1999 TOYOTA AVENSIS oil level

SS0IF–02
– SERVICE SPECIFICATIONSSTEERING
SS–13
STEERING
SERVICE DATA
DRIVE BELT
4A–FE and 7A–FE engines:
Drive belt deflection New belt5 – 6 mm (0.20 – 0.24 in.)
Drive belt deflection Used belt6 – 8 mm (0.24 – 0.31 in.)
*Drive belt tension New belt441 – 539 N (45 –55 kgf)
*Drive belt tension Used belt245 – 392 N (25 – 40 kgf)
3S–FE engine:
Drive belt deflection New belt8 – 10 mm (0.31 – 0.39 in.)
Drive belt deflection Used belt10 – 13 mm (0.39 – 0.51 in.)
* Drive belt tension New belt441 – 539 N (45 – 55 kgf)
* Drive belt tension Used belt245 – 392 N (25 – 40 kgf)
2C–T, 2C–TE and 1CD–FTV engines:
Drive belt deflection New belt11 – 14 mm (0.43 – 0.55 in.)
Drive belt deflection Used belt15 – 18 mm (0.59 – 0.71 in.)
* Drive belt tension New belt539 – 637 N (55 – 65 kgf)
* Drive belt tension Used belt245 – 392 N (25 – 40 kgf)
POWER STEERING FLUID
Oil level rise Maximum5 mm (0.20 in.)
4A–FE and 7A–FE engines:
Oil pressure at idle speed with valve closed Minimum8,238 kPa (84 kgf/cm2, 1,195 psi)
3S–FE engine:
Oil pressure at idle speed with valve closed Minimum9,022 kPa (92 kgf/cm2, 1,309 psi)
2C–T, 2C–TE and 1CD–FTV engines:
Oil pressure at idle speed with valve closed Minimum8,826 kPa (90 kgf/cm2, 1,280 psi)
PS VANE PUMP (2C–T, 2C–TE and 1CD–FTV engines)
Pump rotating torque Maximum0.3 N·m (2.8 kgf·cm, 2.4 in.·lbf)
Pump shaft and front housing bushing oil clearance STD
Maximum0.01 – 0.03 mm (0.0004 – 0.0012 in.)
0.07 mm (0.0028 in.)
Vane plate height Minimum8.1 mm (0.319 in.)
Vane plate thickness Minimum1.797 mm (0.0708 in.)
Vane plate length Minimum14.988 mm (0.5901 in.)
Vane plate and pump rotor groove clearance Maximum0.03 mm (0.0012 in.)
Vane plate length Pump rotor and cam ring mark
None14.996 – 14.998 mm (0.59039 – 0.59047 in.)
114.994 – 14.996 mm (0.59032 – 0.59039 in.)
214.992 – 14.994 mm (0.59024 – 0.59032 in.)
314.990 – 14.992 mm (0.59016 – 0.59024 in.)
414.988 – 14.990 mm (0.59008 – 0.59016 in.)
Flow control valve spring length Minimum36.0 mm (1.417 in.)
*: For use with belt tension gauge

MX01Z–04
– MANUAL TRANSAXLE (E251)TROUBLESHOOTING
MX–1
TROUBLESHOOTING
PROBLEM SYMPTOMS TABLE
Use the table below to help you find the cause of the problem. The numbers indicate the priority of the likely
cause of the problem. Check each part in order. If necessary, replace these parts.
SymptomSuspect AreaSee page
Noise
1. Oil (Level low)
2. Oil (Wrong)
3. Gear (Worn or damaged)
4. Bearing (Worn or damaged)MX–4
MX–4
MX–9
MX–9
Oil leakage
1. Oil (Level too high)
2. Gasket (Damaged)
3. Oil seal (Worn or damaged)
4. O–Ring (Worn or damaged)MX–4
MX–9
MX–9
MX–9
Hard to shift or will not shift
1. Control cable (Faulty)
2. Synchronizer ring (Worn or damaged)
3. Shift key spring (Damaged)MX–48
MX–9
MX–23
MX–30
MX–9
MX–23
MX–30
Jumps out of gear
1. Locking ball spring (Damaged)
2. Shift fork (Worn)
3. Gear (Worn or damaged)
4. Bearing (Worn or damaged)MX–9
MX–9
MX–9
MX–9

D06632AB
D06638
Q10165
Filler Plug
Oil Level
0 – 5 mm
Drain Plug
D06631
MX–6
– MANUAL TRANSAXLE (E251)MANUAL TRANSAXLE UNIT
13. REMOVE ENGINE LEFT MOUNTING BRACKET 3 SET
BOLTS AND NUT
Torque:
Bolt A: 52 N·m (530 kgf·cm, 38 ft·lbf)
Nut B: 87 N·m (890 kgf·cm, 64 ft·lbf)
14. REMOVE ENGINE LEFT MOUNTING BRACKET
Lower the transaxle side and remove the bolt and bracket.
Torque: 52 N·m (530 kgf·cm, 38 ft·lbf)
15. REMOVE FRONT WHEEL
Torque: 216 N·m (2,200 kgf·cm, 159 ft·lbf)
16. RAISE VEHICLE
NOTICE:
Make sure that the vehicle is securely supported.
17. DRAIN TRANSAXLE OIL
Oil grade: API GL–4 or GL–5
Viscosity: SAE 75W–90
Capacity: 3.9 liters (4.1 US qts, 3.4 Imp. qts)
Torque: 49 N·m (500 kgf·cm, 36 ft·lbf)
18. REMOVE FRONT EXHAUST PIPE
(a) Remove the 2 bolts, 2 nuts and gasket from the exhaust
manifold.
Torque: 62 N·m (630 kgf·cm, 46 ft·lbf)
(b) Remove the 2 bolts, 2 springs, gasket and pipe.
Torque: 48 N·m (490 kgf·cm, 35 ft·lbf)
19. REMOVE LH AND RH FRONT DRIVE SHAFTS
(See page SA–1)
20. REMOVE ENGINE MOUNTING CENTER MEMBER
(a) Remove the 2 bolts and front transport hook.
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
(b) Support the suspension crossmember with a jack.
(c) Remove the nuts, and disconnect the suction pipe.

F03737
4A–FE and 7A–FE Engines
2C–T, 2C–TE, 3S–FE and 1CD–FTV
EnginesSR0I8–02
R07281
Normal
Abnormal
R10552Engine IdlingEngine Stopped 5 mm (0.20 in.) or less
– STEERINGPOWER STEERING FLUID
SR–3
POWER STEERING FLUID
INSPECTION
1. CHECK FLUID LEVEL
(a) Keep the vehicle level.
(b) With the engine stopped, check the fluid level in the oil
reservoir.
If necessary, add fluid.
Fluid: ATF DEXRON II or III
HINT:
Check that the fluid level is within the HOT LEVEL range on the
reservoir / reservoir cap dipstick.
If the fluid is cold, check that it is within the COLD LEVEL range.
(c) Start the engine and run it at idle.
(d) Turn the steering wheel from lock to lock several times to
boost fluid temperature.
Fluid temperature: 80
C (176
F)
(e) Check for foaming or emulsification.
If there is foaming or emulsification, bleed power steering sys-
tem (See Pub. No. RM599E on page SR–5).
(f) With the engine idling, measure the fluid level in the oil
reservoir.
(g) Stop the engine.
(h) Wait a few minutes and remeasure the fluid level in the oil
reservoir.
Maximum fluid level rise: 5 mm (0.20 in.)
If a problem is found, bleed power steering system (See Pub.
No. RM599E on page SR–5).
(i) Check the fluid level.

I04818
SPEEDOMETER
TACHOMETER
WATER TEMP.
FUEL
OIL LEVEL
ODO / TRIP
METER
OUTSIDE TEMP.
CLOCK
RHEOSTATLCD
DISPLAY
LCD
DISPLAY S
T
W
FA18
B7
B20 A5
A15
A3
A6
A7
A8
A12
A11
A19
A10
A9
B11
B24
B5
A22
B4
A23
B14
A23
A25
B16
B14
B21
A22
A14VOLTAGE
STABILIZER
B17
B22
B9
B26
A24 Brake Warning
Fuel filter Warning
Discharge Waring
Economy Indicator
Turbo / Glow Plug Indicator
Glow Plug Indicator
ABS Warning
Low Oil Pressure Warning
Check Engine Warning
O / D OFF Indicator
ECT SNOW Indicator
ECT PWR Indicator
Rear Fog Light Indicator
High Beam Indicator
Right Turn Indicator
Left Turn Indicator
Open Door Warning
SRS Warning
Front Fog light Indicator A1
B15
B18A26
B2
A17
B1
B13
B6
B3 B19
BE–4
– BODY ELECTRICALCOMBINATION METER

No.
AGround (Power)
Tacho Pick–UP Sensor
EFI ECU (3S–FE, 2C–TE Engine)
EGR (2C–T Engine)
Vehicle Speed Sensor
EFI ECU
Water Temperature Sender Gauge (2C–T Engine)
Ground (Engine)
Ground
Outside Temperature Sender Gauge
Ground (Fuel)
Fuel Sender Gauge
Ground (Power)
Ground (Speed)
Turn Signal Switch (Right)
Other Parts
Oil Level Warning Switch
O/D OFF Switch
ECT ECU (Gasoline Engine)
Fuel Filter Warning Switch (Diesel Engine)
Glow Plug Timer (Diesel Engine)
EFI ECU (Gasoline Engine)
ECT Pattern Select Switch
ABS ECU
Rear Fog Light Switch 1
3
5
6
7
8
9
10
11
12
14
15
17
18
19
21
22
23
24
25
26Wire Harness Side
1
2
3
4
5
6
7
9
11
13
14
15
16
17
18
19
20
22
24
26Turn Signal Switch (Left)
H–LP Fuse
Front Fog Light Switch
Alternator L Terminal
Brake Fluid Level Warning Switch
Parking Brake Switch
ECU+B Fuse
Taillight Relay
GAUGE Fuse
Ground (Signal)
DOOR Fuse
EFI ECU (Gasoline Engine)
EGR ECU (Diesel Engine)
Headlight Dimmer Switch
Low Oil Pressure Warning Switch
IGN Fuse
Door Courtesy Switch
Airbag ECU
Taillight Relay
GAUGE Fuse
Ground (Signal)
DOOR Fuse
B
– BODY ELECTRICALCOMBINATION METER
BE–5