Page 47 of 114
Fuel supply cut-off switch This switch is located under the bonnet on the right hand side
To restore the fuel supply after a cut-off, press the top of the switch as shown in the diagram.
87V- 4FUEL CUT-OFF SYSTEM*
If your vehicle is fitted with a device which cuts off the fuel supply, this provides additional safety in the majority or frontal or rear impacts.* According to specification or country.
Before switching the ignition on again,
make sure that there is no fuel leakage or smell of fuel.
Page 87 of 114
1
3
2
4
Discharged battery.
94
VI-2BATTERY
Emergency starting from another battery
A vehicle with a discharged battery can be started with either an electrically isolated slave battery or the battery of another vehicle.
To avoid risks of explosion, correctly follow the orderindicated below.
Slave battery
Earth point on failed vehicle.
Check that the voltage of the slave battery is correct (12 volts).
If using the battery of another vehicle, its engine must be switched off. The two vehicles must not be in direct contact
with each other. Connect the battery cables as shown in the diagram in the orderindicated. Make sure that the cable clips are pro-
perly connected (risk of sparks).Start the engine of the assisting vehicle and let it run under slight acceleration for about a minute.
Start the engine of the vehicle with the discharged battery. Caution Do not touch the cable clips during the operation.Do not lean over the batteries.
Disconnect the cables in the reverse order to connection ensuring that they do not touch one another.
Page 88 of 114
1
A
2
B
Dashboard fuses
To access the fuses under the dashboard (to the left of the driver), turn the two knobs on the cover by one quarter of a turn. Fuse chart and table See following pages.
90VI-1FUSES
Two fuse boxes are located under the dashboard and one fuse box is located in the engine compartment.Engine compartment fuses
To access the fuse box located in the engine compartment (beside the bat- tery), unclip the cover as indicated in the diagram.
At the end of the operation, close the cover very carefully.
WARNING Operations on the MAXI second-level protection fuses, located at B,
must be carried out by an approved dealer.Fuse chart and table See following pages.Removing and inserting a fuse Before changing a fuse, it is necessary to know and
correct the cause of the incident. The fuse numbersare marked on the fuse box. Always replace a faulty fuse with a fuse of the same amperage. Use the special pliers Aprovided on the fuse box.
Correct Incorrect Pliers A
