1997 FORD F250 lock

109
*
[SS12000(F )05/96]
RWARNING
Each seating position in your vehicle has a
specific safety belt assembly which is
made up of one buckle and one tongue
that are designed to be used as a pair. 1)
Use the shoulder belt on the outside
shoulder only. Never wear the shoulder
belt under the arm. 2) Never swing it
around your neck over the inside
shoulder. 3) Never use a single belt for
more than one person.
*
[SS12100(F )02/96]
RWARNING
Lock the doors of your vehicle before
driving to lessen the risk of the door
coming open in a collision.
% [SS12150(F )05/96]
Dual Locking Mode Retractors
[SS12200(F )01/96]
Your vehicle is equipped with a dual locking
mode retractor on the shoulder belt portion of
the combination lap/shoulder safety belt for
front seat passenger and rear seat outboard
passengers.
[SS12500(F )01/96]
Vehicle Sensitive (Emergency) Locking Mode
*
[SS12600(F )01/96]
In this operating mode, the shoulder belt
retractor will allow the occupant freedom of
movement, locking tight only on hard braking,
hard cornering or impacts of approximately
5 mph (8 km/h) or more.
[SS12700(F )01/96]
The front seat belt retractor can also be made to
lock by pulling/jerking on the belt.
File:06ltssf.ex
Update:Tue May 28 08:44:33 1996
ProCarManuals.com

110 % [SS12800(F )01/96]Automatic Locking Mode
*
[SS12900(F )08/95]
In this operating mode, the shoulder belt
retractor will be automatically locked and remain
locked when the combination lap/shoulder
safety belt is buckled, and does not allow the
occupant freedom of movement. This mode
provides the following:
*
[SS13000(F )01/96]
q
A tight lap/shoulder belt fit on occupant
[SS13100(F )01/96]
q
Child seat/infant carrier installation restraint
[SS13300(F )01/96]
This mode must be used when installing a child
seat on the front passenger seat and rear
outboard seats where dual locking retractors are
provided.
[SS13400(F )01/96]
To switch the retractor from the ªemergency
locking modeº to the ªautomatic locking mode,º
perform the following steps:
*
[SS13500(F )02/96]
1. Buckle the lap/shoulder combination belt.
[SS13600(F )01/96]
2. Grasp the shoulder portion of the belt and
pull downward until all of the belt is
extracted, and when allowed to retract, a
clicking sound will be heard. At this time,
the belt retractor is in the ªautomatic locking
modeº (child restraint mode).
[SS13700(F )01/96]
3. A clicking sound will continue to be heard
as the belt is allowed to retract. This
indicates that the retractor is in the
ªautomatic locking mode.º
File:06ltssf.ex
Update:Tue May 28 08:44:33 1996
ProCarManuals.com

111 [SS13750(F )05/96]
How to cancel the Automatic Locking
Mode:
[SS13775(F )05/96]
Disconnect the combination lap and shoulder
belt and allow it to completely retract to cancel
the Automatic Locking Mode and be in the
Vehicle Sensitive (Emergency) Mode.
[SS13800(F )01/96]
NOTE: When the combination lap/shoulder
belt is unbuckled and allowed to
retract completely, the retractor will
switch back to the vehicle sensitive
(emergency) locking mode. See the
detailed instructions underSafety Seats
for Childrenin this chapter.
%
*
[SS14350(F )02/96]
Combination Lap and Shoulder
Belts
[SS14400(F )04/96]
While your vehicle is in motion, the combination
lap and shoulder belt adjusts to your movement.
However, if you brake hard, corner hard or if
your truck receives an impact of 5 mph
(8 km/h) or more, the combination lap/shoulder
belt locks and helps reduce your forward
movement. The front seat belt systems can also
be made to lock by jerking on the shoulder belt.
[SS14450(F )04/96]
NOTE: The rear belts cannot be made to lock
up by jerking on shoulder belt.
*
[SS14500(F )01/96]
After you get into your vehicle, close the door
and lock it. Then adjust the seat to the position
that suits you best.
[SS14600(F )01/96]
To fasten the belt
*
[SS14700(F )02/96]
Pull the combination lap/shoulder belt from the
retractor so that the shoulder portion of the belt
crosses your shoulder and chest. Be sure the belt
is not twisted. If it is, remove the twist. Insert
File:06ltssf.ex
Update:Tue May 28 08:44:33 1996
ProCarManuals.com

113 [SS15500(F )01/96]
While you are fastened in the seat belt, the
combination lap and shoulder belt adjusts to
your movement. However, if you brake hard,
turn hard, or if your vehicle receives an impact
of 5 mph (8 km/h) or more, the lap and
shoulder belt will become locked and help
reduce your forward movement.
[SS15510(F )05/96]
Shoulder Belt Height Adjustment
(If equipped)
*
[SS15520(F )05/96]
Driver and right front passenger
[SS15530(F )05/96]
The driver and right front passenger shoulder
belt height is adjustable to one of five (5)
positions.
*
[SS15540(F )05/96]
To adjust the belt down, push the release button
on the adjuster down and slide the adjuster
down. Then release the button and make sure
the adjuster is firmly in one of the positions. To
adjust the belt up, slide the adjuster up. (You do
not have to push the release button.) Slide it up
or down until the belt rests across the middle of
your shoulder.
*
[SS15550(F )05/96]
RWARNING
Position the shoulder belt height adjuster
so that the belt rests across the middle of
your shoulder. Be sure the shoulder belt is
properly positioned on your shoulder each
time you use the belt. If the shoulder belt
is off your shoulder, on your upper arm
or neck, there is a greater risk of severe
injury in a collision.
*
[SS15560(F )05/96]
NOTE: Be sure the belt is properly positioned
on your shoulder each time you use
the belt.
File:06ltssf.ex
Update:Tue May 28 08:44:33 1996
ProCarManuals.com

114 [SS15570(F )05/96]
half page art:0021600-AShoulder belt height adjuster Ð full up position
%*
[SS16800(F )12/95]
Lap Belts
[SS16900(F )05/96]
The lap belts for center seating position
occupants do not have retractors, but do have a
locking adjustable tongue. They should be
shortened and fastened to buckle when you are
not using them. To lengthen your belt, tip the
belt tongue at a right angle to the belt and pull
the belt over your lap until the tongue reaches
the buckle.
File:06ltssf.ex
Update:Tue May 28 08:44:33 1996
ProCarManuals.com

122 [SS26800(F )04/96]
RWARNING
If the shoulder belt cannot be properly
positioned, move the child to one of the
seats with a lap belt only (preferably in a
rear seat) and use the lap belt.
*
[SS26900(F )01/96]
Lap belts and the lap belt portion of lap and
shoulder belts should always be worn snugly
and below the hips, touching the child's thighs.
*
[SS27000(F )02/96]
RWARNING
Children should always ride with the
seatback in the fully upright position.
%*
[SS27100(F )01/96]
Safety Seats for Children
*
[SS27200(F )01/96]
Use a safety seat that is recommended for the
size and weight of the child. Always follow the
safety seat manufacturer's instructions when
installing and using the safety seat.
*
[SS27300(F )01/96]
Ford recommends the use of a child safety seat
having a top tether strap. Install the child safety
seat in a seating position which is capable of
providing a tether anchorage. For more
information on top tether straps seeAttaching
Safety Seats With Tether Strapsin this chapter.
[SS27400(F )01/96]
When installing a child safety seat, be sure to
use the correct safety belt buckle for that seating
position making sure the tongue is securely
fastened in the buckle and for a shoulder/lap
belt combination with a sliding tongue make
sure the retractor is in the ªautomatic locking
mode.º
*
[SS28300(F )05/96]
All child restraint systems are designed to be
secured in vehicle seats by lap belts or by the
lap portion of a lap-shoulder belt.
File:06ltssf.ex
Update:Tue May 28 08:44:33 1996
ProCarManuals.com

124 [SS28800(F )01/96]
half page art:0021377-B
*
[SS28900(F )01/96]
Installing Child Safety Seats
[SS29000(F )01/96]
Your vehicle is equipped with a dual locking
mode retractor on the shoulder belt portion of
the combination lap/shoulder safety belt for the
front seat passenger and a dual-locking mode
retractor for rear outboard passengers.
*
[SS29300(F )01/96]
If you choose to install a forward-facing child
safety seat or infant carrier in the front seating
positions, move vehicle seat as far back as
possible.
File:06ltssf.ex
Update:Tue May 28 08:44:33 1996
ProCarManuals.com

125
*
[SS29400(F )01/96]
For seating positions equipped with a
dual-locking mode retractor, use the following
procedure:
*
[SS29800(F )05/96]
1. Position the child seat in the center of the
passenger seating position.
*
[SS29900(F )02/96]
2. Pull down on shoulder belt, then grasp
shoulder belt and lap belt together. See
Figure 1.
*
[SS30000(F )04/96]
half page art:0011238-C
Pulling out belt webbing
File:06ltssf.ex
Update:Tue May 28 08:44:33 1996
ProCarManuals.com