1999 NISSAN PICK-UP belt

DEPLOYMENT OF AIR BAG MODULE WHILE
MOUNTED IN VEHICLE
When disposing of a vehicle, deploy air bag modules while they
are mounted in vehicle.
CAUTION:
When deploying air bag module, ensure vehicle is empty.
1. Disconnect both the vehicle battery cables and wait 3 min-
utes.
2. Disconnect air bag modules connector.
3. Connect deployment tool [SST: KV99106400] to air bag
module.
For front passenger air bag module, attach deployment tool
adapter [SST: KV99108300] to the tool connector.
4. Connect red clip of deployment tool to battery positive termi-
nal and black clip to negative terminal.
5. The lamp on the right side of the tool, marked ``deployment
tool power'', should glow green, not red.
6. Press the button on the deployment tool. The left side lamp
on the tool, marked ``air bag connector voltage'', will illumi-
nate and the air bag module will deploy.
CAUTION:
Activate only one air bag module or seat belt pre-tensioner
at a time.
DISPOSING OF AIR BAG MODULE
Deployed air bag modules are very hot. Before disposing of air
bag module, wait at least 30 minutes. Seal them in a plastic bag
before disposal.
CAUTION:
lNever apply water to a deployed air bag module.
lBe sure to wear gloves when handling a deployed air
bag module.
lNo poisonous gas is produced upon air bag module
deployment. However, be careful not to inhale gas since
it irritates throat and can cause choking.
lDo not attempt to disassemble air bag module.
lAir bag module can not be re-used.
lWash your hands clean after finishing work.
SRS006
SBF276H
SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
Disposal of Air Bag Module (Cont'd)
RS-2014

5. Touch ``AIRBAG''.
6. Touch ``SELF-DIAG [CURRENT]''.
7. If no malfunction is detected on ``SELF-DIAG [CURRENT]'',
repair of SRS is completed. Go to step 8.
(When the malfunction was only in seat belt pre-tensioner
system, go to step 11.)
If any malfunction is detected on ``SELF-DIAG [CURRENT]'',
the malfunctioning part is not repaired completely or another
malfunctioning part is detected. Go to DIAGNOSTIC PRO-
CEDURE 2, page RS-2026, and repair malfunctioning part
completely.
8. Touch ``ERASE''.
NOTE:
Touch ``ERASE'' to clear the memory of the malfunction
(``SELF-DIAG [PAST]'').
If the memory of the malfunction is ``SELF-DIAG [PAST]'' is
not erased, the User mode shows the system malfunction by
the operation of the warning lamp even if the malfunction is
repaired completely.
9. Touch ``BACK'' key of CONSULT to select ``SELF-DIAG
[PAST]'' in the ``SELECT DIAG MODE'' screen. Touch
``SELF-DIAG [PAST]''.
SRS074
SRS047
SRS049
SRS357
SRS050
TROUBLE DIAGNOSES Ð Supplemental Restraint System (SRS)
Self-diagnosis (Cont'd)
RS-2031