2001 Peugeot Partner VU lights

De-activating the passengerÕs airbag *
- With the ignition switched off, insert the key into the switch A.
- Turn the key to the Ò OFFÓ position. The passengerÕs airbag is now de-activated.
- The warning lamp, on the instrument panel, lights up when the ignition is switched on (if it flashes, there is a problem).
To re-activate the passengerÕs airbag
- Do not forget to re-activate the passengerÕs airbag. To do so, with the ignition switched off :
- Insert the key into the switch and turn to the Ò ONÓ position. The passengerÕs
airbag is now re-activated.
- The warning light in the instrument panel lights for six seconds on switching on the ignition.
* According to specification.
19I-8THE AIRBAG SYSTEM*
Never place a rearwards facing child seat on the front passenger seat when the vehicle is fitted with an airbag.
Depending on the vehicleÕs equipment, it may be possible to de-activate the
front passengerÕs airbag (see below).
The wearing of seat belts is compulsory in conjunction with the front airbags.Never deactivate the passenger's airbag when the front passenger is present
(with the exception of the use of a rear- facing child seat).
A

You can adjust the height of the steering wheel.
With the vehicle stationary,firstly adjust your seat to the best position.
Release the steering wheel by pushing the handle forwards.
18I-7ADJUSTING THE STEERING WHEEL
Adjust the steering wheel to the desired height, then lock it in position by pulling the handle fully towards you. Make sure that the instrument panel dials and indicator lights remain clear- ly visible.
IMPORTANT
For safety reasons, these manoeuvres must not be performed while driving.

1Left air vent
2 Left speaker
3 Upper glove box or passenger's airbag
4 Location of radio or glove compartment
5 Controls :
¥ Electric windows
¥ Rear screen /exterior mirror
demister
¥ Air-conditioning
¥ Hazard warning lights
¥ Heated seats
6 Location of radio / CB, car phone
7 Central air vents
8 Controls :
¥ Horn
¥ Headlamps
¥ Direction indicators
¥ Rear fog lamp
9 Instrument panel
10 Controls :
¥ Windscreen wipers
¥ Rear screen wiper
¥ Windscreen wash 11
Right speaker
12 Right air vent
13 Key-operated switch :
¥ Activation/de-activation of
the passengerÕs airbag
14 Controls :
¥ Passenger's side electric mirror
¥ Headlamp angle adjuster
15 Fusebox access flap
16 Ignition lock
17 Driver's airbag
18 Steering wheel adjustment
19 Heating controls
20 Handbrake
21 Ashtray
22 Gear lever
23 Lighter
24 Lower glove box
25 Courtesy light
* According to specification.
25I-13INSTRUMENTS AND CONTROLS *

1
11
Maintenance intervals If your vehicle is used in particular- ly harsh conditions, it is necessaryto select the maintenance sche-dules for arduous conditions (seethe Maintenance Guide) whichconsist of more frequent services.Note : if the maximum time bet-
ween two oil changes is reachedbefore the mileage is up, the span-ner symbol lights. To change the maintenanceintervals :
- Switch off the ignition. - Press and hold down button
1.
- Switch on the ignition
- The distance remaining until the next service flashes.
- Release the button immediately.
- The maintenance interval is dis- played.
- Pressing button 1briefly allows
the maintenance intervals to be alternated - When the desired maintenance
interval is displayed, press but-ton 1for ten seconds to validate
(the selected maintenance inter-val will flash for ten seconds).
Release the button to validatewhen the display stops flashing. Resetting the maintenance indi- cator to zero
Your dealer will perform this ope-
ration after each service. However,if you intend to service the vehicleyourself, the procedure for reset-ting the maintenance indicator isas follows:
- Switch off the ignition.- Press and hold down button 1.
- Switch on the ignition.
- The distance remaining until the next service flashes.
- Holdbutton 1down for ten
seconds.
- The display will read Ò=0Óand
the spanner will disappear.
29I-14INSTRUMENT PANEL*
* According to model or country.

1
11
Maintenance intervals If your vehicle is used in particular- ly harsh conditions, it is necessaryto select the maintenance sche-dules for arduous conditions (seethe Maintenance Guide) whichconsist of more frequent services.Note : if the maximum time bet-
ween two oil changes is reachedbefore the mileage is up, the span-ner symbol lights. To change the maintenanceintervals :
- Switch off the ignition. - Press and hold down button
1.
- Switch on the ignition
- The distance remaining until the next service flashes.
- Release the button immediately.
- The maintenance interval is dis- played.
- Pressing button 1briefly allows
the maintenance intervals to be alternated - When the desired maintenance
interval is displayed, press but-ton 1for ten seconds to validate
(the selected maintenance inter-val will flash for ten seconds).
Release the button to validatewhen the display stops flashing. Resetting the maintenance indi- cator to zero
Your dealer will perform this ope-
ration after each service. However,if you intend to service the vehicleyourself, the procedure for reset-ting the maintenance indicator isas follows:
- Switch off the ignition.- Press and hold down button 1.
- Switch on the ignition.
- The distance remaining until the next service flashes.
- Holdbutton 1down for ten
seconds.
- The display will read Ò=0Óand
the spanner will disappear.
29I-14INSTRUMENT PANEL*
* According to model or country.

Rear fog lamp See ÒSIGNALLINGÓ.ABS system See ÒBRAKESÓ.Diesel engine preheating warning lamp
See ÒSTARTING THE ENGINEÓ.
Left direction indicators See ÒSIGNALLINGÓ.
Right direction indicatorsSee ÒSIGNALLINGÓ.
34I-15WARNING LAMPS *
All the direction indicator lights flash at the same time when the hazard warning signal is operated.
Dipped beam See ÒSIGNALLINGÓ. Main beamSee ÒSIGNALLINGÓ.
* According to specification or country

Electronic key warning lamp Lights up when switching
on ignition if the key is not recogni- sed
* Depending on version or country.
35I-15WARNING LAMPS *
Minimum coolant fluid level warning lamp If the warning lamp lights
up, it is imperative to stop the vehicle. Check the level and takethe precautions detailed in chapter
ÒLEVELS AND CHECKSÓ).
Battery charge warninglamp Should not be on when the engine is running. If it
comes permanently on, contact
your nearest approved Dealer.
Imperative stopwarning lamp Lights up at the same time as ano-
ther visual warning or if the maxi-mum permissible coolant fluid tem-perature is reached.
Engine oil pressurewarning lamp If it lights up while you are
driving, stop the engine, check the
level, (See ÒLEVELS ANDCHECKSÓ). If it remains lit despite the level being correct, contact your nearest
approved Dealer. Warning lamp for hand-brake and for brakefluid level Indicates that the brake
is applied or incorrectly released. Also that the brake fluid level is
insufficient. See ÒBRAKESÓ,
ÒLEVELS AND CHECKSÓ . The warning lamp may also indica- te a malfunction of the electronicbraking distribution.
Engine operation war-ning lamp (autodiagno-sis)
If it flashes or lights up, this indi-cates a malfunctioning of either theinjection, ignition or emissioncontrol systems (depending oncountry). Quickly consult your nearest
approved dealer.
AIRBAG operation war-ning lamp
See ÒTHE AIRBAG SYSTEMÓ. Doors open warninglamp Lights up when swit- ching on ignition.
Goes out when all the doors are
closed correctly.

Direction indicators Left: move the stalk downwards. Right: move the stalk upwards.
To signal a change of direction, move the stalk past the point of resistance. The signal will cancel automatically as the steering wheel returns.
36I-16SIGNALLING
Horn Press the end of the stalk. Headlamp flash Flick the stalk gently towards you.
It is possible to flash the headlamps when the engine is switched off. Hazard warning This operates all the direction indicators at the same time.
Use it only in case of danger,for an emergency stop or in exceptional dri-
ving circumstances.
It can also operate when the ignition is off.The direction indicators will not operate if the vehicle is driven with the hazard warning lights on.