Page 112 of 370
5-13
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-5.frame
EL
EBU00485
Engine oil
Make sure the engine oil is at the specified lev-
el. Fill with oil as necessary. (See pages 8-15 ~
8-23 for details.)
Temp.
-20°
-10°0°10°20°30°40°
50°C
5W/30
10W/30
10W/40
20W/50
15W/4020W/40
Recommended oil:
Recommended engine oil classification:
API Service SE, SF, SG type or higher
Page 249 of 370

8-8
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-8.frame
ER
* It is recommended that these items be serviced by a Yamaha dealer.
** Lithium-soap-based grease
NOTE:
Brake fluid replacement:
1. When disassembling the master cylinder or caliper cylinder, replace the brake fluid. Normally
check the brake fluid level and add fluid as required.
2. On the inner parts of the master cylinder and caliper cylinder, replace the oil seals every two
years.
3. Replace the brake hoses every four years, or if cracked or damaged.
Wheel bearings*
• Check bearing assembly for looseness/damage.
• Replace if damaged.
Steering system*
• Check operation.
• Repair if damaged.
• Check toe-in.
• Adjust if necessary.
Upper and lower arm
pivot and steering
shaft*
• Lubricate every 6 months.**
Rear arm pivot*
• Lubricate every 6 months.**
Fittings and Fasteners*
• Check all chassis fittings and fasteners.
• Correct if necessary.
Battery*
• Check specific gravity.
• Check breather hose for proper operation.
• Correct if necessary.
ITEM ROUTINEINITIAL EVERY
1
month3
months6
months6
months1
year
Page 262 of 370
8-21
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-8.frame
EL
CAUTION:
Be sure no foreign material enters the crank-
case.
10. Warm up the engine for several minutes
at idle speed. Check for oil leakage while
warming up.
CAUTION:
If oil leakage is found, stop the engine immedi-
ately and check for the cause.
Recommended oil:
See page 10-2.
Oil quantity:
Periodic oil change:
2.4L
With oil filter replacement:
2.5 L
Total amount:
3.2 L
Page 304 of 370
8-63
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-8.frame
EL
EBU00570
Cable inspection and lubrication
WARNING
Inspect cables frequently and replace if dam-
aged. Corrosion can result when the outer
covering of control cables becomes damaged.
Cables can also become frayed or kinked. Op-
eration of controls could be restricted, whichcould cause an accident or injury.
Lubricate the inner cables and the cable ends.
If the cables do not operate smoothly, ask a
Yamaha dealer to replace them.
EBU00737
Brake and shift pedal/brake and clutch lever
lubrication
Lubricate the pivoting parts of each lever and
pedal.Recommended lubricant:
Engine oil
Recommended lubricant:
Lithium-soap-based grease
(all-purpose grease)
Page 349 of 370
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-SPEC-E.frame
10-2
ER
1
111111191011
Engine oil:
Type
-20°
-10°0°10°20°30°40°
50°C
5W/30
10W/30
10W/40
20W/5020W/4015W/40
Recommended engine oil classification: API Service SE, SF, SG type or higherMODEL YFM350X
CAUTION
:
Be sure to use motor oils that do not contain anti-
friction modifiers. Passenger car motor oils (often
labeled “Energy Conserving”) contain anti-friction
additives which will cause clutch and/or starter
clutch slippage, resulting in reduced componentlife and poor engine performance.