1999 TOYOTA AVENSIS key

SR0WB–01
F08960
 Gasket Union Bolt
Pressure Feed Tube
PS Vane Pump
Assembly Woodruff Key
Vane Pump Pulley
Drive Belt
Idler PulleyReturn Hose
N·m (kgf·cm, ft·lbf): Specified torque
 Non–reusable part
Pulley Cover
43 (440, 32)
39 (400, 29)
39 (400, 29)
38 (390, 28)
52 (525, 38)
SR–6– STEERINGPOWER STEERING VANE PUMP (2C–T, 2C–TE,
1CD–FTV)
POWER STEERING VANE PUMP (2C–T, 2C–TE, 1CD–FTV)
COMPONENTS

SR0WC–01
F03730
F04155
SST
SR–8– STEERINGPOWER STEERING VANE PUMP (2C–T, 2C–TE,
1CD–FTV)
REMOVAL
1. REMOVE DRIVE BELT
(a) Loosen the idler pulley set nut.
(b) Loosen the belt tension adjusting bolt, and remove the
drive belt.
2. REMOVE VANE PUMP PULLEY
(a) Using SST to stop the pulley rotating, remove the pulley
set nut.
SST 09960–10010 (09962–01000, 09963–01000)
(b) Remove the pulley and woodruff key from the vane pump
shaft.
3. DISCONNECT RETURN HOSE
Remove the clip and disconnect return the hose.
4. DISCONNECT PRESSURE FEED TUBE
Remove the union bolt and gasket, and disconnect the pres-
sure feed tube.
5. REMOVE PS VANE PUMP ASSEMBLY
Remove the 3 bolts and PS vane pump assembly.
6. REMOVE PULLEY COVER
Remove the bolt and pulley cover.

SR0WG–01
F04155
SST
F08958
SR–16– STEERINGPOWER STEERING VANE PUMP (2C–T, 2C–TE,
1CD–FTV)
INSTALLATION
1. INSTALL PULLEY COVER
Install the pulley cover to the PS vane pump with the bolt.
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
2. INSTALL PS VANE PUMP ASSEMBLY
Install the PS vane pump to the pulley bracket and engine with
the 3 bolts.
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
3. CONNECT PRESSURE FEED TUBE
Place a new gasket to the pressure feed tube and connect them
with the union bolt.
Torque: 52 N·m (525 kgf·cm, 38 ft·lbf)
4. CONNECT RETURN HOSE
Connect the return hose with the clip.
5. INSTALL VANE PUMP PULLEY
(a) Install the woodruff key to the vane pump shaft.
(b) Install the vane pump pulley.
(c) Using SST to stop the pulley rotating, torque the nut.
SST 09960–10010 (09962–01000, 09963–01000)
Torque: 43 N·m (440 kgf·cm, 32 ft·lbf)
6. INSTALL DRIVE BELT
(a) Install the drive belt to the pulley.
(b) Adjust drive belt tension with the belt tension adjusting
bolt (See page SR–1).
(c) Torque the idler pulley set nut.
Torque: 38 N·m (390 kgf·cm, 28 ft·lbf)
7. BLEED POWER STEERING SYSTEM
(See Pub. No. RM599E on page SR–5)