1998 MITSUBISHI MONTERO oil pressure

[x] Cancel search: oil pressure

Page 796 of 1501

MITSUBISHI MONTERO 1998  Service Manual       *  Check power supply to PCM.
       *  Check fuel pressure.
       *  Check ignition timing.
       *  Check for disconnected or damaged vacuum hoses.
       *  Check for control relay malfunct

Page 797 of 1501

MITSUBISHI MONTERO 1998  Service Manual       *  Check idle air control (DC) motor (if applicable).
       *  Check idle air control (stepper) motor (if applicable).
       *  Check for fuel injector malfunction.
       *  Check for power t

Page 814 of 1501

MITSUBISHI MONTERO 1998  Service Manual                                                               Starters
Generator  ..................................  Generators & Regulators
                                                    Engine

Page 815 of 1501

MITSUBISHI MONTERO 1998  Service Manual Parking Brake Switch  ......................  Analog Instrument Panels
Park Lights  ........................................  Exterior Lights
Park/Neutral Position Switch  ............................

Page 820 of 1501

MITSUBISHI MONTERO 1998  Service Manual THROTTLE POSITION (TP) SWITCH or THROTTLE POSITION (TP) SENSOR in G \
-
TESTS W/CODES article.
         Engine Coolant Temperature Sensor
         See G - TESTS W/CODES article.
          Heated Oxyge

Page 823 of 1501

MITSUBISHI MONTERO 1998  Service Manual INSTRUMENT PANEL 
1998 Mitsubishi Montero
         1998 ACCESSORIES & EQUIPMENT
          Mitsubishi - Instrument Panels
          Eclipse, Galant, Mirage, Montero, Montero Sport, 3000GT
         DESC

Page 825 of 1501

MITSUBISHI MONTERO 1998  Service Manual Fig. 2:  Boost Pressure Gauge Test Terminals (3000GT Turbo)
Courtesy of Mitsubishi Motor Sales of America
         FUEL TANK SENDING UNIT
          Resistance Test
         Remove fuel tank sending un

Page 834 of 1501

MITSUBISHI MONTERO 1998  Service Manual          Eclipse 2.0L Non-Turbo With A/T
         Disconnect sensor harness connector. Check resistance between
sensor terminals. Resistance should be 300-1200 ohms. Replace sensor
as necessary.