2001 YAMAHA WARRIOR 350 tow bar

4-13
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-4.frame
EL
EBU00069
Clutch lever
The clutch lever is located on the left handlebar
and the ignition circuit cut-off system is incor-
porated in the clutch lever holder. Pull the
clutch lever to the handlebar to disengage the
clutch, and release the lever to engage the
clutch. The lever should be pulled rapidly and
released slowly for smooth clutch operation.
(Refer to “Starting a cold engine” for a descrip-
tion of the ignition circuit cut-off system.)
EBU00070
Front brake lever
The front brake lever is located on the right
handlebar. Pull it toward the handlebar to ap-
ply the front brake.
1. Clutch lever
1. Levier d’embrayage
1. Palanca de embrague
1. Front brake lever
1. Levier de frein avant
1. Palanca del freno delantero

6-33
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-6.frame
EL
l
Do not mount an accessory where it could
interfere with your ability to control the
ATV. Examples include (but are not limited
to) a heavy or bulky object attached to the
handlebars which could make steering diffi-
cult, an accessory that limits your ability to
move around on the seat, or one that limits
your view.
l
Use extra caution when riding an ATV with
accessories. The ATV may handle different-
ly than it does without accessories.
EBU00224
Loading
As originally equipped, this ATV is not de-
signed to carry cargo or tow a trailer. If you
choose to add accessories so that you can car-
ry cargo or tow a trailer, you must use com-
mon sense and good judgement. Keep the
following points in mind:

7-41
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-7.frame
EL
As you approach a curve, slow down and begin
to turn the handlebars in the desired direction.
As you do so, put your weight on the footboard
to the outside of the turn (opposite your desired
direction) and lean your upper body into the
turn. Use the throttle to maintain an even speed
through the turn. This maneuver will let the
wheel on the inside of the turn slip slightly, al-
lowing the ATV to make the turn properly.
This procedure should be practiced at slow
speed many times in a large off-road area with
no obstacles. If an incorrect technique is used,
your ATV may continue to go straight. If the
ATV doesn’t turn, come to a stop and then
practice the procedure again. If the riding sur-
face is slippery or loose, it may help to position
more of your weight over the front wheels by
moving forward on the seat. Once you have
learned this technique you should be able to
perform it at higher speeds or in tighter curves.
1. Lean towards inside of turn.
2. Support your weight on the outer footrest.
1. Se pencher vers l’intérieur du virage.
2. S’appuyer sur le repose-pied externe.
1. Inclínese hacia el interior del giro.
2. Descanse su peso en el descansapie externo.