LIGHTING
ADJUSTMENTS 86-2-1
LIGHTING ADJUST ME NTS
Headlamps - pair - align beam - up to
04MY
$% 86.40.17
Check
1.Align beam setting equipment to headlamp.
2.Switch on headlamps. Headlamp setting
lNon NAS models: 1.2% below horizontal
and parallel.
lNAS models: 0.4% below horizontal and
parallel.
Adjust
1.Adjust headlamp using a 6 mm Allen key.
2.Turn Allen screw for vertical alignment.
3. Non NAS models: Turn Allen screw for
horizontal alignment.
4.Align beam setting equipment to 2nd
headlamp.
5.Adjust 2nd headlamp as detailed above.
6.Switch off headlamps and remove beam setting
equipment.
Headlamps - pair - align beam - from
04MY
$% 86.40.17
Check
1.Align beam setting equipment to headlamp.
2.Switch on headlamps. Headlamp setting:
lNon NAS models: 1.2% below horizontal
and parallel.
lNAS models: 0.4% below horizontal and
parallel.
Adjust
1.Rotate inboard adjuster for vertical alignment.
2. Non NAS models: Rotate outboard adjuster
for horizontal alignment.
NOTE: The outboard adjuster is accessible via
a slot in rear face of headlamp.
3.Align beam setting equipment to 2nd
headlamp.
4.Adjust 2nd headlamp as detailed above.
5.Switch off headlamps and remove beam setting
equipment.
IN CAR ENTERTAINMENT
REPAIRS 86-6-1
IN CAR ENTERTA INMENT REPAIRS
Radio - up to 04MY
$% 86.50.03
Remove
1. Mid and high line only: Using tool SMD 4091
release radio from centre console.
2.Disconnect multiplugs and aerial from radio
and remove radio.3. Low line only: Using 2.5mm Allen key, loosen
bolts securing radio and release radio from
centre console.
Refit
1.Position radio to facia aperture and connect
multiplugs and aerial.
2.Fit radio to centre console.
3. Low line only: Tighten Allen bolts.
4.Enter security code and check radio cassette
player for correct operation.
M86 6006
SMD 4091
1
23
4
5
6FM
i
M
MODE
M86 6007
NAVIGATION SYSTEM
REPAIRS 87-1
NAVIGATION SYST EM REPAIRS
Interface unit - remote control
$% 86.53.15
Remove
1.Remove front console.
+ INTERIOR TRIM COMPONENTS,
REPAIRS, Console - front - up to 04MY.
2.Release interface ECU from bracket,
disconnect multiplug and remove ECU.
Refit
1.Secure interface ECU in bracket and connect
multiplug.
2.Fit front console.
+ INTERIOR TRIM COMPONENTS,
REPAIRS, Console - front - up to 04MY.
Display unit - navigation system
$% 86.53.20
Remove
1.Fit tool LRT-86-009 into slots, ensuring correct
handed tool is in correct slot.
The tools are stamped with 'TOP L' and 'TOP
R', ensure the stampings are facing upwards
when removing the unit.
2.Pull unit from fascia.
3.Disconnect 3 multiplugs and 2 coax cables,
remove unit.
4.Push retaining clips inwards and remove keys.
Refit
1.Position unit to fascia, connect multiplugs and
coax cables.
2.Slide unit in fascia until retaining clips engage.
3.Enter security code, check system is
operational.
M86 5745
M86 5741
