1999 LAND ROVER DEFENDER door lock

09LUBRICANTS, FLUIDS AND CAPACITIES
2
INFORMATION Propeller shaft Front
and RearNLGI - 2 Multi-purpose Lithium based GREASE
Lubrication nipples
(hubs, ball joints
etc.)
Seat slides
Door lock striker
Brake and clutch
reservoirsBrake fluids having a minimum boiling point of 260°C (500°F) and complying with
FMVSS 116 DOT4
Engine coolant Use Texaco XLC long life coolant. Use one part anti-freeze to one part water for
protection down to -36°C (-33°F).
IMPORTANT: Coolant solution must not fall below 50% anti-freeze otherwise
damage to engine is liable to occur. Maximun concentration is 60%.
Battery lugs, Petroleum jelly.
Earthing surfacesNOTE: Do not use Silicone Grease
where paint has
been removed
Air Conditioning
System Refrigerant Use only refrigerant R134a
Compressor Oil ND-OIL 8
LUBRICATION PRACTICE
Use a high quality oil of the correct viscosity range and service classification in the engine during maintenance and
when topping up. The use of oil not to the correct specification can lead to high oil and fuel consumption and
ultimately to damaged components.
Oil to the correct specification contains additives which disperse the corrosive acids formed by combustion and
prevent the formation of sludge which can block the oilways. Additional oil additives should not be used. Always
adhere to the recommended servicing intervals.
WARNING: Many liquids and other substances used in motor vehicles are poisonous. They must
not be consumed and must be kept away from open wounds. These substances, among others,
include anti-freeze, windscreen washer additives, lubricants and various adhesives.
ProCarManuals.com

10 - MAINTENANCE
CONTENTS
Page
MAINTENANCE
UNDERBONNET VIEW - Td5 1..............................................................................
SEATS AND SEAT BELTS 2..................................................................................
LAMPS, HORNS AND WARNING INDICATORS 2................................................
WIPERS AND WASHERS 3...................................................................................
HANDBRAKE 3.......................................................................................................
BATTERY CONDITION - Td5 4..............................................................................
HANDSET BATTERY 5...........................................................................................
HEADLAMP ALIGNMENT 5....................................................................................
ROAD WHEELS 6...................................................................................................
TYRE PRESSURES, CONDITION AND TREAD DEPTH 6....................................
BRAKE PADS, CALIPERS AND DISCS 7..............................................................
ROAD WHEEL SPEED SENSOR HARNESS - Td5 7............................................
FUEL FILTER ELEMENT 8.....................................................................................
FUEL FILTER SEDIMENTER - Td5 8.....................................................................
INTERCOOLER / COOLING SYSTEM 9................................................................
AMBIENT AIR PRESSURE (AAP) SENSOR - Td5 9..............................................
DOOR LOCKS AND HINGES 10............................................................................
ENGINE COOLANT 10...........................................................................................
BRAKE FLUID 11....................................................................................................
AIR FILTER ELEMENT AND DUMP VALVE 11.....................................................
AUXILIARY DRIVE BELT 12...................................................................................
PAS FLUID, CLUTCH FLUID AND SCREEN WASHER LEVELS 12.....................
STEERING BOX 13................................................................................................
ENGINE OIL 14.......................................................................................................
CENTRIFUGE ROTOR - Td5 14.............................................................................
FULL FLOW OIL FILTER 15...................................................................................
GEARBOX OIL 15...................................................................................................
TRANSFER BOX OIL 16.........................................................................................
FRONT AND REAR AXLE OIL 17..........................................................................
PROPELLER SHAFTS 18.......................................................................................
CLUTCH PIPES AND UNIONS 18..........................................................................
PAS PIPES AND UNIONS 19.................................................................................
ENGINE, GEARBOX, TRANSFER BOX AND AXLES 19.......................................
EXHAUST SYSTEM 20...........................................................................................
STEERING BOX AND SUSPENSION 20...............................................................
STEERING BALL JOINTS 21.................................................................................
SHOCK ABSORBERS 22.......................................................................................
TOWING BRACKET 22...........................................................................................
ENGINE AND TRANSMISSION MOUNTINGS 23..................................................
ProCarManuals.com

10MAINTENANCE
10
MAINTENANCE DOOR LOCKS AND HINGES
Front, rear and tail doors
1.Open each door in turn and lubricate door
hinges and check strap using recommended
lubricant.
2.Lubricate door lock, striker and private lock using
PTFE lubricant. Remove excessive lubricant,
particularly from door striker area, to avoid
customer complaint.
3.Check tightness of accessible door lock and
striker fixings
4.Open and close door to check for smooth,
noise-free operation. Ensure door closes
securely.
5.Check for smooth operation of private lock.
Bonnet
1.With bonnet open, lubricate hinges, striker, lock
and safety catch using a suitable lubricant.ENGINE COOLANT
1.Renew engine coolant.See COOLING
SYSTEM, Adjustment.
ProCarManuals.com

76 - CHASSIS AND BODY
CONTENTS
Page
PLASTIC SHEET - REAR DOOR - FROM 02MY 34..............................................
LOCK - TAIL DOOR - FROM 02MY 35...................................................................
LOWER FASCIA PANEL - FROM 02MY 36...........................................................
ProCarManuals.com

76CHASSIS AND BODY
2
REPAIR TRIM CASING - TAIL DOOR - UP TO 02MY
Service repair no - 76.34.09
Remove
1.Remove 2 bolts securing grab handle to tail
door.
2.Remove grab handle.
3.Remove 2 screws securing wiper motor cover.
4.Remove wiper motor cover.
5.Remove 7 screws securing trim casing to door.
6.Remove 2 screws securing wiper motor harness
cover.
7.Remove harness cover.
8.Release 7 of 8 trim studs securing trim casing.
9.Remove trim casing from remaining stud.
10.Collect door lock cover.Refit
11.Position door lock cover.
12.Position trim casing and secure trim casing.
13.Position harness cover and secure with screws.
14.Secure trim pad with screws.
15.Fit wiper motor cover and secure with screws.
16.Fit grab handle and secure with screws.
ProCarManuals.com

CHASSIS AND BODY
7
REPAIR Refit
29.Fit bonnet cable grommet.
30.Fit side repeater lamp to wing.
31.Fit headlamp sealing ring, fit headlamp and
tighten screws.
32.Fit headlamp finisher, side and indicator lamps
and tighten screws.
33.Fit grille support bracket and tighten bolt.
34.With assistance, position and align wing to body
and locate bonnet cable to wing.
35.Connect headlamp, indicator, side lamp and side
repeater lamp multiplugs.
36.Fit bolt securing wing to bulkhead.
37.Fit bolts securing wing to’A’post.
38.Fit nut and bolt securing support stay to wing.
39.Fit bolt securing inner and outer wing to chassis.
40.Fit bolts securing radiator bracket to wing.
41.Fit bolts securing outer wing to inner wing.
42.Align wing and finally tighten all bolts.
43.Position wheel arch extension to wing, and fit
securing studs.
44.Position PAS reservoir to wing and tighten bolts.
45.Position expansion tank pipe and secure with
studs.
46.Position EGR solenoid and tighten bolts.
47.Position heater air intake seal and fit air intake.
48.Fit heater air intake bracket and tighten bolts.
49.Fit heater air intake grille and tighten screws.
50.Align air cleaner intake elbow, tighten screws
and fit grille.
51.Fit wheel arch liner.See this Section.
52.Position bonnet release cable to lock and tighten
screw.
53.Fit cooling fan cowl.
54.Fit front grille.See this Section.STEP - FOLDING - REAR DOOR
Service repair no - 76.10.41
Remove
1.Remove 2 bolts securing step to chassis
member, remove step and collect spacers.
Refit
2.Position step, fit spacer washers and tighten
bolts.
ProCarManuals.com

CHASSIS AND BODY
17
REPAIR TRIM CASING - REAR DOOR
Service repair no - 76.34.04.99
Remove
1.Remove screw securing door handle
escutcheon.
2.Remove escutcheon.
3.Remove interior lock button bezel.
4.Remove retaining clip and remove door glass
regulator handle.
5.Release covers and remove 2 screws securing
door pull to door.
6.Carefully release 12 clips securing trim casing to
door and remove door casing.Refit
7.Fit trim casing to door and secure with clips.
8.Fit door glass regulator handle.
9.Fit escutcheon to door handle and tighten screw.
10.Fit door lock button bezel.
11.Fit door pull and secure with screws.
ProCarManuals.com

CHASSIS AND BODY
23
REPAIR 59.Fit radio housing to fascia and secure with trim
studs.
60.Position radio to fascia and connect multiplugs
and aerial.
61.Fit radio to fascia.
62.Fit crash pad to fascia and secure with screws.
63.Fit both demister vents to crash pad and secure
with screws.
64.Fit grab handle to fascia and secure with screws.
65.Fit Land Rover decal to grab handle.
66.Position both front speakers to fascia and
connect multiplugs.
67.Fit speakers to fascia and secure with screws.
68.Fit locking rings to speakers.
69.Connect multiplugs and Lucars to HRW, Rear
Fog Guard Lamp, and Hazard Warning
Switches.
70.Fit switches to fascia.
71.Position heater controls to fascia and secure
with screws.
72.Fit instrument pack.See ELECTRICAL,
Repair.
73.Fit 2 halves of nacelle to steering column and
secure with screws.
74.Fit steering wheel.See STEERING, Repair.
75.Reconnect battery negative lead.PANEL - MOUNTING - FRONT DOOR - FROM 02MY
Service repair no - 76.11.28
Remove
1.Remove plastic sheet.See this Section.
2.Lower glass and remove 2 bolts securing door
glass to regulator.
3.Release glass from regulator, raise and wedge
in raised position.
ProCarManuals.com