MAINTENANCE
5
MAINTENANCE HANDSET BATTERY
Remove
NOTE: Do not remove a battery until you
are ready to install the replacement.
Always fit a Land Rover STC4080 or a
Panasonic CR2032 replacement battery.
1.Unlock the vehicle and disarm the alarm system.
2.Turn the ignition switch to position’II’, then turn
to position’0’and remove the key.
3.Carefully prise the handset apart, starting from
the keyring end. Avoid damaging the seal
between the two halves of the case.
CAUTION: Do not allow moisture to get
inside the handset.
4.Slide the battery out of its clip, taking care to
avoid touching the circuit board or the contact
surfaces of the clip.
5.Press and hold one of the buttons for at least 5
seconds to drain any residual power from the
handset.
Refit
6.Fit the new battery, ensuring that correct polarity
is maintained (+ve side facing up). Finger marks
will adversely affect battery life. Avoid touching
the flat surfaces of the battery, and wipe clean
before fitment.
7.Reassemble the two halves of the handset.
Operate the Padlock symbol button at least 4
times within range of the vehicle to
resynchronise the hanset.HEADLAMP ALIGNMENT
1.Check alignment of headlamps.See
ELECTRICAL, Adjustment.
ProCarManuals.com
