R15899
SST
R07227
SST
Upper SA-78
- SUSPENSION AND AXLEREAR DIFFERENTIAL CARRIER
1768 Author: Date:
1997 SUPRA (RM502U)
9. INSTALL SIDE BEARING OUTER RACE AND ADJUST
PLATE WASHER
(a) 2JZ-GTE M/T:
Using SST and a press, install the outer race.
SST 09950-60020 (09951-00910),
09950-70010 (09951-07150)
(b) Others:
Using SST and a press, install the outer race and adjust-
ing plate washer.
SST 09950-60020 (09951-00810),
09950-70010 (09951-07150)
10. INSTALL DIFFERENTIAL CASE IN CARRIER
Install the drive side bearing in the differential carrier first, as
shown in the illustration, then install the differential case.
11. 2JZ-GTE M/T:
INSTALL ADJUSTING PLATE WASHER AND DIFFER-
ENTIAL CARRIER RETAINERS
(a) Place the adjusting washer to the carrier retainer.
(b) Using SST and a hammer, install the carrier retainer with
adjusting washer.
SST 09950-60020 (09951-00910),
09950-70010 (09951-07150)
HINT:
Do not install a new O-ring and a new oil seal.
Install it after inspect tooth contact pattern.
(c) Tighten the 8 bolts.
Torque: 47 N´m (480 kgf´cm, 35 ft´lbf)
12. EXCEPT 2JZ-GTE M/T:
INSTALL DIFFERENTIAL CARRIER RETAINERS
(a) Using SST and a hammer, install the carrier retainer.
SST 09950-60020 (09951-00890),
09950-70010 (09951-07150)
(b) Tighten the 8 bolts.
Torque: 22 N´m (225 kgf´cm, 16 ft´lbf)
Z16467
FIPG
R07455
SA-86
- SUSPENSION AND AXLEREAR DIFFERENTIAL CARRIER
1776 Author: Date:
1997 SUPRA (RM502U)
31. RECHECK BACKLASH, TOTAL PRELOAD AND
TOOTH CONTACT PATTERN (See page SA-74)
32. REMOVE DIFFERENTIAL CARRIER FROM OVER-
HAUL STAND, ETC.
33. INSTALL DIFFERENTIAL CARRIER COVER
(a) Clean the contact surfaces of the carrier and cover of any
residual FIPG material using cleaner.
(b) Coat FIPG to the carrier or cover.
FIPG:
Part No. 08826-00090, THREE BOND 1281 or equiva-
lent
NOTICE:
After installing the cover, wait at least 1 hour before filling
it with oil or running the vehicle.
(c) Install the carrier cover to the carrier with the 8 bolts.
Torque
2JZ-GTE M/T78 N´m (800 kgf´cm, 58 ft´lbf)
Others47 N´m (475 kgf´cm, 34 ft´lbf)
(d) Install the breather plug.
Torque: 21 N´m (210 kgf´cm, 15 ft´lbf)
