1999 LAND ROVER DEFENDER oil capacities

09LUBRICANTS, FLUIDS AND CAPACITIES
2
INFORMATION Propeller shaft Front
and RearNLGI - 2 Multi-purpose Lithium based GREASE
Lubrication nipples
(hubs, ball joints
etc.)
Seat slides
Door lock striker
Brake and clutch
reservoirsBrake fluids having a minimum boiling point of 260°C (500°F) and complying with
FMVSS 116 DOT4
Engine coolant Use Texaco XLC long life coolant. Use one part anti-freeze to one part water for
protection down to -36°C (-33°F).
IMPORTANT: Coolant solution must not fall below 50% anti-freeze otherwise
damage to engine is liable to occur. Maximun concentration is 60%.
Battery lugs, Petroleum jelly.
Earthing surfacesNOTE: Do not use Silicone Grease
where paint has
been removed
Air Conditioning
System Refrigerant Use only refrigerant R134a
Compressor Oil ND-OIL 8
LUBRICATION PRACTICE
Use a high quality oil of the correct viscosity range and service classification in the engine during maintenance and
when topping up. The use of oil not to the correct specification can lead to high oil and fuel consumption and
ultimately to damaged components.
Oil to the correct specification contains additives which disperse the corrosive acids formed by combustion and
prevent the formation of sludge which can block the oilways. Additional oil additives should not be used. Always
adhere to the recommended servicing intervals.
WARNING: Many liquids and other substances used in motor vehicles are poisonous. They must
not be consumed and must be kept away from open wounds. These substances, among others,
include anti-freeze, windscreen washer additives, lubricants and various adhesives.
ProCarManuals.com

LUBRICANTS, FLUIDS AND CAPACITIES
3
INFORMATION CAPACITIES
The following capacity figures are approximate and are provided as a guide only.
Capacities (approx.)* Litres Pints
Engine sump oil - Td5 7.20...................................................... 12.67
Extra when refilling after fitting new filter 1.00.......................... 1.76
Manual gearbox 2.38............................................................... 4.19
Transfer gearbox oil 2.30......................................................... 4.00
Front differential 1.70............................................................... 3.00
Rear differential
90 Models 1.70............................................................... 3.00
110 Models 2.26............................................................. 4.00
Power steering box and reservoir LHD 2.90............................ 5.00
Power steering box and reservoir RHD 3.40............................ 6.00
Swivel pin housing oil/grease (each) 0.35................................ 0.60
Fuel tank usable fuel
90 Models 60.00............................................................... 13.20 gall
110 & 130 Models 75.00................................................... 16.50 gall
Cooling system - Td5 13.00....................................................... 22.88
Washer bottle 3,0................................................................... 5.28
NOTE: * All levels must be checked by dipstick or level plugs as applicable.
ANTI-FREEZE
PERCENTAGE CONCENTRATION - 50%
PROTECTION - LOWER TEMPERATURE LIMIT
Complete protection
Vehicle may be driven away immediately from cold,
-33°C (-36°F).
Safe limit protection
Coolant in semi-frozen state. Engine may be started
and driven away after warm-up period, -41°C (-42°
F).
Lower protection
Prevents frost damage to cylinder head, block and
radiator. Thaw out before starting engine, -47°C (-53°
F).
CAUTION: Anti-freeze content must never
be allowed to fall below 50% otherwise
damage to the engine is liable to occur.
Also, anti-freeze content should not exceed 60%
as this will greatly reduce the cooling effect of the
coolant.RECOMMENDED FUEL
Diesel fuel oil, distillate, diesel fuel, automotive gas or
Derv to British standard 2869, Class A1 or A2
Using diesel fuel with a class rating lower than stated
above could seriously impair vehicle performance.
ProCarManuals.com

10MAINTENANCE
12
MAINTENANCE AUXILIARY DRIVE BELT
Check
1.Check auxiliary drive belt for signs of splits,
fraying, oil contamination and wear.
NOTE: Any requirement to replace the
auxiliary drive belt should be advised to
the customer as this will incur additional
labour and/or material cost and should not be
carried out without the authorisation of the
customer.
Renew
1.Renew auxiliary drive belt.See ELECTRICAL,
Repair.
NOTE: Additional time is built into the
96,000/8 year service time to allow for
auxiliary drive belt renewal.PAS FLUID, CLUTCH FLUID AND SCREEN
WASHER LEVELS
PAS Fluid
1.Clean arear around PAS reservoir filler cap, and
remove cap.
2.Check fluid level in PAS reservoir.
3.Top-up if necessary to the correct level using
recommended fluid.See LUBRICANTS,
FLUIDS AND CAPACITIES, Information.
4.Fit filler cap.
ProCarManuals.com

10MAINTENANCE
14
MAINTENANCE ENGINE OIL
WARNING: Avoid excessive skin contact
with used engine oil. Used engine oil
contains potentially harmful contaminants
which may cause skin cancer or other serious
skin disorders.
1.Remove underbelly panel.See CHASSIS AND
BODY, Repair.
2.Position suitable container beneath sump.
3.Clean arear around drain plug.
4.Remove oil drain plug, discard sealing washer.
5.Allow oil to drain.
6.Fit new sealing washer to oil drain plug.
7.Fit engine drain plug and tighten to23 Nm (17
lbf.ft).
8.Fill engine with recommended grade of oil to
correct mark on dipstick.See LUBRICANTS,
FLUIDS AND CAPACITIES, Information.
9.Fit underbelly panel.See CHASSIS AND
BODY, Repair.CENTRIFUGE ROTOR - Td5
1.Renew centrifuge rotor.See ENGINE , Repair.
ProCarManuals.com

10MAINTENANCE
16
MAINTENANCE TRANSFER BOX OIL
WARNING: Avoid excessive skin contact
with mineral oil. Mineral oils remove the
natural fats from the skin, leading to
dryness, irritation and dermatitis.
Check
1.Remove underbelly panel.See CHASSIS AND
BODY, Repair.
2.Clean area around oil filler/level plug.
3.Remove oil filler/level plug.
4.Check that oil level is to bottom of oil filler/level
plug hole.
5.Remove all traces of sealant from threads of oil
filler/level plug.
6.Apply Loctite 290 to threads of oil filler/level plug
and tighten to25 Nm (18 lbf.ft).
7.Remove all traces of oil from main casing.
8.Fit underbelly panel.See CHASSIS AND
BODY, Repair.Renew
1.Remove underbelly panel.See CHASSIS AND
BODY, Repair.
2.Place a suitable container beneath transfer box
to catch any fluid spillage.
3.Clean area around oil filler/level and drain plugs.
4.Remove oil filler/level plug.
5.Remove oil drain plug.
6.Allow oil to drain.
7.Apply Loctite 290 to threads of oil drain plug.
8.Fit transfer box drain plug and tighten to30 Nm
(22 lbf.ft).
9.Fill transfer box with recommended oil to bottom
of oil filler/level plug hole.See LUBRICANTS,
FLUIDS AND CAPACITIES, Information.
10.Remove all traces of sealant from threads of oil
filler/level plug.
11.Apply Loctite 290 to threads of oil filler/level plug
and tighten to25 Nm (18 lbf.ft).
12.Remove all traces of oil from main casing.
13.Fit underbelly panel.See CHASSIS AND
BODY, Repair.
ProCarManuals.com

MAINTENANCE
17
MAINTENANCE FRONT AND REAR AXLE OIL
Renew
A- Front and rear axle, 90 models, front, 110/130
models.
B- Rear axle, 110/130 models.
WARNING: Avoid excessive skin contact
with used axle oil. Used axle oil contains
potentially harmful contaminants which
may cause skin cancer or other serious skin
disorders.1.Ensure vehicle is level and place suitable tray
under axle to be drained.
2.Using 13mm square drive wrench, remove drain
and filler/level plugs from axle and allow oil to
drain completely.
3.Clean and refit drain plug.
4.Inject new oil, until it runs out from filler/level
hole. Allow excess oil to drain and wipe clean.
See LUBRICANTS, FLUIDS AND
CAPACITIES, Information.
5.Clean and refit filler/level plug.
Check
1.Ensure vehicle is level.
2.Using 13 mm square drive wrench, remove
filler/level plug.
3.If necessary inject new oiluntil oil runs out from
filler/level hole. Allow excess oil to drain and
wipe clean.See LUBRICANTS, FLUIDS AND
CAPACITIES, Information.
4.Clean and refit filler/level plug.
ProCarManuals.com

37MANUAL GEARBOX
2
ADJUSTMENT GEARBOX OIL - DRAIN AND REFILL
Service repair no - 37.24.01
Drain
1.The oil should be drained when the gearbox is
warm and the vehicle is standing on a level
surface.
WARNING: Observe due care when
draining gearbox as oil can be very hot.
2.Raise vehicle on ramp.
3.Position container to collect oil.
4.Clean area around filler/level plug.
5.Remove filler/level plug.
NOTE: Later gearboxes: Use No. 55 Torx
bit to remove filler/level plug.
6.Remove gearbox drain plug and discard sealing
washer.Refill
1.Clean gearbox drain plug and fit new sealing
washer.
2.Fit gearbox drain plug and tighten to50 Nm (36
lbf.ft).
3.Fill gearbox with correct grade of oil.See
LUBRICANTS, FLUIDS AND CAPACITIES,
Information.
4.Apply Loctite 290 to the filler/level plug and
tighten to30 Nm (22 lbf.ft).
5.Remove fluid container.
6.Lower vehicle on ramp.
ProCarManuals.com

REAR AXLE AND FINAL DRIVE
5
REPAIR DIFFERENTIAL ASSEMBLY - 90
Service repair no - 51.15.01
Remove
1.Using suitable container, drain axle oil.
2.Mark differential and propeller shaft flanges to
facilitate reassembly.
3.Remove 4 bolts and disconnect propeller shaft
from differential. Tie aside.
4.Remove 5 hub drive member bolts and withdraw
axle half shafts sufficiently to disengage from
differential unit.
5.Remove 10 nuts securing differential to axle
case.
6.Withdraw differential unit.
NOTE: The differential unit can only be
serviced as a complete assembly with
matching drive pinion. For advice ring
Land Rover Service Department.Refit
7.Ensure mating faces are clean and apply a bead
of RTV sealant to axle case.
8.Support differential unit and position on axle
casing.
9.Secure with self locking nuts and tighten to40
Nm (30lbf/ft).
10.Align marks on flanges and secure propeller
shaft to differential. Tighten bolts to48 Nm (35
lbf/ft).
11.Refit half shafts, using new drive member
gaskets. Tighten bolts to65 Nm (48 lbf/ft).
12.Refill axle oil with approved lubricantSee
LUBRICANTS, FLUIDS AND CAPACITIES,
Information. Recommended lubricants and
fluids.
ProCarManuals.com