2000 SUZUKI SWIFT door lock

9-44 BODY SERVICE
REAR DOOR LOCK ASSEMBLY (IF EQUIPPED)
REMOVAL
1) Remove door trim and door sealing cover, refer to steps 1) to
7) of “REMOVAL” under “REAR DOOR GLASS (IF
EQUIPPED)” in this section.
2) Disconnect door opening control rod (1) and door latch con-
trol rod (2).
3) Loosen door latch mounting screw (3), door latch actuator
screw (5) (if equipped power door lock) and remove door
lock assembly (4).
INSTALLATION
Reverse removal procedure to install rear door lock assembly
referring to “FRONT DOOR LOCK ASSEMBLY” in this section.
1. Outside handle 4. Latch striker 7. Shim
2. Inside handle bezel 5. Door latch screw 8. Door latch actuator screw
3. Rear door latch assembly
: Apply lithium grease 99000-25010 to sliding part6. Door latch striker screw 9. Door lock control rod
4
7
6 5
5 3
3
8 1
9
2
2
1
3
4 5

BODY SERVICE 9-45
BACK DOOR LOCK ASSEMBLY
REMOVAL
1) Remove door trim (1).
2) Disconnect door lock control rod (1).
Disconnect control rod (2).
3) Disconnect door lock motor lead wire (if equipped).
4) Loosen door latch screw (3) and remove door latch assembly
(4).
1. Back door latch assembly 3. Latch striker 5. Latch striker screw
2. Back door lock cylinder 4. Door latch screw Tightening torque
“A”
“A”“A”
1
2
1
4
3

9-46 BODY SERVICE
5) Remove back door licence garnish (1).
6) Remove back door lock cylinder (2).
INSTALLATION
Reverse removal procedure to install back door lock assembly
noting the following instruction.
Adjust door latch striker so that its center aligns with the cen-
ter of groove in door latch base.
INSPECTION
Check that door open and closes smoothly and properly.
Also check that door latch half lock operates properly (Check that
door latch half lock keeps door from opening all the way) and door
latch full locks securely closed.
Adjust door latch striker position if necessary.
KEY CODING
KEY USAGE AND IDENTIFICATION
Key is used for ignition and door lock cylinder. Keys are cut on
both edges to make them reversible.
Key identification is obtained from five character key code
stamped on key code tag. Using this key code, key code cutting
combination can be determined from a code list (available to own-
ers of key cutting equipment from suppliers).
If key codes are not available from records or tags, key code can
be obtained from the right hand door lock cylinder (if lock has not
been replaced). Lock cylinders supplied by the factory as service
parts are unmarked.
If original key is available, key code cutting combination can be
determined by laying key.
2
1