SMT881C
11. Remove rear oil seal.
IDo not reuse oil seal.
SMT882C
12. Apply ATF to the circumference of new rear oil seal, and tap it
using a drift as shown in the figure so that it is aligned with
case tip face.
IApply multi-purpose grease to oil seal lip.
SMT879C
13. Apply sealing fluid 518 (Locktite) to entire rear case mounting
surface of center case as shown in the figure.
CAUTION:
IRemove all foreign materials such as water, oil, and
grease from center case and rear case mating surfaces.
IBe careful not to allow sealing fluid to clog bleeder hole.
14. Install rear case to center case, and tighten bolts to specified
torque.
: 41 - 48 N´m (4.2 - 4.9 kg-m, 30 - 35 ft-lb)
IBe sure to attach harness clips.
SMT880C
15. Remove all the gasket fluid 1215 (Three Bond) from switch
mounting area and inside rear case, with ATP switch and neu-
tral-4LO switch threaded in 1 to 2 pitches, apply gasket fluid
1215 (Three Bond) to the thread of the switches and tighten it
to specified torque.
: 15 - 20 N´m (1.5 - 2.0 kg-m, 11 - 14 ft-lb)
16. Install rear case assembly to center case assembly.
GI
MA
EM
LC
EC
FE
AT
PD
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
ASSEMBLY
Final Assembly (Cont'd)
TF-155
