more) of your
machine will require some preventive proce-
dures to guard against deterioration. After
thoroughly cleaning the machine, prepare for
storage as follows:
1. Fill the fuel tank with fresh fuel and add
fuel stabilizer (if available).
NOTE:
Use of fuel stabilizer eliminates the need to
drain the fuel system. Consult a Yamaha dealer
if the fuel system is to be drained instead.
2. Remove the spark plug, pour about one
tablespoon of SAE 10W30 or 20W40 mo-
tor oil in the spark plug hole and reinstall
the spark plug. Ground the spark plug
wire and turn the engine over several
times to coat the cylinder wall with oil.
3. Lubricate all control cables.
4. Block up the frame to raise all wheels off
the ground.
Page 352 of 372
10-1
EBU00428
SPECIFICATIONS
Model YFM600FWA
Dimensions:
Overall length 2,068 mm
Overall width 1,161 mm
Overall height 1,215 mm
Seat height 865 mm
Wheelbase 1,254 mm
Minimum ground clearance 175 mm
Minimum turning radius 3,100 mm
Basic weight:
With oil and full fuel tank 290 kg
Engine:
Engine type Air-cooled 4-stroke, SOHC
Cylinder arrangement Forward-inclined single cylinder
Displacement 595 cm
3
Bore× stroke 95 × 84 mm
Compression ratio 8.5:1
Starting system Electric and recoil starter
Lubrication system Wet sump
Page 353 of 372
10-2
10
10
10
10
10
10
10
10
10
10
10
Engine oil:
Type-20°-10°0°10°20°30°40°50°C
5W/30
10W/30
10W/40
20W/50
20W/40
15W/40
Recommended engine oil classification: API Service SE, SF, SG type or higher
Quantity:
Periodic oil change
With oil filter replacement
Total amount1.9 L
2.0 L
2.6 L Model YFM600FWA
CAUTION:
Be sure to use motor oils that do not contain anti-
friction modifiers. Passenger car motor oils (often
labeled “Energy Conserving”) contain anti-friction
additives which will cause clutch and/or starter
clutch slippage, resulting in reduced component
life and poor engine performance.