Page 57 of 86

6-25
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
EC000096
cC
Too little chain slack will overload
the engine and other vital parts.
Keep the slack within the specified
limits.
4. Tighten the wheel axle nut to
the specified torque.
5. Adjust the brake pedal free
play.
EW000103
w
Check the operation of the brake
light after adjusting the rear brake.
EAU01106*Drive chain lubrication
The chain consists of many parts
which work with each other. If the
chain is not maintained properly, it
will wear out quickly. Therefore,
the chain must be serviced regular-
ly. This service is especially neces-
sary when riding in dusty areas.
The drive chain should be lubri-
cated every 500 km. First, remove
all dirt and mud from the chain
with a brush or cloth. Then, spray
any of the many brands of spray-
type chain lubricant between
both rows of side plates and on
all center rollers.
To clean the chain thoroughly,
remove it from the motorcycle,
dip it in solvent, and clean out as
much dirt as possible. Then, take
the chain out of the solvent to
dry it, and immediately lubricate
it to prevent it from rusting.
EC000097
cC
Be sure to oil the chain after wash-
ing the motorcycle or riding in the
rain.
Tightening torque:
Wheel axle nut:
90 Nm (9.0 m·kg)
5EK-9-E1 (TW125)<3.1> 4/6/0 11:50 PM Page 55
Page 58 of 86
6-26
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
EAU02962Cable inspection and
lubrication
EW000112
w
Damage to the outer housing of
cables may lead to internal rusting
and interfere with the cable move-
ment. Replace damaged cables as
soon as possible to prevent unsafe
conditions.
Lubricate the cables and cable
ends. If a cable does not operate
smoothly, ask a Yamaha dealer to
replace it.EAU00773Throttle cable and grip
lubrication
The throttle twist grip assembly
should be greased at the time that
the cable is lubricated, since the
grip must be removed to get at the
end of the throttle cable. After
removing the screws, hold the end
of the cable up in the air and put in
several drops of lubricant. With the
throttle grip disassembled, coat the
metal surface of the grip assembly
with a suitable all-purpose grease. Recommended lubricant:
Engine oil
5EK-9-E1 (TW125)<3.1> 4/6/0 11:50 PM Page 56
Page 59 of 86
6-27
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
EAU02984Brake and shift pedal
lubrication
Lubricate the pivoting parts.
EAU02985Brake and clutch lever
lubrication
Lubricate the pivoting parts.
EAU02986Sidestand lubrication
Lubricate the sidestand pivoting
point and metal-to-metal contact
surfaces. Check that the sidestand
moves up and down smoothly.
EW000113
w
If the sidestand does not move
smoothly, consult a Yamaha deal-
er.
Recommended lubricant:
Engine oilRecommended lubricant:
Engine oil
Recommended lubricant:
Engine oil
5EK-9-E1 (TW125)<3.1> 4/6/0 11:50 PM Page 57
Page 60 of 86
6-28
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
EAU00791Rear suspension lubrication
Lubricate the pivoting parts.
1. Grease nipple (´2)
EAU02939Front fork inspection
Visual checkEW000115
w
Securely support the motorcycle
so there is no danger of it falling
over.
Check for scratches or damage on
the inner tube and excessive oil
leakage from the front fork.Operation check
1. Place the motorcycle on a level
place.
2. Hold the motorcycle in an
upright position and apply the
front brake.
3. Push down hard on the han-
dlebars several times and
check if the fork rebounds
smoothly.
EC000098
cC
If any damage or unsmooth move-
ment is found with the front fork,
consult a Yamaha dealer.
1
Recommended lubricant:
Lithium soap base grease
5EK-9-E1 (TW125)<3.1> 4/6/0 11:50 PM Page 58
Page 61 of 86
6-29
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
EAU00794Steering inspection
Periodically inspect the condition
of the steering. Worn out or loose
steering bearings may be danger-
ous. Place a stand under the
engine to raise the front wheel off
the ground. Hold the lower end of
the front forks and try to move
them forward and backward. If any
free play can be felt, ask a Yamaha
dealer to inspect and adjust the
steering. Inspection is easier if the
front wheel is removed.
EW000115
w
Securely support the motorcycle
so there is no danger of it falling
over.
EAU01144Wheel bearings
If there is play in the front or rear
wheel hub or if the wheel does not
turn smoothly, have a Yamaha
dealer inspect the wheel bearings.
5EK-9-E1 (TW125)<3.1> 4/6/0 11:50 PM Page 59
Page 62 of 86

6-30
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
1
EAU01071Battery
Check the level of the battery elec-
trolyte and make sure that the ter-
minals are tight.
Fill with distilled water if the elec-
trolyte level is low.
EC000099
cC
When inspecting the battery, be
sure the breather hose is routed
correctly. If the breather hose is
positioned in such a way as to
cause battery electrolyte or gas to
exit onto the frame, structural and
cosmetic damage to the motorcy-
cle can occur.
1. Battery
EW000116
w
Battery electrolyte is poisonous
and dangerous, causing severe
burns, etc. It contains sulfuric acid.
Avoid contact with skin, eyes or
clothing.
ANTIDOTE:
8EXTERNAL: Flush with water.
8INTERNAL: Drink large quanti-
ties of water or milk. Follow
with milk of magnesia, beaten
egg, or vegetable oil. Call a
physician immediately.
8EYES: Flush with water for 15
minutes and get prompt med-
ical attention.
Batteries produce explosive gases.
Keep sparks, flame, cigarettes etc.,
away. Ventilate when charging or
using in an enclosed space.
Always shield your eyes when
working near batteries.
KEEP OUT OF REACH OF CHIL-
DREN.
1
2
Replenishing the battery fluid
A poorly maintained battery will
corrode and discharge quickly. The
battery fluid should be checked at
least once a month. The level
should be between the minimum
level and maximum level marks.
Use only distilled water if refilling
is necessary.
EC000100
cC
Normal tap water contains miner-
als which are harmful to a battery;
therefore, refill only with distilled
water.
1. Maximum level mark
2. Minimum level mark
5EK-9-E1 (TW125)<3.1> 4/6/0 11:50 PM Page 60
Page 63 of 86

6-31
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
EW000117
w
Take care not to spill battery fluid
on the chain. Battery fluid may
weaken the chain causing shorter
chain life and possibly result in an
accident.
Battery storage
8When the motorcycle will not
be used for a month or longer,
remove the battery, fully
charge it and store it in a cool,
dry place. Completely recharge
the battery before reinstalla-
tion.
1. Battery breather hose
8If the battery will be stored for
longer than two months, check
the specific gravity of the fluid
at least once a month and fully
recharge the battery when it is
too low.
8Always make sure the connec-
tions are correct when putting
the battery back in the motor-
cycle. Make sure the breather
hose is properly connected
and is not damaged or
obstructed.
1. Battery
2. Battery breather hose
EAU01307Fuse replacement
The fuse is located behind panel B.
(See page 6-7 for panel removal
and installation procedures.)
If the fuse is blown, turn off the
main switch and the switch of the
circuit in question. Install a new
fuse of proper amperage. Turn on
the switches and see if the electri-
cal device operates. If the fuse
immediately blows again, consult a
Yamaha dealer.
1. Spare fuse
2. Main fuse
1
21
21
5EK-9-E1 (TW125)<3.1> 4/6/0 11:50 PM Page 61
Page 64 of 86
6-32
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
EC000103
cC
Do not use fuses of higher amper-
age rating than those recommend-
ed. Substitution of a fuse of
improper rating can cause exten-
sive electrical system damage and
possibly a fire.
EAU01158Headlight bulb replacement
If the headlight bulb burns out,
replace the bulb as follows:
1. Remove cowling C. (See page
6-8 for removal and installa-
tion procedures.)
2. Remove the headlight unit by
removing the bolts.
1. Bolt (´2)
3. Remove the headlight connec-
tor and the bulb holder cover.
1. Connector
2. Bulb holder cover
1
1
2
Specified fuse: 20A
5EK-9-E1 (TW125)<3.1> 4/6/0 11:50 PM Page 62