1998 FORD WINDSTAR warning

Driving
225
*
[GF13000(ALL)01/96]
RWARNING
Towing trailers beyond the maximum recommended
gross trailer weight exceeds the limit of the vehicle and
could result in engine damage, transaxle damage,
structural damage, loss of control, and personal injury.
*
[GF13100(ALL)05/96]
Preparing to Tow
*
[GF13200(ALL)01/96]
For your safety and for the good of your vehicle, use the right
equipment for the type of trailer you tow. Also, make sure that
all towing equipment is properly attached to your vehicle. If
you are not certain that you are using the right equipment in
the proper manner, see your dealer or a reliable trailer dealer.
%*
[GF13300(ALL)01/96]
Hitches
*
[GF13400(ALL)01/96]
For towing trailers up to 2,000 lbs. (907 kg), use a good
weight-carrying hitch and hitch ball which uniformly distributes
the trailer tongue load through the underbody structure.
*
[GF13500(ALL)01/96]
Do not use single clamp bumper hitches or hitches that attach
to the axle.
*
[GF13600(ALL)01/96]
Whenever a trailer hitch and hardware are removed, make sure
all mounting holes in the underbody are properly sealed to
prevent exhaust fumes from entering the vehicle.
*
[GF13700(ALL)01/96]
Safety chains
*
[GF13800(ALL)01/96]
Always use safety chains between your vehicle and trailer.
Cross chains under the trailer tongue and allow slack for
turning corners. Connect safety chains to the vehicle frame or
hook retainers.Never attach chains to the bumper.
File:09wngfs.ex
Update:Mon Oct 7 11:46:08 1996

226
[GF13900(ALL)04/96]
Trailer brakes
*
[GF14000(ALL)01/96]
Separate trailer brakes are required on most trailers weighing
over 1,500 lbs. (680 kg).
*
[GF14100(ALL)05/96]
RWARNING
Do not connect a trailer's hydraulic brake system directly
to your vehicle's brake system. Your vehicle may not
have enough braking power and your chances of having
a collision greatly increase.
%*
[GF14200(ALL)01/96]
Trailer Lamps
*
[GF14300(ALL)01/96]
Make sure your trailer lamps conform to federal and local
regulations.
*
[GF14400(ALL)01/96]
Class I Trailer Tow electrical wiring provides two circuits (right
hand and left hand) to operate trailer stop/turn tail lamps. Each
stop/turn circuit will operate one combination stop/turn light
bulb (# 1157, 3157, 2357, or 3357) on the trailer. Never add more
than one trailer light bulb to one circuit.
*
[GF14500(ALL)01/96]
RWARNING
Always replace a fuse with one that has the specified
amperage rating. Using a fuse with a higher amperage
rating can cause severe wire damage and could start a
fire.
%*
[GF14600(ALL)05/96]
Driving While You Tow
[GF14700(ALL)09/96]
Be especially careful when driving while you tow a trailer.
Never drive faster than 45 mph (72 km/h) when you tow in
hilly country on hot days. Also, anticipate stops so that you can
brake gradually.
*
[GF14800(ALL)01/96]
If you use the speed control while you are towing on very long,
steep grades, the speed control may shut off automatically.
File:09wngfs.ex
Update:Mon Oct 7 11:46:08 1996

Driving
231
*
[GF18300(ALL)01/96]
Wheel Spin
[GF18400(ALL)01/96]
Extreme acceleration can cause the front wheels to spin,
resulting in reduced steering control. If the wheels spin during
vehicle start-up, shift to 2 (Second) gear. Move forward slowly
and evenly. If this does not work, try rocking the vehicle.
% [GF18500(ALL)04/96]
Driving at High Speeds
*
[GF18600(ALL)03/96]
RWARNING
Driving too fast for conditions creates the possibility of
loss of vehicle control. Driving at very high speeds for
extended periods of time may result in damage to vehicle
components.
*
[GF18700(ALL)03/96]
Ford Motor Company recommends obeying posted speed limits.
*
[GF18800(ALL)05/96]
RWARNING
Do not spin the wheels at over 35 mph (55 km/h). The
tires may fail and injure a passenger or bystander.
%*
[GF18900(ALL)01/96]
Driving in Bad Weather
%*
[GF19000(ALL)01/96]
Slippery roads
[GF19100(ALL)01/96]
n
Drive cautiously on wet or snowy roads.
*
[GF19200(ALL)01/96]
n
Do not quickly move the steering wheel unless necessary.
[GF19300(ALL)04/96]
n
Drive more slowly than you would normally.
*
[GF19400(ALL)01/96]
n
Do not use speed control.
*
[GF19500(ALL)01/96]
n
Give your vehicle more distance to stop.
[GF19600(ALL)04/96]
n
Use the ªsqueezeº technique for braking as described in
previous braking sections.
*
[GF19700(ALL)01/96]
n
Consider using one of the lower gears.
File:09wngfs.ex
Update:Mon Oct 7 11:46:08 1996

232
[GF19800(ALL)09/96]
RWARNING
To avoid skidding and losing control on slippery roads,
do not downshift into 1 (First) when you are moving
faster than 20 mph (32 km/h).
[GF19900(ALL)04/96]
RWARNING
The Anti-Lock Brake System may not prevent brake
lock-up on extremely slippery surfaces.
%*
[GF20000(ALL)01/96]
High water
*
[GF20100(ALL)01/96]
Do not drive through flooded areas unless you are sure that the
water is below the bottom of the wheel hubs.
[GF20200(ALL)04/96]
If you must drive through high water, drive slowly. You may
have limited traction or wet brakes so allow extra stopping
distance because your vehicle will not stop as quickly as usual.
[GF20300(ALL)04/96]
After you drive through the standing water, apply your brakes
gently several times as your vehicle moves slowly to help dry
the brakes.
*
[GF20400(ALL)05/96]
Rocking the Vehicle
[GF20500(ALL)04/96]
If your vehicle gets stuck (for example, in mud or snow), you
may rock it out. Shift in a steady rhythm between forward and
reverse gears. At the same time, press lightly on the accelerator.
If you are still stuck after a few minutes of rocking, call for a
tow truck.
[GF20600(ALL)01/96]
NOTE: If your vehicle is equipped with Traction Control,
make sure the system has been turned off before
attempting to rock the vehicle.
[GF20700(ALL)07/96]
SeeTraction Control Off Lightin theInstrumentationsection of
this guide for more information.
File:09wngfs.ex
Update:Mon Oct 7 11:46:08 1996

Driving
233
[GF20800(ALL)04/96]
Do not rock the vehicle for more than a few minutes. This may
overheat the engine, damage the transaxle, or damage the tires.
%*
[GF20900(ALL)01/96]
Driving With a Heavy Load
*
[GF21000(ALL)01/96]
The Safety Compliance Certification Label, located on the
driver's door pillar, provides important information regarding
the weight limits your vehicle can safely carry or tow. The total
weight of your vehicle, including the weight of the passengers
and cargo, should never be more than the Gross Vehicle Weight
Rating (GVWR). Also, the weight that your vehicle carries on
the front axle and rear axle should never be more than the
Gross Axle Weight Rating (GAWR) for the respective axle.
*
[GF21100(ALL)01/96]
The load capacities of your vehicle's tires affect the GVWR or
GAWR limitations. Using replacement tires with a higher weight
limit than the originals does not increase GVWR or GAWR.
Using lower capacity replacement tires may lower GVWR and
GAWR limitations.
*
[GF21200(ALL)01/96]
RWARNING
Do not exceed the GVWR or the GAWR specified on the
Safety Compliance Certification Label.
*
[GF21300(ALL)03/96]
Vehicle/Trailer Loads
[GF21400(ALL)01/96]
Your vehicle may tow a Class I trailer up to 2,000 lbs. (907 kgs)
or 3,500 lbs. (1,587 kgs) with Trailer Tow Package provided the
Gross Vehicle Weight (GVW) is less than the GVWR shown on
the Safety Compliance Certification Label.
File:09wngfs.ex
Update:Mon Oct 7 11:46:08 1996

236
[ER01000(ALL)12/95]
13-1/2 pica
art:0051021-A
Fuel pump shut-off switch reset button location
*
[ER01100(ALL)03/96]
RWARNING
If you see or smell fuel, do not reset the switch or try to
start your vehicle. Have all the passengers get out of the
vehicle and call the local fire department or a towing
service.
*
[ER01200(ALL)01/96]
If your engine cranks, but does not start after a collision:
*
[ER01300(ALL)01/96]1.
Turn the key in the ignition to the OFF position.
*
[ER01400(ALL)03/96]2.
Check under the vehicle for leaking fuel.
*
[ER01500(ALL)01/96]3.
If you do not see or smell fuel, push the fuel pump shut-off
reset button down. If the red button is already set, you may
have a different mechanical or electrical problem.
*
[ER01600(ALL)01/96]4.
Turn the ignition key to the ON position for a few seconds,
then turn it to the OFF position.
*
[ER01700(ALL)01/96]5.
Check under the vehicle again for leaking fuel. If you see or
smell fuel, do not start your vehicle again. If there is no fuel,
you can try to start your vehicle again.
*
[ER01800(ALL)03/96]6.
Check all vehicle warning lights before driving your vehicle.
File:10wners.ex
Update:Mon Oct 7 11:47:52 1996

242
[ER03300(ALL)01/96]3.
Use the fuse puller tool to remove the fuse.
[ER03400(ALL)01/96]4.
Check the fuse to see if it is blown. Look through the clear
side of the fuse to see if the metal wire inside is separated. If
it is, the fuse is blown and should be replaced with a fuse of
the correct amperage rating.
*
[ER03500(ALL)01/96]
7-1/2 pica art:0040210-B
Fuse puller tool and fuse
*
[ER03600(ALL)01/96]
RWARNING
Always replace a fuse with one that has the specified
amperage rating. Using a fuse with a higher amperage
rating can cause severe wire damage and could start a
fire.
*
[ER03700(ALL)01/96]5.
Put the fuse panel cover back on.
*
[ER03800(ALL)04/96]
Even after you replace a fuse, it may continue to blow if you do
not find what caused the overload. If the fuse continues to
blow, have your electrical system checked.
File:10wners.ex
Update:Mon Oct 7 11:47:52 1996

246
*
[ER04500(ALL)01/96]
RWARNING
Always disconnect the battery before servicing high
current fuses.
*
[ER04600(ALL)01/96]
Ford recommends that high current fuses be replaced by a
qualified technician.
*
[ER04700(ALL)01/96]
RWARNING
Always replace the cover to the Power Distribution Box
before reconnecting the battery or refilling fluid
reservoirs.
[ER04800(ALL)01/96]
A blown maxi-fuse may be replaced but will continue to blow
until the cause of the overload condition is corrected.
*
[ER04900(ALL)01/96]
RWARNING
Always replace a fuse with one that has the specified
amperage rating. Using a fuse with a higher amperage
rating can cause severe wire damage and could start a
fire.
%*
[ER05000(ALL)05/96]
Relays
% [ER05100(ALL)01/96]
Relays are devices which receive signals from components or
systems. After receiving signals, relays transfer these signals to
activate or deactivate other components or systems. One relay
box is located with the maxi-fuses near the battery and one is
located with the fuse panel under the instrument panel.
File:10wners.ex
Update:Mon Oct 7 11:47:52 1996