2001 SUBARU FORESTER heating

ii
How to use this owner
’s manual
Using your Owner ’s manual
Before you op erate your vehic le, c arefully read thi s manual. To p rotec t
yourself and extend the servic e life of your vehic l e, follow the instruc tions
in this manual. Failure to ob serve these instruc tio ns may result in serious
injury and d amag e to your vehic le.
This manual is c omp osed of thirteen c hap ters. Eac h c hap ter b eg ins with
a b rief tab le of c ontents, so you c an usually tell at a g lanc e if that c hap -
ter c ontains the information you want. Chapter 1: Seat, seatbelt and SRS airbag
This c hap ter informs you how to use the seat and se atb elt and c ontains
p rec autions for the SRS airb ag .Chapter 2: Doors and Locks
This c hap ter informs you how to op erate the keys, l oc ks and wind ows.
Chapter 3: Instruments and controls
This c hap ter informs you ab out the op eration of ins trument p anel ind ic a-
tors and how to use the instruments and other switc hes.
Chapter 4: Climate control
This c hap ter informs you how to op erate the c limate c ontrol.
Chapter 5: Audio
This c hap ter informs you how to op erate your aud io system.
Chapter 6: Interior equipment
This c hap ter informs you how to op erate interior eq uip ment.
Chapter 7: Starting and operating
This c hap ter informs you how to start and op erate y our SUBARU.
Chapter 8: Driving tips
This c hap ter informs you how to d rive your SUBARU i n various c ond i-
tions and exp lains some safety tip s on d riving .Chapter 9: In case of emergency
This c hap ter informs you what to d o if you have a p rob lem while d riving ,
suc h as a flat tire or eng ine overheating .Chapter 10: Appearance care
This c hap ter informs you how to keep your SUBARU lo oking g ood .
Chapter 11: Maintenance and service

Seat, seatbelt and SRS airbags1-7
–
CONTINUED –
Seat heater (if equipped)
CAUTION
Use of the seat heater for long period of time while the engine
is not running can cause battery discharge. Do not put anything on the seat which insulates against heat,
such as a blanket, cushion, or similar items. This may cause theseat heater to overheat. When cleaning the seat, do not use benzine, paint thinner, or
any similar materials.
The seat heater op erates when the ig nition switc h i s either in the “ACC ”
or “ON ” p osition.
HS0034HS0285
Indicator
HI LO
Heating element
To turn on the seat heater, p ush the
“LO ” or “HI ” p osition on the switc h,
as d esired , d ep end ing on the temp erature. LO: Normal heating
HI: Rap id heating
The ind ic ator loc ated on the switc h c omes on when t he seat heater is in
op eration. When the vehic le ’s interior is warmed enoug h or b efore you
leave the vehic le, b e sure to turn the switc h off.

3-20Fog light switch (if equipped)
The fog lights operate only when the headlights are on low beam.
Push the fog light switch to turn the fog lights on.
Press the switch again to turn them off.
HB2025BB
The indicator light located on the switch will illuminate when the fog
lights are on.
Wiper and washer
WARNING
In freezing weather, do not use the windshield washer until the
windshield is sufficiently warmed by the defroster.Otherwise the washer fluid can freeze on the windshield, blocking
your view.
CAUTION
Do not operate the washer continuously for more than ten se-
conds, or when the washer fluid tank is empty. This may cause
overheating of the washer motor. Check the washer fluid level fre-
quently, such as at fuel stops.

4
Climate control
Ventilator4-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Heating and air conditioning control system 4-4 . . . . . . . . . . . . . . . . . . .
Heater operation 4-6
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Air conditioner operation 4-10
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Operating tips for heater and air conditioner 4-11 . . . . . . . . . . . . . . . . . . .
Air filtration system (if equipped) 4-12 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

4-4
Heating and air conditioning control system
Control panel
HS4001BC
1. Temp erature c ontrol d ial
2. Air inlet selec tion lever
3. Air flow c ontrol d ial
4. Air c ond itioner b utton (if eq uip p ed )
5. Fan sp eed c ontrol lever nTemperature control dial
This d ial reg ulates the temp erature of air flow fro m the air outlets over
a rang e from the b lue area (c ool) to red area (warm ).
n Fan speed control lever
The fan op erates only when the ig nition switc h is t urned to the “ON ”
p osition. The fan sp eed c ontrol lever is used to se lec t four fan
sp eed s.n Air flow control dial
This d ial has the following five p ositions:
: Air flows throug h the instrument p anel outlets.
: Air flows throug h the instrument p anel outlets an d the foot
outlets.
: Air flows throug h the foot outlets and some throug h the wind -
shield d efroster outlets.

Climate control4-7
–
CONTINUED –

Heating and defrosting
HS0074
To d irec t warm air toward the floor and the wind shi eld :
1. Set the air inlet selec tion lever to the “
” p osition.
2. Set the air flow c ontrol d ial to the “
” p osition.
3. Set the temp erature c ontrol d ial to the most c omf ortab le level.
4. Set the fan sp eed c ontrol lever to the d esired sp eed .
NOTE
Warm air also comes out from the right and left air outlets. To
stop warm air flow from these outlets, turn the correspondingthumb-wheel to the “
” position.
Heating
HS0076
To d irec t warm air toward the floor:

4-81. Set the air inlet selec tion lever to the
“
” p osition
2. Set the air flow c ontrol d ial to the “
” p osition.
3. Set the temp erature c ontrol d ial to the most c omf ortab le level.
4. Set the fan sp eed c ontrol lever to the d esired sp eed .
NOTE
Warm air also comes out from the right and left air outlets. To
stop warm air flow from these outlets, turn the correspondingthumb-wheel to the “
” position.
Bi-level heating
HS0078
This setting allows you to d irec t air of d ifferent temp eratures from the
instrument p anel and foot outlets. The air from the foot outlets is
slig htly warmer than from the instrument p anel outl ets.
1. Set the air inlet selec tion lever to the “
” p osition.
2. Set the air flow c ontrol d ial to the “
” p osition.
3. Set the temp erature c ontrol d ial to the d esired t emp erature level.
4. Set the fan sp eed c ontrol lever to the d esired sp eed .
Setting the temp erature c ontrol d ial fully turned t o the red area or b lue
area d ec reases the temp erature d ifferenc e b etween t he air from the
instrument p anel outlets and the air from the foot outlets.

Climate control4-11
–
CONTINUED –
2. Set the air outlet c ontrol d ial to the
“ ” p osition.
3. Push the air c ond itioner b utton to the “ON ” p osition.
4. Set the temp erature c ontrol d ial to the red area.
5. Set the fan sp eed c ontrol lever at the hig hest sp eed .
Operating tips for heater and air conditioner Cleaning ventilator grille
HS0083
Ventilator inlet grille
Always keep the front ventilator inlet g rille free of snow, leaves, or oth-
er ob struc tions to ensure effic ient heating and d ef rosting . Sinc e the
c ond enser is loc ated in front of the rad iator, this area should b e kep t
c lean b ec ause c ooling p erformanc e is imp aired b y an y ac c umulation
of insec ts and leaves on the c ond enser. Efficient cooling after parking in direct sunlight
After p arking in d irec t sunlig ht, d rive with the wi nd ows op en for a few
minutes to allow outsid e air to c irc ulate into the heated interior. This re-
sults in q uic ker c ooling b y the air c ond itioner. Ke ep the wind ows
c losed d uring the op eration of the air c ond itioner for maximum c ooling
effic ienc y. Lubrication oil circulation in the refrigerant circuit
Op erate the air c ond itioner c omp ressor at a low eng ine sp eed (at id le
or low d riving sp eed s) a few minutes eac h month d ur ing the off-sea-
son to c irc ulate its oil.