1998 OPEL FRONTERA battery location

8F–63 BODY STRUCTURE
Rear Window Regulator And Glass
Parts Location
651RW018
Legend
(1) Window Regulator
(2) Glass
(3) Cable Fixing Clip(4) Window Regulator Motor Connector
(5) Door Trim Panel
(6) Waterproof Sheet
Removal
1. Disconnect the battery ground cable.
2. Remove door trim panel.
Refer to Door Trim Panel (Rear) removal procedure
in this section.
3. Remove waterproof sheet (1).
Taking notice of the door harness, peel the
waterproof sheet off the door panel carefully.
651RS002

8F–65 BODY STRUCTURE
Rear Door Fixed Glass And Glass Run
Parts Location
651RW019
Legend
(1) Glass Run
(2) Rear Fixed Glass
(3) Sash Division(4) Sash Division Fixing Bolts
(5) Door Trim Panel
(6) Waterproof Sheet
(7) Glass
Removal
1. Disconnect the battery ground cable.
2. Remove door trim panel.
3. Remove waterproof sheet.
4. Remove glass.
Refer to Window Regulator and Glass removal
procedure in this section.
5. Remove glass run.
Pull the glass run (1) out from the door frame.
651RS007

8F–68BODY STRUCTURE
Rear Door Moulding
Parts Location
645RS003
Legend
(1) Rear Door Side Moulding(2) Rear Door Corner Moulding
(3) Rear Door Upper Moulding
Removal
1. Disconnect the battery ground cable.
2. Remove rear door side moulding.
3. Remove rear door upper moulding.
4. Remove rear door corner moulding.
Avoiding the weatherstrip (3), pry the moulding (2)
out from the door frame (1).
645RS004
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Install each moulding with no clearance between
each piece of moulding.
2. Assemble the edge portion (A portion) of the
moulding so that the clearance between the rear side
moulding and the waist seal is 1 mm (0.04 in).

8F–69 BODY STRUCTURE
Front Door Waist Seal
Parts Location
631RS009
Legend
(1) Nylon Washer(2) Door Mirror
(3) Front Door Waist Seal
Removal
1. Disconnect the battery ground cable.
2. Remove door mirror.
Refer to Exterior / Interrior Trim in this section.
3. Remove front door waist seal.
Remove the fixing screw and pull out the waist seal
(1) from the door frame while prying it up.
631RS010
Installation
1. Install the front door waist seal.
Apply soap and water to the inside of the waist seal
and align the screw hole of the waist seal to the door
panel hole, and gently tap the seal with a rubber
hammer.
Be sure not to tap the seal hard. This may result in
deforming the seal.
2. Install the door mirror.

8F–74BODY STRUCTURE
Front Door Seal Finisher
Parts Location
635RS002
Legend
(1) Front Door Sill Plate
(2) Front Door Seal Finisher
Removal
1. Disconnect the battery ground cable.
2. Remove front door sill plate.
3. Remove front door seal finisher (1).
Pull the finisher out from the body panel.
635RS003
Installation
1. Install the front door seal finisher (2).
Insert the finisher into the A corner and install the
finisher in the arrow–marked directions.
635RS002
2. Install the front door sill plate (1).
Take care not to allow the sill plate to distort or twist
the finisher.

8F–75 BODY STRUCTURE
Rear Door Seal Finisher
Parts Location
655RS002
Legend
(1) Rear Door Sill Plate and Luggage Side Lower
Cover
(2) Rear Door Seal Finisher
Removal
1. Disconnect the battery ground cable.
2. Remove rear door sill plate and the luggage side
lower cover.
3. Remove rear door seal finisher (1).
Pull the rear door seal finisher (1) out from the body
panel.
635RS003
Installation
1. Install the rear door seal finisher (2).
Insert the rear door seal finisher (2) into the A corner
and install the finisher in the arrow-marked
directions.
655RS002
2. Install the rear door sill plate and luggage side lower
cover.
Be careful not to allow the sill plate and the cover to
distort or twist the finisher.

8F–76BODY STRUCTURE
Tailgate Assembly (LH)
Parts Location
681RW008
Legend
(1) Tailgate Fixing Bolt
(2) Tailgate Hinge
(3) Tailgate Harness Connection(4) Tailgate Stopper Assembly
(5) Tailgate Trim Panel (LH)
(6) Tailgate Assembly (LH)
Removal
1. Disconnect the battery ground cable.
2. Remove tailgate time panel (LH).
Refer to Exterior / Interrior Trim in this section.
3. Remove tailgate stopper assembly
4. Remove tailgate harness connection.
Open the luggage trim panel lid and disconnect the
tailgate harness connection.
810RS003

8F–78BODY STRUCTURE
Tailgate Assembly (RH)
Parts Location
681RS004
Legend
(1) Tailgate Assembly (RH)
(2) Tailgate Trim Panel (RH)
(3) Tailgate Harness Connection(4) Rear Combination Light (RH)
(5) Tailgate Fixing Bolt
(6) Tailgate Hinge
Removal
1. Disconnect the battery ground cable.
2. Remove rear combination light (RH).
3. Remove tailgate trim panel (RH).
Refer to Exterior / Interrior Trim in this section.
4. Remove tailgate harness connection.
Disconnect the tailgate harness connection.
810RS004