B00319
Recommended Viscosity (SAE):
TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE °F
°C-20
-29 0
-1820
-740
460
1680
27100
38 10W-30
5W-30 PREFERRED
2JZ-GE
Z09522
Recommended Viscosity (SAE):
10W - 30
5W - 30
-20
-29 -18 -7 4 16 27
38 0 20 40 60 80 100
°C °F
TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE
2JZ-GTE
LU0JY-01
Z13413
2JZ-GTE
Z16754
2JZ-GTE M/T
P11837
- LUBRICATIONOIL AND FILTER
LU-1
1448 Author: Date:
1997 SUPRA (RM502U)
OIL AND FILTER
INSPECTION
1. CHECK OIL QUALITY
Check the oil for deterioration, entry of water, discoloring or thin-
ning.
If oil quality is visibly poor, replace the oil.
Oil grade (2JZ-GE):
API grade SH Energy-Conserving II or SJ, Energy-
Conserving or ILSAC multigrade engine oil.
SAE 5W-30 is the best choice for your vehicle, for
good fuel economy, and good starting in cold weath-
er.
Oil grade (2JZ-GTE):
API grade SH Energy-Conserving II or SJ, Energy-
Conserving or ILSAC multigrade engine oil.
Recommended viscosity is as shown in the illustra-
tion.
2. CHECK ENGINE OIL LEVEL
The oil level should be between the low level and full level marks
on the dipstick.
If low, check for the leakage and add oil up to full level mark.
3. REMOVE ENGINE UNDER COVER
4. 2JZ-GTE:
REMOVE NO.2 AIR TUBE
Loosen the 2 hose clamps, and remove 2 bolts and air tube.
5. 2JZ-GTE M/T:
REMOVE DRIVE BELT TENSION DAMPER
Remove the 2 nuts and tensioner damper.
6. REMOVE DRIVE BELT
Loosen the drive belt tension by turning the drive belt tensioner
clockwise, and remove the drive belt.
Z04031
R08549
Less than 5 mm (0.20 in.)
- SUSPENSION AND AXLEREAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL
SA-61
1751 Author: Date:
1997 SUPRA (RM502U)
7. INSTALL SIDE GEAR SHAFT
(a) Install a new snap ring to the side gear shaft.
(b) Coat MP grease onto the snap ring.
(c) Using a brass bar and hammer, install the side gear shaft
to the differential.
NOTICE:
Be careful not damage the side gear shaft and oil seal.
HINT:
Whether or not the side gear shaft is making contact with the
pinion shaft can be determined by the sound or feeling when
driving it in.
8. CHECK INSTALLATION OF SIDE GEAR SHAFT
Check that the side gear shaft will not come out by trying to pull
it out by hand.
9. INSTALL REAR DRIVE SHAFT (See page SA-58)
10. FILL DIFFERENTIAL WITH HYPOID GEAR OIL
Torque: 49 N´m (500 kgf´cm, 36 ft´lbf)
Oil grade: Hypoid gear oil API GL-5
Viscosity:
Above -18 °C (0 °F) SAE 90
Below -18 °C (0 °F) 80W-90 or SAE 80W
Capacity: 1.35 liters (1.43 US qts, 1.19 lmp. qts)
