13. Install oil pan.
a. Attach a magnet to oil pan.
b. Install new oil pan gasket on transmission case.
c. Install oil pan and bracket on transmission case.
+Always replace oil pan bolts as they are self-sealing
bolts.
+Before installing bolts, remove traces of sealant and oil
from mating surface and thread holes.
+Tighten four bolts in a criss-cross pattern to prevent
dislocation of gasket.
d. Tighten drain plug.
14. Install PNP switch.
a. Check that manual shaft is in ª1º position.
b. Temporarily install PNP switch on manual shaft.
c. Move manual shaft to ªNº.
d. Tighten bolts while inserting 4.0 mm (0.157 in) dia. pin ver-
tically into locating holes in PNP switch and manual shaft.
15. Install torque converter.
a. Pour ATF into torque converter.
+Approximately 2 liters (1-3/4 Imp qt) of fluid are required
for a new torque converter.
+When reusing old torque converter, add the same
amount of fluid as was drained.
SAT011B
SAT601B
SAT299I
SAT014B
SAT428DA
ASSEMBLY
Assembly (2) (Cont'd)
AT-1203
