ENGINE
23
REPAIR FILTER - OIL
Service repair no - 12.60.04
Remove
1.Remove 3 bolts and remove engine acoustic
cover.
2.Release clip and disconnect breather hose from
camshaft cover.
3.Release clips and disconnect air flow meter from
air filter.
4.Disconnect multiplug from air flow meter.
5.Loosen clip screw and remove air inlet hose
from turbocharger.
6.Remove 3 bolts and remove manifold heat
shield.
7.Clean area around filter head and place a
container beneath engine.
8.Using a strap wrench, unscrew and discard filter.
Refit
9.Clean mating face of filter head.
10.Lubricate sealing ring of new filter with clean
engine oil.
11.Fit filter and tighten by hand until it seats then
tighten a further half turn.
12.Start and run engine to check for leaks.
13.Stop engine, wait a few minutes, then check oil
level.
14.Top up engine oil.
15.Position exhaust manifold heat shield and
tighten 3 bolts.
16.Position air inlet hose to turbocharger and
tighten clip screw.
17.Connect air flow meter to air filter and secure
clips.
18.Connect air flow meter multiplug.
19.Connect breather hose and secure with clip.
20.Position engine acoustic cover.
ProCarManuals.com
CHASSIS AND BODY
3
REPAIR LATCH - TAIL DOOR - UP TO 02MY
Service repair no - 76.37.16
Remove
1.Remove tail door trim casing.See this Section.
2.Collect latch cover.
3.Remove 2 screws securing latch to door and
collect captive nut bracket.
4.Remove 2 nuts securing latch to door and collect
captive bolt bracket.
5.Remove latch assembly and collect foam
gasket.
Refit
6.Fit foam gasket and latch assembly to tail door.
7.Fit captive nut and bolt brackets to tail door.
8.Secure latch to tail door with nuts and screws.
9.Fit cover to latch.
10.Fit tail door trim casing.See this Section.CARPET - LUGGAGE COMPARTMENT
Service repair no - 76.49.04
Remove
1.Remove 7 screws and remove carpet retainer.
2.Remove bolt covers and remove rear seat belt
bolts.
3.Release rear seat catches and fold seats
forward.
4.Remove luggage compartment carpet.
Refit
5.Position carpet.
6.Fold rear seats to position.
7.Align rear seat belts and tighten tighten bolts.
8.Fit bolt covers.
9.Position carpet retainer and tighten screws.
ProCarManuals.com
