− MANUAL TRANSAXLETRANSFER (4WD)
MX−97
1996 RAV4 (RM447U)
(d) Install and torque the 4 bolts.
Torque: 25 N·m (260 kgf·cm, 19 ft·lbf)
20. INSTALL DYNAMIC DAMPER
Install the dynamic damper and torque the 4 bolts.
Torque: 25 N·m (260 kgf·cm, 19 ft·lbf)
21. INSTALL DUST BOOT
PR07S−01
Q05756
65.5 − 70.5 mm
(2.579 − 2.776 in.)
Q06145
11.5 − 13.5 mm
(0.453 − 0.536 in.)
− PROPELLER SHAFTPROPELLER SHAFT ASSEMBLY
PR−9
1996 RAV4 (RM447U)
INSTALLATION
1. INSTALL INTERMEDIATE SHAFT
(a) Remove SST from the transfer.
(b) Insert the yoke into the transfer.
2. INSTALL CENTER SUPPORT BEARING TEMPORARI-
LY
3. INSTALL PROPELLER SHAFT
(a) Align the matchmarks on the flanges and connect the
shaft with the 4 bolts, washers and nuts.
(b) Torque the bolts and nuts.
Torque: 74 N·m (750 kgf·cm, 54 ft·lbf)
4. TIGHTEN CROSS GROOVE JOINT SET BOLT
(a) Depress the brake pedal and hold it.
(b) Using a hexagon wrench, tighten the cross groove joint
set bolts.
Torque: 27 N·m (275 kgf·cm, 20 ft·lbf)
5. INSTALL CENTER SUPPORT BEARING
(a) With the vehicle in the unladen condition, adjust the di-
mension between the rear side of cover and the shaft, as
shown in the illustration.
(b) With the same condition, adjust the dimension between
the rear side of center bearing housing and the rear side
of cushion at 11.5 − 13.5 mm (0.4528 − 0.5315 in.), as
shown in the illustration below, then torque the bolts.
Torque: 37 N·m (375 kgf·cm, 27 ft·lbf)
(c) Check that the center line of the bracket is at right angles
at the shaft axial direction.
