1996 FORD WINDSTAR fuel cap

72
*
[LG02500(ALL)05/95]
Under certain conditions, the Check Engine Warning Light may
come on if the fuel cap is not properly installed. If the Check
Engine Warning Light comes on and you suspect that the fuel
cap is not properly installed, pull off the road as soon as it is
safely possible and turn off the engine. Remove and replace the
cap, making sure it is properly seated.
*
[LG02600(ALL)05/95]
After completing the three consecutive warm up cycles and on
the fourth engine start up, the Check Engine Warning Light
should turn off. If the light does not go off after the fourth
engine re-start, have your vehicle serviced by your dealer or a
qualified technician.
%*
[LG02700(ALL)01/95]
Charging System Light
[LG02801(ALL)11/93]
This light indicates that your battery is not being charged. The
light comes on briefly during the display self-test every time
you turn your ignition key to the ON position. The light will go
off when the key is turned to the START position. The light
should stay off when the self-test is done if the engine is
running and the alternator is charging.
*
[LG03100(ALL)01/95]
If the light stays on or comes on when the engine is running,
have the electrical system checked as soon as possible.
[LG03150(ALL)02/94]
6 pica art:0050149-B
The charging system light
File:wnlgs.ex
Update:Tue Mar 19 08:25:03 1996

Warning Lights and Gauges
87
*
[LG10962(ALL)05/95]
If the light turns on and off on rare occasions while you are
driving, it means that a malfunction occurred and the condition
corrected itself.
*
[LG10965(ALL)05/95]
An example of a condition which corrects itself occurs when an
engine running out of fuel begins to misfire. In this case, the
Check Engine Warning Light may turn on and will then set a
Diagnostic Trouble Code indicating that the engine was
misfiring while the last of the fuel was being consumed. After
refueling, the Check Engine Warning Light will turn off after
the vehicle has completed three consecutive warm up cycles
without a misfire condition occurring. A warm up cycle consists
of engine start from a cold condition (engine at ambient
temperature) and running until the engine reaches normal
operating temperature.
*
[LG10968(ALL)05/95]
On the fourth engine start up, the Check Engine Warning Light
will turn off as soon as the engine begins to crank. It is not
necessary to have the engine serviced.
[LG10969(ALL)02/95]
Under certain conditions, the Check Engine Warning Light may
come on if the fuel cap is not properly installed. If the Check
Engine Warning Light comes on and you suspect that the fuel
cap is not properly installed, pull off the road as soon as it is
safely possible and turn off the engine. Remove and replace the
fuel cap, making sure it is properly seated.
[LG10970(ALL)02/95]
After completing three (3) consecutive warm up cycles and on
the fourth engine start up, the Check Engine Warning Light
should turn off. If the light does not go off after the fourth
engine re-start, have your vehicle serviced by your dealer or a
qualified technician.
File:wnlgs.ex
Update:Tue Mar 19 08:25:03 1996

94indicate at the top of the NORMAL band. This is also
acceptable.
[LG11700(ALL)04/95]
If, under any circumstances, the bars move above the NORMAL
band, the temperature symbol will flash and a chime will sound
to alert the driver that the engine coolant is overheating and
continued operation may cause engine damage.
*
[LG11800(ALL)01/95]
If your engine coolant overheats:
*
[LG11900(ALL)03/95]1.
Pull off the road as soon as it is safely possible.
*
[LG12000(ALL)03/95]2.
Turn off the engine. If you do not stop the engine as soon as
safely possible, severe engine damage could result.
*
[LG12100(ALL)05/95]3.
Let the engine cool.DO NOT REMOVE COOLANT
SYSTEM FILL CAP UNTIL THE ENGINE IS COOL.
[LG12200(ALL)11/93]4.
Check the coolant level following the instructions on
checking and adding coolant to your engine in this Owner
Guide. Seeengine coolantin the index. If you do not follow
these instructions, you or others could be injured.
*
[LG12300(ALL)01/95]
If the coolant continues to overheat, have the coolant system
serviced.
[LG12400(ALL)06/94]
If the temperature gauge displays only the top two and bottom
two bars, the temperature indication system is indicating that it
requires servicing. Take the vehicle to a dealership for service as
soon as possible.
%*
[LG12600(ALL)01/95]
Fuel Gauge
[LG12700(ALL)03/94]
The fuel gauge displays approximately how much fuel you have
in the fuel tank. The number of bars illuminated in the display
indicates fuel level. Your ignition must be in the ON position to
read the fuel gauge. Read the fuel level at the top bar that is lit.
When only one bar on the gauge is lit, the fuel pump symbol
on the gauge will flash to warn you of a low fuel level
condition.
File:wnlgs.ex
Update:Tue Mar 19 08:25:03 1996

Instrument Panel Controls
109
[IP01775(ALL)05/95]
The air conditioning settings include MAX A/C, A/C andS
(Panel/Floor). However, heating capabilities are also provided in
these modes. Adjust the Temperature Control Knob as necessary
to receive cool (air-conditioned) or warm (heated) air when in
these modes.
[IP01780(ALL)06/94]
NOTE: The A/C compressor will only operate when outside
air temperatures are above approximately45ÊF (7ÊC).
[IP01785(ALL)06/94]
The climate control system provides fresh outside air in all
function control settings except for MAX A/C andm(OFF).
Only recirculated interior air is available in MAX A/C.
[IP01791(ALL)04/95]
InMAX A/C, air from inside the passenger compartment is
recirculated continuously and the A/C compressor is engaged.
In this position, the system provides maximum cooling,
maximum dehumidifying, and greater fuel efficiency. It also has
a greater noise level because the sound of the air from the
blower motor is not muffled by a closed damper door as it
would be in all other functional settings.
[IP01802(ALL)04/95]
InA/C, outside air is drawn into the system and the A/C
compressor is engaged. The cooling process and the distribution
of cooled air is the same as that provided with MAX A/C.
Because outside air is drawn into the system, it will not have
the advantage of cooling already cooled air. It will have a lower
noise level because a closed damper door muffles the sound of
the air from the blower motor.
[IP01812(ALL)06/94]
InQ(PANEL), air is drawn from the outside and directed into
the passenger compartment through the instrument panel
registers. The temperature of the air can be varied by adjusting
the Temperature Control Knob. This mode is normally used as a
vent setting. The A/C compressor does not operate in this
mode, only heating capabilities are provided.
File:wnips.ex
Update:Tue Mar 19 08:23:17 1996

250
*
[DR13700(ALL)01/93]
Vehicle Loading Information
*
[DR13800(ALL)04/95]
Your vehicle's load capacity is designated by weight, not
volume, so you cannot necessarily use all the available space.
Maximum safe vehicle weights as well as tire sizes, rim sizes
and inflation pressures are specified for your vehicle at the
assembly plant on the Safety Compliance Certification Label.
The certification label is located on the pillar in the driver's
door opening.
*
[DR13900(ALL)01/93]
Each additional item of equipment affects how much cargo a
vehicle can carry. If a vehicle is overloaded, performance will
suffer and service concerns may arise.
*
[DR14200(ALL)01/93]
NOTE: The vehicle must not be loaded to both the front and
rear GAWR because the GVWR will be exceeded. The
GAWR of the front and rear axles exceed the GVWR
when added together.
*
[DR14500(ALL)01/93]
Understanding Loading Information
*
[DR14600(ALL)01/93]
There are five terms that are used to describe a vehicle's ability
to carry a load:
*
[DR14700(ALL)01/93]
n
Base Curb Weight
*
[DR14800(ALL)01/93]
n
Payload
*
[DR14900(ALL)01/93]
n
GVW (Gross Vehicle Weight)
*
[DR15000(ALL)01/93]
n
GVWR (Gross Vehicle Weight Rating)
*
[DR15100(ALL)01/93]
n
GAWR (Gross Axle Weight Rating)
*
[DR15200(ALL)06/92]
n
GCWR (Gross Combined Weight Rating)
*
[DR15300(ALL)01/93]
Base Curb Weight
*
[DR15400(ALL)04/95]
The base curb weight is the weight of the vehicle including fuel,
coolants, lubricants, emergency tools and spare wheel and tire.
It also includes any equipment that is standard. It does not
include passengers, cargo or optional equipment installed by
factory, dealer, aftermarket supplier or customer.
File:wndrs.ex
Update:Tue Mar 19 08:18:48 1996

252
*
[DR16500(ALL)01/93]
The rating is based on the carrying capacity of the weakest axle
and suspension component as well as other factors. This is why
it is so important to observe vehicle loading ratings.
Overloading a vehicle punishes components and can lead to
shortened service life or outright failure.
*
[DR16600(ALL)01/93]
The weakest link in the suspension system defines the GAWR,
and may be the tires. Tires are rated to carry a specific
maximum load at a specific tire pressure.
*
[DR16700(ALL)01/93]
When passenger car tires are installed on light trucks and
multipurpose passenger vehicles, they are rated at a 10% lower
load carrying capacity due to the differences in vehicle usages.
*
[DR16800(ALL)01/93]
With the tires inflated to the specified pressure, the total weight
of your vehicle must not exceed the GVWR and GAWR
specified on the Safety Compliance Certification Label. This
includes full fuel tank(s), vehicle equipment, and occupants, as
well as the cargo load.
*
[DR16900(ALL)05/93]
Gross Combined Weight Rating (GCWR)
*
[DR17000(ALL)01/93]
The GCWR is the maximum allowable weight of the towing
vehicle and the loaded trailer (including all cargo and
passengers).
File:wndrs.ex
Update:Tue Mar 19 08:18:48 1996

308
*
[SV05100(ALL)03/95]
What to Check When You Stop at a Service
Station
%*
[SV05200(ALL)03/95]
Filling Your Fuel Tank With Fuel
[SV05750(ALL)11/93]1.
Open the fuel door (located on the driver's side of the
vehicle).
[SV05800(ALL)11/93]2.
Unscrew the fuel cap by exerting pressure on the plastic cap
and rotating the fuel cap counterclockwise.
[SV05900(ALL)11/93]3.
Turn the fuel cap 3/4 of a turn until a hissing sound is
heard. Wait until the hissing sound stops and then continue
rotating counterclockwise to remove the fuel cap.
[SV06000(ALL)11/93]4.
Follow the fuel cap removal instructions and use caution to
minimize the possibility of fuel spraying when you unscrew
the cap.
*
[SV06050(ALL)05/95]
RWARNING
If the fuel cap is venting vapor or if you hear a hissing
sound, wait until it stops before completely removing the
cap.
[SV06060(ALL)04/95]
RWARNING
Turn the fuel cap 3/4 of a turn to relieve any pressure
and vacuum in the fuel tank. The cap will start
unthreading after 3/4 of a turn.
File:wnsvs.ex
Update:Tue Mar 19 08:16:43 1996

Servicing Your Windstar
309
[SV06100(ALL)09/93]
10-1/2 pica
art:0050054-A
The fuel door
*
[SV06200(ALL)01/93]
To replace and secure the fuel cap, place it in position and
rotate it clockwise until it clicks (ratchets). The ratcheting
mechanism allows the fuel cap to be sealed without
overtightening.
[SV06290(ALL)05/95]
If you lose the fuel cap, replace it with an authorized Motorcraft
or equivalent part.
%*
[SV06300(ALL)05/95]
RWARNING
If you do not use the proper fuel cap, the pressure in the
fuel tank can damage the fuel system or cause it to work
improperly in a collision.
*
[SV06600(ALL)01/95]
NOTE: If you replace your fuel cap with an aftermarket fuel
filler cap, the customer warranty may be void for any
damage to the fuel tank and/or fuel system.
File:wnsvs.ex
Update:Tue Mar 19 08:16:43 1996