2001 BMW M3 COUPE Owner's Manual

17n

IndexDataTechnologyRepairsCar careControlsOverview

Cockpit

1 Side lamps/Low beams81
2

d

Turn signal indicator65

>

Parking lamp82

>

High beams82

>

Headlamp flasher65

>

Computer72
3 Washer/Wiper system65
4 Hazard warning flashers24
5 Shift lever64
6 Rear window defroster67
7 Central locking system31
8 Adjusting steering wheel52
9 Horn, entire surface
10 Fog lamps82

18n

Instrument cluster

19n

IndexDataTechnologyRepairsCar careControlsOverview

Instrument cluster

1 Fuel gauge with indicator lamp for
fuel reserve70
2 Turn signal indicator22
3 Speedometer
4 Indicator lamp for:

>

Battery charge current20

>

High beams22

>

Engine oil pressure/Engine oil
level20, 21
5 Tachometer and engine oil
temperature gauge69, 69
6 Engine coolant temperature gauge
with "Coolant temperature too high"
indicator70
7 Indicator and warning lamps
(clockwise) for:

>

Parking brake/Brake hydraulic
system/Cornering Brake Control
(CBC)20

>

Antilock Brake System
(ABS)21

>

Brake pads21

>

Tire Pressure Warning
(RDW)20, 22

>

Airbags21

>

Please fasten safety belts21

>

Cruise control22
8 Set button for the clock73
9 Indicator lamp for Dynamic Stability
Control (DSC)2210 Indicator for:

>

Odometer69

>

Trip odometer69

>

Clock73

>

Service Interval71
Indicator for computer, operation
using the turn signal lever, refer to
page 72:

>

Clock

>

Outside temperature

>

Average fuel consumption

>

Crusing range

>

Average speed
11 Indicator for Check Control72
12 Trip odometer, reset to zero6913 Indicator and warning lamps
(clockwise) for:

>

Fog lamps22

>

Add washer fluid22

>

Coolant level22

>

Electronic Throttle Control
(EML)22

>

Service engine soon22
You can have the outside temper-
ature and distance traveled shown
in other units of measurement.

<

20n

Indicator and warning lamps

Technology
that monitors itself

Many of the systems of your BMW
monitor themselves automatically, both
during engine starts and while you are
driving. Indicator and warning lamps
that are identified by "

l

" are tested for
proper functioning whenever the igni-
tion key is turned. They each light up
once for different periods of time.
If a fault should occur in one of these
systems, the corresponding lamp does
not go out after the engine is started or
it lights up while the vehicle is moving.
You will see how to react to this below.

Red: stop immediately

Battery charge current

l

The battery is no longer being
charged. There is a malfunction
of the alternator drive belt or in the
charging circuit of the alternator. Please
contact the nearest BMW center.
If the drive belt is defective, do not
continue driving. The engine could
be damaged due to overheating. If the
V-belt is defective, increased steering
effort is also required.

<


Engine oil pressure

l

Stop vehicle immediately and
switch off engine. Check the
engine oil level and top up as required.
If the oil level is correct: please contact
the nearest BMW center.
Do not continue driving, other-
wise, the engine could be
damaged because of inadequate lubri-
cation.

<



Tire Pressure Warning (RDW)
In addition, an acoustic signal is
sounded: a flat tire has
occurred. To come to an immediate
stop, reduce speed, while avoiding any
sudden, jerky braking or steering
maneuvers.
For additional information, refer to
page 78.
Brake hydraulic system

l

If the lamp comes on when the
parking brake is not engaged:
Check the brake fluid level. Before
driving further, be sure to read the addi-
tional information on pages 107
and 126.
Brake lamp for Canadian
models.

21n

IndexDataTechnologyRepairsCar careControlsOverview

Indicator and warning lamps

Red: an important reminder

Parking brake
Comes on when the parking
brake is applied Ð an additional
acoustic signal sounds when starting
off.
For additional information, refer to
page 63.



Parking brake lamp for Cana-
dian models.
Please fasten safety belts

l


A warning signal will sound at
the same time. Lights up for a
few seconds or until the safety belt is
fastened.
For additional information on safety
belts, refer to page 54.
Airbags

l


Please have the system
inspected by your authorized
BMW center.
For additional information,refer to
pages 56, 158.

Red and yellow: continue driving
cautiously
If the brake warning lamp
comes on together with the
yellow indicator lamps for ABS
and DSC:
The entire ABS, CBC and DSC
control system has failed.
Continue driving cautiously and
defensively. Avoid hard brake
applications. Please have the system
checked by your BMW center as soon
as possible.
For additional information, refer to
pages 76, 105.
ABS, CBC and DSC indicator
and warning lamps for Canadian
models.
Yellow: check as soon as possible
Antilock Brake System (ABS) l
ABS has been deactivated in
response to system malfunction.
Conventional braking efficiency is avail-
able and unrestricted. Please have the
system inspected by your BMW center.
For additional information, refer to
page 104.
ABS warning lamp for Canadian
models.
Engine oil level
Lights up while driving:
The oil level is at the absolute
minimum; therefore, add engine oil as
soon as possible. Do not drive more
than 30 miles (50 km) until you do.
For additional information, refer to
page 123.
Engine oil level
Comes on after the engine has
been shut off: add more engine
oil the next time you stop for gas.
For additional information, refer to
page 123.
Brake pads l
Have the brake pads checked.
For additional information, refer
to page 107.

22n
Indicator and warning lamps
Tire Pressure Warning (RDW) l
RDW has been switched off or
has been deactivated because
of a malfunction. In the event of a
malfunction, have the system checked
by your BMW center.
For additional information, refer to
pages 26, 78.
Dynamic Stability Control
(DSC) l
The indicator lamp flashes when
the system is active and governs drive
force and braking force.
If the indicator lamp fails to go out after
the engine is started, or if it comes on
during normal driving and stays on:
DSC has been switched off via the
button or because of a malfunction.
In the event of a malfunction, have the
system checked by the nearest BMW
center.
For additional information, refer to
page 76 and on.
Add washer fluid
The washer fluid is too low.
Top up the fluid at the earliest
opportunity.
For additional information, refer to
page 122.
Service Engine Soon l
If the indicator lamp comes on
either continuously or intermit-
tently, this indicates a fault in the emis-
sions-related electronic systems.
Although the vehicle remains opera-
tional, you should have the systems
checked by your BMW center at the
earliest possible opportunity.
For additional information, refer to
page 135.
Warning lamp: Service Engine
Soon for Canadian models.
Engine electronics l
There is a fault in the engine's
electronic control system. The
electronics allow for continued driving
with reduced engine output or speed.
Please have the system inspected by
your BMW center.
Add coolant
The coolant level is too low.
Add coolant at the earliest
opportunity.
For additional information, refer to
page 125.
Green: for your information
Turn signal indicator
Flashes when the turn signal is
on. Rapid flashing: indicates a
system malfunction.
For additional information, refer to
page 65.
Cruise control
Lights up when the cruise
control is activated. Available for
operation via the multifunction steering
wheel (MFL).
For additional information, refer to
page 67.
Fog lamps
Lights up whenever fog lamps
are on.
For additional information, refer to
page 82.
Blue: for your information
High beams
Lights up when the high beams
are on or the headlamp flasher
is actuated.
For additional information, refer to
pages 65, 82.

23n
IndexDataTechnologyRepairsCar careControlsOverview
Multifunction steering wheel (MFL)

The buttons integrated in the multifunc-
tion steering wheel (MFL) are provided
so that you can operate a number of
accessories quickly and without being
distracted from traffic conditions. You
may operate:
>Selected radio functions
>the cruise control
>selected cellular phone functions
*
>the voice recognition
*.
In order to operate a system via
the MFL, the corresponding
system controls must be switched on.<
1 Horn, entire surface
2 Radio/Cellular phone: select
3 Press briefly:
Cellular phone: receive a call, initiate
dialing, terminate a call
Press longer:
Turn the voice recognition on and off
4 Radio/Cellular phone: volume
5 Radio/Cellular phone: scan backward
or scan station keys or scroll through
the phone listings
6 Radio/Cellular phone: scan forward
or scan station keys or scroll through
the phone listings
7 Cruise control: activate stored
setting (resume)
8 Cruise control: accelerate and store
(+) as well as decelerate and store (Ð)
9 Cruise control: activate/interrupt/
deactivate

24n
Hazard warning flashers Warning triangle
*
First-aid kit
*
Switching on and off:
Press button.
The button flashes intermittently when
the hazard flashers are on.
To help you locate the button in an
emergency, the button is also illumi-
nated whenever the car lamps are on.
The turn signal function takes
precedence over the warning
lamp function. Starting with ignition key
position 1, you are therefore able to use
the turn signal, even if the hazard
warning system has been activated.<
The hazard warning triangle is stored
on the left-hand side in the luggage
compartment.
Comply with legal requirements
that cover the availability of a
hazard warning triangle in the vehicle.<
The first-aid kit is located under the
front passenger's seat.
To open: pull the handle and fold the
cover down.
To fasten: fold the cover up.
Some of the articles in the first-aid
kit may be used within a limited
time only. For this reason, check the
expiration dates of each of the items
regularly, and replace any whose expi-
ration dates have passed. You can
acquire replacements in any drugstore
or pharmacy.
Comply with legal requirements
regarding keeping a first-aid kit in the
vehicle.<