1996 PONTIAC FIREBIRD Owners Manual

To turn ~ff the flashers, pull
out on the collar.
When the hazard warning flashers are on, your turn
signals won’t work.
Other Warning Devices
If you carry reflective triangles, you can set one up at
the
side of the road about 300 feet (100 m) behind
your vehicle.
Jump Starting
If your battery has run down, you may want to use
another vehicle and some jumper cables to start
your Pontiac. But please use the following steps to
do it safely. ’. * ..
Batteries can hurt you. They can be dangerous
because:
0 They contain acid that can burn you.
They contain gas that can explode or ignite.
They contain enough dectricity to burn you.
If you don’t follow these steps exactly, some or all
of these things can hurt you.

5-2
ProCarManuals.com

NOTICE:
Ignoring these steps could result in costly damage
to your vehicle that wouldn’t be covered by your
warranty.
Trying to start your Pontiac by pushing or
pulling
it could damage your vehicle, even if you
have a manual transmission.
And if you have an
automatic transmission, it won’t start that way.
1. Check the other vehicle. It must have a 12-volt
battery with a negative ground system.
NOTICE:
If the other system isn’t a 12-volt system with a
negative ground, both vehicles can be damaged.
2. Get the vehicles close enough so the jumper cables
can reach, but be sure the vehicles aren’t touching
each other. If they are, it could cause a ground
connection you don’t want.
You wouldn’t be able to start
your Pontiac, and the bad grounding could
damage the electrical systems.
unnecessary accessories plugged into the cigarette
lighter. Turn
off all lamps that aren’t needed as well
as radios. This will avoid sparks and help save both
batteries. In addition, it could save your radio!
3. Turn off the ignition on both vehicles. Unplug
(CE:
r
If you leave your radio on, it could be badly
damaged. The repairs wouldn’t be covered by
your warranty.
4. Open the hoods and locate the batteries.
I==--
~
An electric fan can start up even when the engine
is not running and can injure you. Keep hands,
clothing and tools away from any underhood
electric fan.
ProCarManuals.com

5. Find the positive (+) ad negative (-) terminals on
each battery.
Using a match near a battery can cause battery
gas to explode. People have
been hurt doing this,
and some have been blinded. Use a flashlight if
you need more light.
Be sure the battery has enough water. You don't
need to add water to the Delco Freedom@ battery
installed in every new GM vehicle. But if a
battery has filler caps, be sure the right amount
of fluid is there. If it is low, add water to take-
care
of that first. If you don't, explosive gas
could be present.
Battery
fluid contains acid that can burn you.
Dan't get it on you. If you accidentally get it in
your eyes or on your skin, flush the place with
water
and get medical help immediitely.
.- :A,
,. .- , .. . ..
6. Check that the jumper cables don't have loose or
missing insulation.
If they do, you could get a shock.
The vehicles could be damaged, too.
Before
you connect the cables, here are some basic
things
you should know. Positive (+) will go to
positive
(+) and negative (-) will go to negative (-)
or a metal engine part. Don't connect positive.(+) to
negative
(-) or you'll get a short that would damage
the battery
and maybe other parts, too.
Fans or other moving engine parts can injure you
badly. Keep your hands away
from moving parts
once the engines are running.
,I. I'
,- . .-
ProCarManuals.com

7. Connect the red positive (+) cable to the positive (+)
terminal of the vehicle with the dead battery. Use a
remote positive (+) terminal if the vehicle has one.
Don’t use the junction block on your Pontiac.
8. Don’t let the other end
touch metal. Connect
it
to the positive (+)
terminal of the good
battery. Use a remote
9. Now connect the
black negative
(-) cable
to the
good battery’s
negative
(-) terminal.
Don’t let the other end touch anythmg until the
next step. The other end
of the negative (-) cable
doesn’t
go to the dead
battery. It goes to a heavy
unpainted metal part on
the engine of&e vehicle
with the dead battery.
5-5
ProCarManuals.com

13. Remove the cables in reverse order to prevent
electrical shorting. Take care that they don’t touch
each other or any other metal.
10.
11.
12.
Attach the cable at least 18 inches (45 cm) away
from the dead battery, but not near engine parts that
move. The
electrical connection is just as good
there, but the chance of sparks getting back to the
battery is much less.
Now start the vehicle with the good battery and run
the engine for a while.
Try to start the vehicle with the dead battery.
If it won’t start after a few tries, it probably
needs service.
A. Heavy Metal Engine Part
B, Good Battery
C. Dead Battery
5-6
ProCarManuals.com

Towing Your Vehicle
Try to have a Pontiac dealer or a professional towing
service tow your Firebird.
If your vehicle has been changed or modified since it
was factory-new by adding aftermarket items like
fog
lamps, aero skirting, or special tires and wheels, these
instructions may not be correct.
Before you do anything, turn on the hazard
warning flashers.
When you call, tell the towing service:
That your vehicle cannot be towed from the front or
That you vehicle has rea-wheel drive.
0 The make, model and year of your vehicle!
rear
with sling-type equipment.
0 Whether you can still move the shift lever.
0 If there was an accident, what was damaged.
When the towing service arrives, let the tow operator
know that this manual contains detailed towing
instructions and illustrations. The operator may want
to see them.
I I
To help avoid injury to you OF others:
0 Never let passengers ride in a vehicle that is
0 Never tow faster than safe or posted speeds.
0 Never tow with damaged parts not fully
secured.
0 Never get under your vehicle after it has
been lifted
by the tow truck.
0 Always secure the vehicle on each side with
separate safety
chains when tswhg it.
0 Never use J-hooks. Use T-hooks instead.
being towed.
ProCarManuals.com

A CAUTION:
A vehicle can fall from a car carrier if it isn’t
adequately secured. This can cause
a collision,
serious personal injury and vehicle damage. The
vehicle should be tightly secured with chains or
steel cables before it
is transported.
Don’t use substitutes (ropes, leather straps,
canvas webbing, etc.) that can be cut by sharp
edgeswderneath the towed vehicle. Always use
T-hooks inserted in the T-hook slots. Never use
J-hooks. They will damage drivetrain and
suspension components.
When your vehicle is being towed, have the ignition
key turned #to the
OFF position. The steering wheel
should be clamped in a straight-ahead position, with
a clamping device designed for towing service. Do not
use the vehicle’s steering column lock
for this. The
transmission should be in
NEUTRAL (N) and the
parking brake released.
Don’t have your vehicle towed on the drive wheels
unless you must. If the
vehicle must be towed on the
drive wheels, be sure to follow the speed and distance
restrictions later in this section
or your transmission will
be damaged. If these limits must be exceeded, then the
drive wheels have to be supported on a dolly.
5-8
ProCarManuals.com

Front Towing
Tow Limits -- 35 mph (55 kh), 50 miles (80 km)
I
NOTICE:
Do not tow with sling-type equipment or
fascidfog light damage will occur.
Use wheel lift or car carrier equipment.
Additional ramping may be required
for car
carrier equipment.
Use safety chains and wheel straps.
.(.
Attach T-hook chains to slots in frame, rearward of front
wheels on both sides.
I
5-9
ProCarManuals.com