Page 2473 of 3115
B06412
B06415
Drain Plug
B06413Drain Plug
- MAINTENANCECHASSIS
MA-9
57 Author: Date:
(b) Differential:
Remove the filler plug and feel inside the hole with your
finger. Check that the oil comes to within 5 mm (0.20 in.)
of the bottom edge of the hole. If the level is low, add oil
until it begins to run out of the filler hole.
Front differential oil: See page SA-35
Rear differential oil: See page SA-95
8. REPLACE AUTOMATIC TRANSMISSION FLUID (See
page AT-3-1)
9. REPLACE TRANSFER AND DIFFERENTIAL OIL
(a) Remove the drain plug and drain the oil.
(b) Reinstall the drain plug securely.
(c) Add new oil until it begins to run out of the filler hole.
Transfer oil: See page TR-6
Front differential oil: See page SA-35
Rear differential oil: See page SA-95
10. REPACK FRONT WHEEL BEARINGS AND DRIVE
SHAFT BUSHING GREASE
(a) Change the front wheel bearing grease (See page
SA-16).
NOTICE:
Maintenance free for rear wheel bearing.
(b) Repack the drive shaft bushing grease (See page
SA-33).
11. LUBRICATE PROPELLER SHAFT AND TIGHTEN
BOLTS
(a) Lubricate chassis components, referring to the lubrication
chart. Before pumping in grease, wipe off any mud and
dust on the grease fitting.
Page 2479 of 3115
MA02R-05
MA-4
- MAINTENANCEUNDER HOOD
52 Author: Date:
2004 LAND CRUISER (RM1071U)
UNDER HOOD
GENERAL MAINTENANCE
1. GENERAL NOTICE
Maintenance items may vary from country to country. Check the owner's manual supplement in which
the maintenance schedule is shown.
Every service item in the periodic maintenance schedule must be performed.
Periodic maintenance service must be performed according to whichever interval in the periodic main-
tenance schedule occurs first, the odometer reading (miles) or the time interval (months).
Maintenance services after the last period should be performed at the same interval as before unless
otherwise noted.
Failure to do even one item can cause the engine to run poorly and increase exhaust emissions.
2. WINDSHIELD WASHER FLUID
Check that there is sufficient fluid in the tank.
3. ENGINE COOLANT LEVEL
Check that the coolant level is between the LEVEL lines on the see-through reservoir at normal tem-
perature (20°C (68°F)).
4. RADIATOR AND HOSES
(a) Check that the front of the radiator is clean and not blocked with leaves, dirt or bugs.
(See page CO-14)
(b) Check the hoses for cracks, kinks, rot or loose connections.
5. BATTERY ELECTROLYTE LEVEL
Check the indicator.
When the indicator color is blue, the condition is satisfactory. A red color indicates that distilled water
must be added, and white indicates that charging is necessary.
6. BRAKE FLUID LEVELS
Check that the brake fluid level is near the upper level line on the see-through reservoir.
(See page BR-4)
7. ENGINE DRIVE BELTS
Check drive belt for fraying, cracks, wear or oiliness.
8. ENGINE OIL LEVEL
Check the level on the dipstick with the engine turned off.
9. POWER STEERING FLUID LEVEL
Check the level on the dipstick.
The level should be in the ºHOTº or ºCOLDº range depending on the fluid temperature.
10. AUTOMATIC TRANSMISSION FLUID LEVEL
Visually check the overflow plug and oil pan for fluid leaks or traces of fluid.
Page 2487 of 3115
PP1BR-03
PP-32
- PREPARATIONAUTOMATIC TRANSMISSION
91 Author: Date:
2004 LAND CRUISER (RM1071U)
LUBRICANT
ItemCapacityClassification
Automatic transmission fluid
Dry fill
Drain and refill
10.6 liters (11.2 US qts, 9.3 lmp qts)
3.0 liters (3.2 US qts, 2.6 lmp qts)ATF WS
