Page 43 of 215

43n
IndexDataTechnologyRepairsCar careControlsOverview
Alarm system
*
>The indicator lamp flashes for 
10 seconds when the system is 
disarmed: an attempted entry has 
been detected in the period since the 
system was armed.
Following triggering of an alarm, the 
indicator lamp will flash continuously.Avoiding unintentional alarms The tilt alarm sensor and interior motion 
sensor may be switched off at the same 
time. You can do this to prevent a false 
alarm from being triggered (in garages 
with elevator ramps, for instance, or 
when the vehicle is transported by 
trailer or train):
Lock the vehicle (= arm the system) 
twice. Press button 2 on the remote 
control twice in succession or lock the 
vehicle twice with the key. Refer to 
page 34.
The indicator lamp lights up briefly and 
then flashes continuously. The tilt alarm 
sensor and the interior motion sensor 
are deactivated as long as the system is 
armed.
Reset the alarm to reactivate the tilt 
alarm sensor and the interior motion 
sensor.
Interior motion sensor Transmitter and receiver for the interior 
motion sensor are located in the front 
area of the center console, invisible to 
the driver, and in the back area of the 
center console under a rack.
However, be sure to deactivate the 
interior motion sensor (see previous 
column) if children or animals are to 
remain in the vehicle.
For US owners onlyThe transmitter and receiver units 
comply with part 15 of the FCC (Federal 
Communication Commission) regula-
tions. Operation is governed by the 
following:
FCC ID: LTQSDR2G5
Compliance statement: 
This device complies with part 15 of the 
FCC Rules. Operation is subject to the 
following two conditions:
>This device may not cause harmful 
interference, and
>this device must accept any interfer-
ence received, including interference 
that may cause undesired operation.
Any unauthorized modifications to 
these devices could void the 
user's authority to operate the equip-
ment.< 
     
        
        Page 110 of 215

110n
BMW Universal Transmitter
*
Storage facilities 
Clearing the channel keys
Read and comply with the safety 
precautions on page 108.< 
The memory of individual channel keys 
cannot be deleted. However, the three 
channel keys can be cleared together 
as follows: 
>Press and hold both outside keys of 
the BMW Universal Transmitter until 
the indicator lamp flashes, and then 
release them. 
All of the channel keys are cleared. 
User informationDo not use this BMW Universal Trans-
mitter with any garage door opener that 
lacks safety "stop" and "reverse" 
features as required by federal safety 
standards (this includes any garage 
door opener model manufactured 
before April 1, 1982).
This device complies with Section 15 of 
the FCC Rules. Operation is subject to 
the following two conditions: as defined 
in the regulations, this device must not 
emit harmful interference, and must be 
shielded against interference from 
external sources to prevent unautho-
rized or inadvertent activation.To
 open the storage compartment in 
the front center armrest: press the 
button (arrow) and lift upward.
You will find additional storage 
compartments in the doors and in the 
center console above the ashtray. 
Storage nets are located on the back-
rests of the front seats.460us043 
     
        
        Page 111 of 215
111n
IndexDataTechnologyRepairsCar careControlsOverview
Storage facilities Cellular phone
* 
Ashtray, front
Beverage holder, coin box A coin box and two beverage holders 
are provided in the center console.460us251
Handsfree systemIn vehicles with telephone preparation
* 
or a communications package
*, the 
trim piece for the hands free micro-
phone is located in the headliner near 
the interior lamp. 
For further information on the cellular 
phone, refer to the separate Owner's 
Manual.
46cus035
To openPress briefly in the direction indicated 
by the arrow. 
To extinguish a cigarette, tap off the 
ash and gently press the tip into the 
funnel.46cus048