RS0QE-02
N12255
Front
- SUPPLEMENTAL RESTRAINT SYSTEMFRONT PASSENGER AIRBAG ASSEMBLY
RS-31
1996 TERCEL (RM440U)
INSTALLATION
1. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY
Install the airbag door and front passenger airbag assembly to
the instrument panel.
CAUTION:
Make sure that no foreign objects are trapped between the
airbag bag, and within the module.
NOTICE:
If the front passenger airbag assembly has been dropped,
or there are cracks, dents or other defects in the case or
connector, replace the front passenger airbag assembly
with a new one.
2. INSTALL INSTRUMENT PANEL (See page BO-38)
Install the 2 bolts to instrument panel reinforcement.
Torque: 19 N´m (195 kgf´cm, 14 ft´lbf)
NOTICE:
Make sure the front passenger airbag assembly is
installed to the specified torque.
When installing the instrument panel, take care that
the airbag wire harness does not interfere with other
parts and is not pinched between other parts.
When installing the instrument panel box, carefully
pull out the airbag wire harness from the glove
compartment upper hole.
3. CONNECT AIRBAG CONNECTOR
(a) Connect the airbag connector.
(b) Install the lower finish panel (See page BO-45).
BO348-01
N12255
Front BO-50
- BODYINSTRUMENT PANEL
1996 TERCEL (RM440U)
DISASSEMBLY
1. REMOVE DEFROSTER NOZZLE
2. REMOVE NO. 3 HEATER TO REGISTER DUCT
3. REMOVE NO. 1 HEATER TO REGISTER DUCT
4. REMOVE NO. 1 REGISTER
5. REMOVE NO. 3 REGISTER
6. REMOVE NO. 2 REGISTER
7. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY
(a) Remove the 2 bolts, 2 nuts and the front passenger airbag
assembly.
(b) Remove the airbag door.
CAUTION:
Do not store the front passenger airbag assembly
with the airbag deployment direction facing down.
Never disassemble the front passenger airbag as-
sembly.
NOTICE:
When installing the instrument panel, take care that
the airbag wire harness does not interfere with other
parts and is not pinched between other parts.
When installing the instrument panel box, carefully
pull out the airbag wire harness from the glove
compartment upper hole.
8. REMOVE CENTER BRACKET
9. REMOVE LOWER RH PANEL
10. REMOVE LOWER LH PANEL
11. REMOVE INSTRUMENT PANEL WIRE HARNESS
