2000 Citroen C5 height adjustment

Downloaded from www.Manualslib.com manuals search engine ENGINE
55
CYLINDER HEAD
Engines : RHZ - RHY
Cylinder head gasket identification
Number
of notches at A Thickness
(mm) Engine
platePiston
stand-proud
(mm)
0.47 to 0.605 1.30 ± 0.06 1
0.605 to 0.655 1.35 ± 0.06 2
0.655 to 0.705 1.40 ± 0.06 3
0.705 to 0.755 1.45 ± 0.06 4
0.755 to 0.83 1.50 ± 0.06 5
RHZ
RHY
B1DP15AD
Cylinder head.
- New cylinder head height = 133 mm.
- Maximum permitted deformation = 0.03 mm.
Cylinder head gasket.
Multilayer cylinder head gasket.
Select seal thickness as a function of the piston stand-proud.
Hydraulic followers.
The hydraulic followers have automatic clearance adjustment.

Downloaded from www.Manualslib.com manuals search engine ENGINE
57
CYLINDER HEAD
Engine : 4HX
Cylinder head gasket identification
Number
of notches
At B At A Thickness
(mm) Engine
platePiston
stand-proud (mm)
0.55 to 0.60 1.25 ± 0.04 1
0.61 to 0.65 1.30 ± 0.04
12
0.66 to 0.70 1.35 ± 0.04 3
0.71 to 0.75 1.40 ± 0.04 4
4HX
Cylinder head.
- New cylinder head height = 133 mm.
- Maximum permitted deformation = 0,03 mm.
Cylinder head gasket.
Multilayer cylinder head gasket.
Select seal thickness as a function of the piston stand-proud.
Hydraulic followers.
The hydraulic followers have automatic clearance adjustment.
B1DP18XD

Downloaded from www.Manualslib.com manuals search engine 212
AXLES
SUSPENSION
STEERING
L1
The dimension«L1» for checking front height is between the level of
the front subframe «b» and the wheel axis «a».
This method eliminates all the variations in measurement due to :
Different wheel fiittings.
Vehicle loading.
Wear or incorrect inflation of tyres.
(Measuring from the wheel axis : tool 8006-T)
AXLE GEOMETRY
General adjustment conditions
Rear height Front height
NOTE : After each movement of the vehicle body, and before each mea-
surement :
- Move the vehicle slightly forwards and backwards, by turning the road
wheel by hand.- Check the tyre pressures.
- Release the handbrake.
- Place the manual height control in the «NORMAL» position.
- Engine running.
L2
The dimension«L2»for checking rear height is between the measuring
zone «b» and the wheel axis «a».
H1 = R1 - L1
H1 = Front height(± 6 mm).
R1 =Wheel radius(mm).
L1 = Theoretical dimension between the level of the front subframe and
the wheel axis.H2 = R2 + L2
H2 = Rear height (± 6 mm).
R2 = Wheel radius(mm).
L2 = Theoretical dimension between the measuring zone on the cross-
member support and the wheel axis.