1997 CADILLAC SEVILLE fog light

Downloaded from www.Manualslib.com manuals search engine c
c
c
c
c
VeSnicle Synb&
These are some of the symbols you may find 011 your vehicle.
For example.
these symbols
are used on
an
original battery:
POSSIBLE A
CAUTION
INJURY
PROTECT EYES
BY
SHIELDING
CAUSTIC
ACID COULD
x
BATTERY
CAUSE
BURNS
SPARK
OR ,\I/,
COULD FLAME
EXPLODE BATTERY
These symbols
arc
important
for you and
your passengers
u:henever your
\.chicle is
driven:
n
DOOR LOCK
UNLOCK
FASTEN BELTS SEAT
.;$-
e;/
AIR
BAG f!! FOG
LAMPS # 0
These symbols
are
on some of
your controls:
WINDSHIELD
WIPER
WINDSHIELD
DEFROSTER
VENTILATING FAN
These symbols
are used on
warning and
indicator lights:
COOLANT -
TEMP -
BRAKE (0)
COOLANT
a
ENGINE OIL w,
PRESSURE
ANTI-LOCK
(@)
BRAKES
Here are some
other symbols
you may see:
FUSE -%-
t
LIGHTER m
HORN kz7
SPEAKER
b
FUEL p3

Downloaded from www.Manualslib.com manuals search engine c
c
.-.
c
The control on the left
side
of the instrument
panel controls these
lamp systems:
1
i
0
0
0
0
0
0
0
e
*
Headlamps
Taillamps Parking Lamps
Sidemarker
Lamps
License Plate Lamp
Underhood Lamp
Fog Lamps (STS Only)
Instrument Panel Lights
Interior Courtesy Lamps Pull the lamp control
knob out to the first stop to
turn on
the parking and taillamps, sidemarker lamps and
instrument panel lights. Pull the knob out all the way
to
turn on the headlamps. Push the control knob all the way
back
in to turn the lamps and lights off.
Cluster lighting as well as instrument panel backlighting
will dim
only when it is dark outside.
~-~.~~~~~~~~~~~.~~~~
The control for the headlamps is on the left side of the
instrument panel. Pull the lamp control knob all the way
out
to turn the headlarnps on. Push the control knob all
the way back in to turn the headlamps
off.
This feature activates the headlamps and parking lamps
after
the windshield wipers have been in use for
approximately
20 seconds.
In order to operate the wiper activated headlamps. the
twilight sentinel must be
in the on position. This feature
lights the way in poor weather and
it also makes your
vehicle more visible
to other drivers. If the wiper
activated headlamps are on. and the ignition switch
is
turned off. the wiper activated headlamps will
immediately turn off.

Downloaded from www.Manualslib.com manuals search engine The wiper activated headlamps will deactivate if you
turn off the twilight sentinel or if the windshield wipers
have been turned off' for a period of one or two seconds.
You will hear a warning chime if you open any door
while leaving
the lamps on, if the manual headlamp
control
is activated. An exception to this is when you're
using twilight sentinel.
Daytime Running Lamps (DRL) can make
it easier for
others
to see the front of your vehicle during the day.
DRL can be helpful in many different driving
conditions, but they can be especially helpful in the
short periods after dawn and before sunset.
The DRL system will make
the high-beam headlamps
come on at reduced brightness when:
0 the ignition is on,
0 the headlamp switch is off and
6 the transaxle is not in PARK (P).
When
DRL are on, only your high-beam headlamps (at
reduced brightness) will be
on. No other exterior- lamps
such as the parking lamps, taillamps, etc. will be on
when the DRL are being used. YGW instsument panel
won't be lit
up either.
When the twilight sent!xL s\s-i:ch is 011 and it's dark
enough outside. the hi@1-ixaE
hea&s (at reduced
intensity)
will turn off and nor:nal low-beam headlamy
operation will occur.
When the t\:..iiight sentinel switch
is on and it's bright enough otltsids.
the regular lamps
will
go off, and the high-beax headlmps at reduced
brightness will
take ovc- for the DRL.
If it's dark enough outside and the twilight sentinel
control is off. a HEADLAMPS SUGGESTED message
will display on the DIC. This message infotms the driver
that turning
on the exterior lamps is reconmended even
though the
DRE are still illunlinated (it's become dark
enough outside to require the headlamps and/or other
exterior lamps). Turning
on the twilight sentinel, the
headlamp switch or the fog lamp switch will remove
the HEADLAMPS
SUGGESTED message.
To idle your vehicle with the DRL off, turn off the
twilight sentinel switch and shift the transaxle into
PARK (P). Placing your vehicle in PARK (P) disables
the DRL.
Ths DRL will stay off until you shift out of
PARK (P).
As with any vehicle. you should turn on the regular
headlamp system when
you need it.

Downloaded from www.Manualslib.com manuals search engine Use the fog lamps for better
vision in foggy or misty
conditions. When
you press
the fog lamp button, a small
indicator light will tell
you
that the fog lamps and the
park.ing lamps are
on. Press
the button again
to turn
them
off.
If you switch on the high-beam headlamps, the fog
lamps will turn off. They'll turn back on again when
you switch to low-beam headlamps.
When the twilight sentinel is
on and the fog lamp switch
is activated. the fog lamps will remain
on as well as the
headlamps and parking lamps.
~:.:wK&..ri~:l$~ . .- IBI.-,kanlps
The cornering lamps come on when the headlamps or
parking lamps are on and you signal a turn. They
provide more light for cornering. The
control
is next to the
headlamp knob. It
automatically switches
the
lamps on and off by sensing
how dark
it is outside.
To operate the twilight
sentinel, leave the lamp
knob
off and move the
TWILIGHT control to any
position but
OFF.
If you move the control all the way to the right, the
lamps
will remain on for approximately three minutes
after the ignition has been turned
to the OFF or LOCK
position. It you move the control so it is just on. the
lamps will go
off quickly when you turn the ignition
switch out of RUN. You can adjust the delay time from
only a few seconds to three minutes.
If it's dark enough outside and the twilight sentinel control
is
off. a HEADLAMPS SUGGESTED message will
display on the DIC. This message infoms the driver that
turning on the exterior lamps is recommended (it's become
dark enough outside
to require the headlamps and/or other
exterior lamps). Turning on the twilight sentinel, the
headlamp switch or the
fog lamp switch will remove the
HEADLAMPS SUGGESTED message.

Downloaded from www.Manualslib.com manuals search engine The following chart shows what lamps are controlled by the twilight sentinel in various conditions:
..--
- Light _.-__.-. Outside . .. Dark Outside
Twilight Switch On Twilight Switch
Off
Domestic & Canadian Domestic Canadian
Park and
Low Beams (Automatic) **** X X
NO Lamps or Message- X* X*
DRL** X X***
DRL and Manual Park Lamps** X
Manual Park LamDs X* X***
~~ -
-
--. -
t
Manual Park and Fog Lamps x* X
Manual Park, Fog and DRL**
-
X I
Manual Park Lamps and Low IseaEsi- X X
Manual Low Beams, Park and Fog Lamps X ---.-- - Y
* Must be in PARK (P)
~r* Not in PARK (P)
*** Reminder message will be displayed if not in PARK (P)
**** Lamps turn on automatically if twilight switch is on and windshield wipers are activated

Downloaded from www.Manualslib.com manuals search engine The light sensor for the DRL and the twilight sentinel is
located in
the center of the front defogger grille, If you
cover the sensor. it will read "dark" and the lamps will
come on. Cluster
lighting
as well as instrument panel lighting
automatically dims when
it becomes dark outside.
When
it's dark. the brightness control can be manually
acljustecl. Cluster lighting and instrument panel lighting
auton-iaticallv brighten when it becomes light outside.

Downloaded from www.Manualslib.com manuals search engine Vacuum around a speaker cover gently, so that the
speaker won’t be damaged. Some spots and stains will
clean off better with just water
and mild soap. If
something gets
on one of them and you need to use a
solvent, follow these steps:
1. Gently scrape excess soil from the trim material with
a clean, duIl knife or scrape::
2. Use very little cleaner, light pressure and clean cloths
(preferably cheesecloth). Cleaning should start at the
outside
of the stain, “feathering” toward the center.
3. Keep changing to a clean section of the cloth.
4. When you clean a stain from fabric, immediately
dry the area with a blow dryer to help prevent a
cleaning ring.
are of Safety Belts
Keep belts clean and dry.
Do not bleach or dye safety belts. If you do, it
may severely weaken them. In a crash, they
might not be able to provide adequate protection.
Clean safety belts only with mild soap and
lukewarnl water.
Glass Surfaces
Glass should be cleaned often. CM Glass Cleaner (GM
Part No. 1050427) or a liquid household glass cleaner
will remove normal tobacco smoke and dust films on
interior glass.
Don’t use abrasive cleaners on glass, because they may
cause scratches. Avoid placing decals on the inside rear
window, since they may have
to be scraped off later. If
abrasive cleaners are used on the inside of the rear
window.
an electric defogger element may be damaged.
Any temporary license should not be attached across the
defogger grid.

Downloaded from www.Manualslib.com manuals search engine RELAY CENTER IDENTIFICATION
Fuse
BODY I
Usage
Real Time Dampening (RTD)
Fuse, Convenience Fuse, BATT
Fuse, Passenger and Driver Seat
Belt Comfort Solenoids, Trunk
and Fuel Door
Release Solenoids
and Relays,
Door Lock/Unlock
Relays, DPR Relay
(STS Only),
Park Lamp Relay, Right and Left
Park Fuse, Rear Fog Lamp Relay
BODY 2
BODY 3
INADVERT
Usage
Defog Relay, Pull-Down Fuse,
Right and Left Heated
Seat Fuse,
Electronic Level Control (ELC)
FuselRelay, Antenna Fuse, Heated
Mirror
Fuse
Controlled Power Relay,
Controlled Power
Back-up Relay,
Cluster Fuse, Platform Zone
Module (YZM) Fuse, Radio Fuse,
DAB Relay, Trunk and Fuel Door
Release Relay, High Beam Relay,
Comfort Fuse, Controlled Power
Relay, AMP Bose Only Fuse,
Right and Left
Bose Relay
Jnadvertent Power Relay, Interior
Lamps Fuse, Cigarette Lighter- 1
Fuse, Cigarette Lighter-2 Fuse