1996 PONTIAC FIREBIRD Owners Manual

Air Cleaner
3800 L36 (Code K) Engine
5.7L LT1 (Code P) Engine
Refer
to the Maintenance Schedule to determine when to
replace the air filter. . ‘1 ’ 8.1. - ’ (<,
See “Scheduled Maintenance Senkes” in the Index.
6-16
ProCarManuals.com

Operating the engine with the air cleaner off can
cause you or others to be burned. The air cleaner
not only cleans the air, it stops flame if the engine
backfires.
If it isn't there, and the engine
backfires, you could be burned. Don't drive with
it off, and be careful working on the engine with
the air cleaner off.
i
I NOTICE: I
LIftheeaner is off, a backfire can cause a I
Air Filter Replacement
To remove the air filter:
damaging engine fire. And, dirt can easily get
have the air cleaner in place when you're driving.
into
your engine, which will damage
it. Always
1. Remove the plastic pin by pulling it straight up.
ProCarManuals.com

2. Disconnect the plastic clamp on the duct. Pull apart
the connection.
3. Pull the air cleaner straight up. Unclamp the
metal
clips.
ProCarManuals.com

4. Open the air cleaner and remove the filter.
If you have the 5.7L LT1 engine (with the WS6 option),
your air cleaner will be located near the front of the
engine compartment.
To remove the filter, remove the screws (located on the
rear edge
of the air cleaner), lift the air cleaner and
remove the filter.
ProCarManuals.com

Automatic Transmission Fluid
When to Check and Change
A good time to check your automatic transmission fluid
level is when the engine oil
is changed.
Change both
the fluid and filter every 15,000 miles
(25 000 km) if the vehicle is mainly driven under one
or more
of these conditions:
In heavy city traffic where the outside temperature
regularly reaches
90°F (32°C) or higher.
In hilly or mountainous terrain.
When doing frequent trailer towing.
Uses such as found in taxi, police or delivery service.
If you do not use your vehicle under any of these
con’ditions, change
the fluid and filter every 100,000 miles
(166 000 km).
See “Scheduled Maintenance Services” in the Index.
How to Check
Because this operation can be a little difficult, you
may choose to have this done at your Pontiac dealership
Service Department.
If you do it yourself, be sure to follow all the instructions
here, or you could get a false reading on the dipstick.
NOTICE:
Too much or too little fluid can damage your
transmission. Too much can mean that some of
the fluid could come out and fall on hot engine
parts or exhaust system parts, starting a fire.
Be
sure to get an accurate reading if you check your
transmission fluid.
Wait at least 30 minutes before checking the
transmission fluid level if
you have been driving:
When outside temperatures are above 90°F (32 ” C).
At high speed for quite a while.
0 In heavy traffic -- especially in hot weather.
0 While pulling a trailer.
To get the right reading, the fluid should be at normal
operating temperature, which
is 180°F to 200°F
(82°C to 93°C).
ProCarManuals.com

Checking Transmission Fluid Hot
Get the vehicle warmed up by driving about 15 miles
(24 km) when outside temperatures are above 50°F
(10°C). If it's colder than 50°F (lO"C), drive the
vehicle in DRIVE
(D) until the engine temperature gage
moves and then remains steady for 10 minutes. Then
follow the hot check procedures.
Checking Transmission Fluid Cold
A cold check is made after the vehicle has been sitting
for eight hours
or more with the engine off and is used
only
as a reference. Let the engine run at idle for five
minutes if outside temperatures
are 50°F (10" C) or
more. If it's colder than
50°F (lO"C), you may have to
idle the engine longer. Should the fluid level be low
during a cold check, you must perform a hot check
before adding fluid. This will give you a more accurate
reading of the fluid level.
Checking the Fluid Hot or Cold ,
0 Park your vehicle on a level place. Keep the engine
0 With the parking brake applied, place the shift lever
running.
in
PARK (P).
0 With your foot on the brake pedal, move the shift
lever through each gear range, pausing for about
three seconds in each range. Then, position the shift
lever in
PARK (P).
0 Let the engine run at idle for three minutes or more.
Then, without shutting
off the engine, follow
these steps:
3800 L36 Engine Transmission Dipstick
6-21
ProCarManuals.com

5.7L LT1 Engine Transmission Dipstick-
back
of the engine. Pull out the dipstick and wipe it
with a clean rag or paper towel.
then pull it back out again.
1. The transaxle fluid handle is the red loop near the
2. Push it back in all the way, wait three seconds and
5.7L LT1 Engine Transmission Dipstick
The fluid level
must be in the COLD area for a cold
check QT in the HOT area or cross hatch area for a
hot check.
L 33
ProCarManuals.com

3800 L36 Engine Transmission Dipstick
3. Check both sides of the dipstick, and read the lower
level. The fluid
level must be in the COLD area for a
cold check or in the HOT area or cross-hatched area
for a hot check.
4. If the fluid level is in the acceptable range, push the
dipstick back in all the way.
How to Add Fluid
Refer to the Maintenance Schedule to determine what
kind
of transmission fluid to use. See “Recommended
Fluids and Lubricants” in the Index.
Add fluid only after checking the transmission fluid
HOT. (A COLD check is used only as a reference.) If
the fluid level is low, add only enough
of the proper
fluid to bring the level up
to the HOT area for a hot
check. It doesn’t take much fluid, generally less than a
pint
(0.5 L). Don’t overfill. We recommend you use only
fluid labeled DEXRON@-111, because fluid with that
label
is made especially for your automatic transmission.
Damage caused by fluid other
than DEXRON-111 is not
covered by your new vehicle warranty.
0 After adding fluid, recheck the fluid level as
described under “How to
Check.”
0 When the correct fluid level is obtained, push the
dipstick back in all the way.
ProCarManuals.com