1997 GMC JIMMY towing

Driving with a Trailer
1 CAUTION:
If you have a rear-most window open and you
pull a trailer with your vehicle, carbon nlonoxide
(CO) could corne into your vehicle. You can’t see
or smell CO. It can cause unconsciousness or
death. (See “Engine Exhaust” in the Index.)
To
maximize your safety when towing a trailer:
Have your exhaust system inspected for
leaks, and make necessary repairs before
starting
on your trip.
Keep the rear-most windows closed.
If exhaust does come into your vehicle
through a window in the rear or another
opening, drive with your front, main
heating
or cooling system on and with the
fan on any speed.
This will bring fresh,
outside air into your vehicle. Do not use
MAX AX because it only recirculates the
air inside your vehicle. (See “ Comfort
Controls” in the Index.)
4-50

Following Distance
Backing
Up
Making Turns
NOTICE:
Making very sharp turns while trailering could
cause the trailer to come
in contact with the
vehicle.
Your vehicle could be damaged. Avoid
making very sharp turns while trailering.
Turn Signals When Towing a Trailer
4-51

When towing a trailer, the ~~rrows on your instrument
panel
will flash for turns even if the bulbs on the trailer
itre burned out. Thus. you may think drivers behind you
are seeing your signal when they are not. It's important
to check occasionally to be sure the trailer bulbs arc
still working.
Driving On Grades
On a long uphill grade, shift down and reducc your
speed
to around 45 mph (70 km/h) to reduce the
possibility
of engine and transmission ovc.rheating.
If you have an automatic transmission. you should use
DRIVE
(D) when towing a trailer. Operating your
vehicle
in DRIVE (D) when towing a trailer will
minimize heat buildup and extend the life
of your
trrmsmission. Or:
if you have ;1 manual transmission. it's
better not to use FIFTH (5) gear. just drive in
FOURTH (4) gear (or, as you need to, a I~MW gear). Whcn
towins at high altitude
on steep uphill grades,
consider the following: Engine coolant will boil at a
lower temperature than at normal altitudes. If yo^^ turn
your engine off immediately after towing
at high altitude
on steep uphill grades, your \:ellicle may show signs
similar to engine overheating.
To avoid this. let the
engine
r~~n while parked (preferably on level grout1d)
with the automatic transmission in PARK (Pj (or the
1manuaI transmission out of
gear and the parking brake
applied) 1'01-
;I few minutes before turning the engine off.
If you do get the overheat warning. see "Engine
Overheating"
in the Index.
Parking on Hills
You really should not park your vehicle. with a trailer
attached.
on a hill. If something goes wrong, your rig
could start
to move. People can be injured, and both
yo~~r vehicle and the trailer can
be damaged.
4-52

When You Are Ready to Leave After
Parking on
a Hill
I, Apply your reg~~lar brakes and lwld the pedal down
while you:
Start your engine;
Shift into a gear: and
Release the parking brake.
2. Let up on the brake pedal.
3. Drive slowly until the trailer is clear of the chocks.
4. Stop and have someone pick up and store the chocks.
Maintenance When Trailer Towing
Your vehicle will need service nlore often when you're
pulling a trailer. See the Maintenance Schedule for more
on
this. Things that are especially important in trailer
operation
are automatic transmission fluid (don't
overfill), engine
oil. ~~xle lubricant, belt, cooling system
and
brakc adjustment. Each of these is covered in this
manurd.
and the Index will help you find then] quickly.
If you're trailering. it's a good idea to review these
sections before you start your trip.
Check periodically
to see that all hitch nuts and bolts
are tight.
4-54

1- E3 +I
Towing Your Vehicle
5-7

c A -T-l[BN:
To help avoid injury to you or others:
0
0
0
0
0
0
Never let passengers ride in a vehicle that is
being towed.
Never tow faster than safe or posted speeds.
Never tow with damaged parts not
fully secured.
Never get under your vehicle after it has
been lifted by the tow truck.
Always use separate safety chains on each
side when towing
a vehicle.
Never use J-hooks. Use T-hooks instead.
I
A vehicle can fall from a car carrier if it isn’t
adequatelJT secured. This can cause a collision,
serious personal injury and vehicle damage. The
vehicle should
he tightly secured with chains or
steel cables before it is transported.
Don’t use substitutes (ropes, leather straps,
canvas webbing, etc.) that can be cut
by sharp
edges underneath the towed vehicle. Always use
T-hooks inserted
in the T-hook slots. Never use
J-hooks. They
will damage drivetrain and
suspension components.
5-8

When your vehicle is being towed. have the ignition key
turned to the OFF position. The steering wheel should
be cla111ped
in a straight-alwad position with a clamping
device designed for towing service. Do not use the
vehicle's steering column lock for this. The transmission
should be
in NEUTRAL (N) and the transfer case, if you
have one. should be in 2HI. The parking brake should
be released.
If your vehicle 11as a floor mounted shifter and no
electrical power, the electrical solenoid lock must be
overridden to shift from PARK (P) to NEUTRAL (N).
Follow these steps:
1. Push the base of the shift lever boot forward \%7ith
your tlwmb.
2. Lift the boot and find the white solenoid lever.
3.
4.
5.
Move the solenoid lever toward the driver's side to
unlock
it.
While holding the solenoid lever in the ~~nlock
position. press the shift lever button and shift into
NEUTRAL (N).
5-9

NOTICE:
Do not tow with sling-type equipment or
fascia/fog lamp damage
will occur. Use wheel-lift
or car carrier equipment. Additional ramping
may be required for car-carrier equipment. Use
safety chains and wheel straps.
Towing
a vehicle over rough surfaces could
damage
a vehicle. Damage can occur from
vehicle to ground or vehicle to wheel-lift
equipment. To help avoid damage, install a
towing dolly and raise the vehicle until adequate
clearance
is obtained between the ground and/or
wheel-lift equipment.
Do not attach winch cables or J-hooks to
suspension components when using car-carrier
equipment. Always use T-hooks inserted in the
T-hook slots.
5-10