2001 MAZDA MODEL PROTÉGÉ Owners Manual (in English)

Driving Your Mazda
f---]-
/" ** l
i t-
/*orto."frl
3. To advance the hours, press ihe hour
sel button ( H ) to advance the
mjnules, press the minute setbutton( M ) while the time is flashing.
4. Press the clock button again to start
NOTE
lf the power supply to the unit is
intrerrupred (if the fuse blows or fte
vehicle's battery is disconn€cted), the
clock will need 1() be reset.
l_--'---------a-::---| '{.J H I I '{H(a I
lnItl
\,, \,2
f-J.-=frn- T---.El!-frI
NOTE
If the time is not adjusted while the
clock's current time is flashing (if
neilber the H nor M is pressed). and
th€ clockbutton ispressed a second
time, the minut€s will be set to 00. If
fte clock s current time selting is
within the lauer pan of dle hour (from
30 to 59 min). tbe hour se$ing will
automatically advance one hour.
V Changing the display mode
The disptay on the unit can be changed
by pressing the clock bution. This
altemates the dhplay between tirne and
audio. When the clock mode has been
s€lechd, the time will be displayed.
fc.o"*-i
-+-
NOTE
Ifaudio operarion is selected while
tle time mode is on, the selected
audio mode will be displayed for ten
seconds, then the display will revert
5-61

Driving Your Mazda
Choos€ AM by pressing the AM button
and FM by pressing the FM1/2 button.
The selected mode will be indicated.
IfFM stereo is being received, "ST" will
be displayed.
V Tbning
The radio has the following tuning
rnethods: Manual, Seek. Scan, Preset
chann€I, and Auto memory luning.
The easiest way to tune stalions is to set
them on preset channels.
NOTtr
If the power supply is interrupted
(fuse blows or the battery is
disconnected), the presel channelsI Operating the Radio
To operate the radio. tum the ignition
switch to the ACC orON position.
V Radio ON
Press the AM or FM1/2 button io tum th€
NOTD
If the FM broadcast signal becomes
weak, reception automatically
changes from STEREO to MONO for
reduced noise, and the "ST" indicator
will go out.
5-62

Driving Your Mazda
-rulu_l/ru{Auo0coMl
!t\
#,x"*4l::iH.,
V
i'** lF
tl/ MAUTGM I
Manual tuning
Turning the manuat tuning knob will
change to a bigher or lower frequency
Seek tnning
Pressing the seek tuning button will
cause the tuner to se€k ahigher or lower
ff€quency automalically.
NOTE
If you continue to press and hold the
bunon, the frequency will continue
changing without stopping.
Scan tuning
Press the scan button to automatically
sample strong slations. Scanning stops at
each station for about 5 rconds. To hold
a staiion, mereiy press the scan butlon
again during this interr'al.
5-63

Driving Your Mazdt
To tune one jn fie memory, selectAM.
FMl, or FM2 and then press its chann€l
prese! button. The station frequency and
the channel number will be displayed.
NOTE
If the power supply is interrupted
(fuse blows or the battery is
disconnected). the preset channels
Preset cbannel tuning
The six preset channels can be used to
store 6 AM and 12 FM stations.
To set a channel first selecr AM, FMl. or
FM2. Tune to lhe station you want and
depress a channel preset button for about
2 seconds uniil abeep is heard. The
preset channel number and siation
frequenc! will be displayed.
The station is now held in lbe memory.
Repeat this operation for the other
slations and bands you wan110 slore.
5.64
Auto memor! tuning
This is especially useful when driving in
an area wbere the local stalions are not
known- Addiiionat AI4/FM slations can
be stored wirhout dislurbing the
previously set channels.
Press and hold the auto memory buiton
for about 2 seconds until a beep is heard;
the system will automatically scan and
temporarily store the six strongest
stations of each selected band in that
/ HscAN I
II
/,*t"u ft

Driving Your M^zda
f- vor-l
I sPowEF \
6)
Y
After scanning is completed. ihe
strongest station will be luned and its
frequency displayed.
Press and release the auto memory bulton
io recall stations from the auto siored
stations. One stored station will be
selected each time; its frequency and
channel number will be displayed.
I Operating the Cassette Tsp€
Player*
To operate the cassette tape player, tum
the ignition switch to the ACC or ON
V Cassette tape insert
Inserl the cassette tape into the slot, open
edge to lhe right and casseue tape will
begin play and "TAPE will be
displayed. At $e end of iie cassere rape.
the unit automatically reverses cassette
tape plat
When is lir. the cassette tap€t top side
is playing. Wlen V is lii, the bottom side
is on,
NOTE
If no stations can be tuned after
scanning operatjons, "A" wiii be
displayed.
V Radio OFF
Press the power/volume knob to tum off
the radio.
NOTE
Press lhe power/volum€ knob again to
listen to the frequency last tuned to.
NOTE
W}jen a metal rape is inserted, theplayer will automatically compensate
for it and "MTL" will be displayed.
"sonenoaets 5-65

Driving Your Mazda
t-;-l
?"'
til;l
-fi
V Playing
Press the casselc tape play button to
staltplaying when a cassette tape is in
the unit.Ifthere isn't a cassette tape in
$e unit wben lhe cassette tape play
button is pressed. "NO TAPE'will flash
on and off in sequence.
V Dolby noise reduction
When using a tape with Dolby NR+,push
the D0 button. The DO symbol will be
displayed. To play a tape without Dolby
NR, push the bulton once again.
* Noise reduction system manLrfactured
under license fiom Dolby Laboratories
Licensing Corporation.
Dolby and the double D syrnbol DO
are trademarks of Dolby Laboratories
Licens jng Corporation.
V Fast forward/Rewind
Press lhe fast forward button 1<)
fast-forward.
Press rhe rewind button to rewind.
To stop this operation and play ihe
cassetie tape, press the button again.
NOTE
Vften the cassette tap€ ends during
fa$ forward or rewind, it
autonatically stops and starts playing.
5-66

Driving Your Mazda
If APC det€cts 15 s€conds of blank space
it will automatically advance ihe tape to
NOIT
APC may not operate properly if. A tape was recorded at atow level.. A tape has long, silena intervals.. A tape is alive recording.. A tape has very short intervals of
less than 3 seconds.V Reversing
Press the program bulton to change
cassette rape-playing direction.
V APC (Automatic Program Control)
APC is used to find the beginning of
either the n€xt prograrn or the one beingplayed.
Press the APC button ( A ) to the
beginning of ihe next selection.
Press the APC button ( v ) to the
b€ginning ofthe one being played.
To stop ahis op€ration and play th€
cassetie lape, press the button again.
NOTE
When lhe cassette tape ends, the unit
auiomatically reverses play.
F,"B",Fl
-f
I:lftI SEEK \-
tE_,t
5-67

Driving Your Mazda
NOTtr
RPI may not operate properly if. A tape was recorded at a low
level.. A tape has 1ong, silent intervals.. A tape is a live recording.. A tape has very short intervals of
less than 3 seconds.
V Repeat play V Stopping
This operation makes itpossible to listen Press the power/volume knob to srop
to a selecfion repeatedly. cassette tape play.
Press lhe repeat bulton during play. The
cunent selection playing will be repealed
("RPT" will be displayed).
Press the rep€at butlon once agajn to
FI
-f
t"'"""'-l
a
5-68