1997 FORD F250 lock

7
% [II04900(F )04/96]
NOTICE TO OWNERS OF
DIESEL-POWERED VEHICLES
[II05000(F )04/96]
Read the7.3L Diesel Engine Owner's Guide
Supplementfor information regarding correct
operation and maintenance of your
diesel-powered light truck.
%
*
[II05100(FM)01/96]
Your Vehicle Identification
Number (VIN)
*
[II05200(FM)04/96]
You should include your Vehicle Identification
Number (VIN) any time you write to Ford
Motor Company about your vehicle.
*
[II05300(F )03/96]
The Vehicle Identification Number is attached to
your vehicle in the following places:
[II05350(F )04/96]
Complete Ford Built Vehicles
*
[II05400(F )03/96]
q
on the metal tag attached to the top of the
instrument panel on the driver's side Ð you
can see the tag by looking through the
windshield from outside your vehicle.
*
[II05450(F )03/96]
one inch art:0010558-A
Vehicle Identification Number (VIN/Serial Number)
%*
[II05500(F )03/96]
q
on the Safety Compliance Certification Label
Ðthis label is attached to the left front door
lock facing or the door latch post pillar. It is
required by the National Highway Traffic
Safety Administration and is made of special
material. If someone tampers with it, it will
be destroyed and/or a destruction pattern
will appear.
File:02ltiif.ex
Update:Tue May 28 08:39:40 1996
ProCarManuals.com

16 %
*
[IS03200(F )03/96]
Anti-Lock Brake System Warning Light
*
[IS03300(F )04/96]
To check the ABS brake warning light turn the
ignition key to ON. The ABS brake warning
light should glow momentarily.
*
[IS03400(F )03/96]
NOTE: If it does not glow momentarily, have
your vehicle's electrical system checked
immediately.
[IS03500(F )04/96]
NOTE: If the ABS brake warning light begins
to flash in a repeatable flash sequence,
check the rear anti-lock system
continuous power fuse and brake lights
for proper operation.
[IS03600(F )04/96]
one inch art:0020913-B
Antilock warning light
*
[IS03700(F )03/96]
RWARNING
If the anti-lock brake system warning
light remains on or comes on while
driving, have the braking system checked
by a qualified service technician as soon
as possible.
*
[IS03800(F )03/96]
NOTE: If a fault occurs in the anti-lock
system, and the brake warning light is
not lit, the anti-lock system is disabled
but normal brake function remains
operational.
File:03ltisf.ex
Update:Tue May 28 08:40:24 1996
ProCarManuals.com

23 %
*
[IS11100(FM)03/96]
Speedometer
*
[IS11200(FM)03/96]
The speedometer tells you how many miles
(kilometers) per hour your vehicle is moving.
*
[IS11300(F )03/96]
Your vehicle contains a speedometer which
receives its input from the Anti-Lock brake
sensor. The speedometer is also used to provide
a speed signal for correct operation of the
vehicle's Powertrain Control Module (PCM),
electronic transmission, and speed control (if so
equipped). Because of this, it is very
IMPORTANT to change the speedometer's
internal conversion constant if the size of the
tires on the vehicle is changed. Changing the
conversion constant to the proper value when
the tires are changed will also ensure that the
speedometer retains the original factory-set
accuracy.
*
[IS11500(F )03/96]
Some vehicles are equipped with a vehicle speed
(mph/km/h) limiting device that is contained
within the Powertrain Control Module (PCM).
The purpose of this device is to maintain peak
vehicle speed below a specified limit. (Vehicle
speed limits may vary based on engine
displacement.)
*
[IS11600(F )03/96]
If you are experiencing an ªengine cut-outº
condition at high speeds, it may be the result of
this limiting device. It is a normal condition and
can be avoided by reducing vehicle/engine
speed.
File:03ltisf.ex
Update:Tue May 28 08:40:24 1996
ProCarManuals.com

31
*
[AS03000(F )02/96]
q
Setting the Station Memory Preset buttons
%*
[AS03100(F )08/95]
Your radio is equipped with 5 station
memory buttons. These buttons can be used
to select up to 5 preset AM stations and 10
FM stations (5 in FM1 and 5 in FM2). Follow
the easy steps below to set these buttons to
the desired frequencies.
*
[AS03200(F )03/96]
1. Select a band, then select a frequency.
*
[AS03400(F )10/95]
2. Press one of the memory preset buttons and
hold the button until the sound returns. That
station is now held in memory on that
button.
*
[AS03500(F )10/95]
3. Follow the two steps above for each station
memory preset button you want to set.
*
[AS03510(F )08/95]
NOTE: If the vehicle's battery is disconnected,
the clock and station memory preset
buttons (if programmed in auto mode)
will need to be reset.
*
[AS03520(F )10/95]
q
Using the Automatic Memory Load feature
*
[AS03530(F )08/95]
You can activate theAuto Memory Load
feature by pressing and holding the ªAUTO
PRESETº buttonfor approximately three
seconds. Auto Memory Load sets all memory
buttons in AM, FM1 and FM2 sequentially by
seeking out the first five strong stations for
the respective band and storing them in
memory buttons 1-5. (FM2 will store the
second set of strong stations from the FM
band.)
File:04ltasf.ex
Update:Tue May 28 08:40:59 1996
ProCarManuals.com

34
*
[AS05250(F )09/95]
NOTE: Illuminated bars in the display show
relative levels of bass and treble and
positions of speaker balance and fader
functions after adjustments are made,
then revert to volume level set.
%*
[AS05300(F )08/95]
Clock operation
*
[AS05350(F )08/95]
When in the radio mode, push the ªCLOCKº
button to switch from radio frequency to clock.
Only the clock numerals will be displayed in the
clock mode Ð there is no A.M./P.M. indication.
When in the clock mode, the time will be
displayed until the button is pushed again.
However, if you retune the radio while it is in
the clock mode, the new radio frequency will be
displayed for approximately ten seconds and
then change back to clock.
*
[AS05400(F )08/95]
When in the CD mode, push the ªCLOCKº
button to change the display from elapsed time
mode to track number mode to clock mode. If
the CD track selection is changed when you are
in the clock or elapsed time mode, the new track
number will be displayed for approximately ten
seconds and then revert back to the previous
mode.
*
[AS05425(F )08/95]
The clock can also be viewed with the ignition
off. Push the ªCLOCKº button and the time will
be displayed momentarily.
*
[AS05450(F )08/95]
To set the clock, simultaneously press the
ªCLOCKº button and either the bottom (
b) half
of the ªSEEKº button to set hours, or the top
(
a) half of the ªSEEKº button to set minutes.
File:04ltasf.ex
Update:Tue May 28 08:40:59 1996
ProCarManuals.com

35 %
*
[AS06050(F )10/95]
Using the Controls on Your New Compact
Disc Player
*
[AS06150(F )03/96]
Your new Ford Compact Disc Player is capable
of playing 12 cmor8 cm discs, without an
adapter. The player operates when the power is
on and a disc is inserted (label side up). Handle
the disc by its edge only. (Be sure to read and
follow all of the care and cleaning instructions
underHow To Take Care of and Clean Your CD
Player and Discs.)
*
[AS06200(F )09/95]
NOTE: If after you insert a disc, the disc is
ejected and ªERRORº begins scrolling
in the display, remove the disc and
reinsert it right side up (label side up).
*
[AS06250(F )08/95]
The digital display on your CD player will
either show the track (selection) number or the
elapsed time. (The display mode can be selected
by pressing the ªCLOCKº button.) Indicators for
play (
a), stop (
X) and compression on (ªCº)
are also in the display. (These features are
described later.)
*
[AS06300(F )10/95]
Once a disc is inserted, operation of the CD
player will override that of the radio.
*
[AS06350(F )09/95]
NOTE: The volume, bass, treble, balance and
fader controls on the radio are also
used with the CD player. Refer to
earlier operating instructions on these
controls.
*
[AS06400(F )04/96]
How to insert a disc and begin play
*
[AS06450(F )10/95]
Insert one disc,label side upinto the disc
opening. When inserted, the disc automatically
loads into the unit and play starts at the
beginning of the first track (selection).
*
[AS06500(F )04/96]
When the disc reaches the end, the disc player
automatically returns to the beginning of the
disc and resumes playing.
File:04ltasf.ex
Update:Tue May 28 08:40:59 1996
ProCarManuals.com

46
*
[AS23400(F )08/95]
Follow the easy steps below to set these buttons
to the desired frequencies:
*
[AS23500(F )03/96]
1. Select a band, then select a frequency.
*
[AS23700(F )10/95]
2. Press one of the memory preset buttons and
hold the button until the sound returns. That
station is now held in memory on that
button.
*
[AS23800(F )10/95]
3. Follow the two steps above for each station
memory preset button you want to set.
*
[AS23900(F )08/95]
NOTE: If the vehicle's battery is disconnected,
the clock and station memory preset
buttons (if programmed in auto mode)
will need to be reset.
*
[AS24000(F )10/95]
Adjusting the tone balance and speaker
output of your radio
*
[AS24150(F )02/96]
Push the ªAUDIOº button repeatedly until
the display reads ªBASS.º Push the right (+)
side of the ªVOLUMEº button to increase
bass (more ªlowsº), and push the left (S)
side to decrease bass (less ªlowsº).
*
[AS24300(F )02/96]
q
Increasing or decreasing treble response
*
[AS24350(F )02/96]
Push the ªAUDIOº button repeatedly until
the display reads ªTREB.º Push the right (+)
side of the ªVOLUMEº button to increase the
treble (more ªhighsº), and push the left (S)
side to decrease treble (less ªhighsº).
File:04ltasf.ex
Update:Tue May 28 08:40:59 1996
ProCarManuals.com

48
*
[AS25700(F )12/95]
How to locate a desired track on the tape
*
[AS26265(F )08/95]
q
Using the Automatic Music Search (ªAMSº)
*
[AS26270(F )03/96]
Press and hold the ªAMSº button (ªAMSº will
appear in the display). Then, push the left
h
button to rewind to the beginning of the current
selection or press the right
gbutton to fast
forward to the beginning of the next selection.
*
[AS26900(F )08/95]
q
How to change the side of the tape being
played
*
[AS27000(F )09/95]
The alternate track (other side) of the tape
can be selected at any time by pushing both
fast-wind buttons (
hand
g) at the
same time. The number in the display will
alternate between 1 and 2.
*
[AS27100(F )08/95]
How to eject the tape
*
[AS27250(F )04/96]
To stop the tape and eject the cassette, press the
eject (i) button. The radio will resume playing.
*
[AS27300(F )02/96]
Using the DolbyHB noise reduction feature
*
[AS27500(F )04/96]
Push thekbutton to activate. Push again to
deactivate.
*
[AS27550(F )09/95]
NOTE: Noise reduction system manufactured
under license from Dolby Labs
Licensing Corporation. ªDolbyº and
double-D symbol are trademarks of
Dolby Laboratories Licensing
Corporation.
%*
[AS27555(F )01/96]
Clock Operation
*
[AS27560(F )08/95]
How to view the clock mode
*
[AS27565(F )08/95]
Press the ªCLOCKº button to alternate the
frequency and time in the display. In the clock
mode, pressing any radio function will
automatically display the radio frequency for
approximately ten seconds before changing back
to the clock mode.
File:04ltasf.ex
Update:Tue May 28 08:40:59 1996
ProCarManuals.com