1996 FORD WINDSTAR warning

Instrument Panel Controls
123
*
[IP13300(ALL)05/95]
RWARNING
The Daytime Running Light (DRL) system will not
illuminate the tail lamps and parking lamps. Turn on
your headlamps at dusk. Failure to do so may result in a
collision.
%*
[IP13320(ALL)02/95]
Setting the Autolamp Delay System (If equipped)
[IP13340(ALL)04/95]
By using the autolamp, you can set the headlamps to:
*
[IP13350(ALL)09/93]
n
turn on the headlamps automatically at night
*
[IP13360(ALL)09/93]
n
turn off the headlamps automatically during daylight
[IP13370(ALL)09/93]
n
keep the headlamps on for up to three minutes after you
turn the key to OFF.
[IP13380(ALL)10/93]
10-1/2 pica
art:0050157-A
The autolamp system
File:wnips.ex
Update:Tue Mar 19 08:23:17 1996

Steering Column Controls
133
*
[SC03900(ALL)01/93]
RWARNING
In freezing weather, the washer solution may freeze on
the windshield and obscure your vision. Always warm
up the windshield with the defroster before you use the
washer fluid. If you cannot see through the windshield
clearly, it can increase the risk of being involved in a
collision.
*
[SC04000(ALL)04/95]
For information about refilling the washer fluid or replacing
your windshield wiper blades, seeWindshield washer fluid and
Wipersin the Index.
%*
[SC04100(ALL)01/93]
Gearshift Lever
[SC04200(ALL)06/94]
The gearshift lever on your vehicle is mounted on the steering
column. On the end of the gearshift lever is the Overdrive
On/Off button and the OVERDRIVE OFF lamp. For additional
information about the gearshift lever and the Overdrive On/Off
button, see theDriving Your Vehiclechapter.
[SC04300(ALL)09/93]
13-1/2 pica
art:0050016-A
The gearshift lever
File:wnscs.ex
Update:Tue Mar 19 08:22:27 1996

Steering Column Controls
139
[SC09010(ALL)05/95]
NOTE: On a downhill grade, if your speed increases above
your set speed while driving inj(Overdrive) on a
downhill grade, you may want to downshift to Third
(3) gear to reduce vehicle speed. To do this, push the
Overdrive ON/OFF button on the end of the gearshift
lever. The OVERDRIVE OFF lamp will illuminate
when you press the switch.
[SC09020(ALL)05/95]
You may want to drive in 3 (Third) when driving in hilly
terrain, at high altitudes, or when pulling a trailer. This will
improve speed control performance.
[SC09030(ALL)06/94]
NOTE: When driving uphill, especially with a heavy load,
you may notice your speed decreasing even if you
have the speed control set. If the speed drops more
than 8 to 14 mph (13-23 km/h) it is normal for the
automatic speed control feature to be cancelled. You
may need to use the accelerator pedal to help your
vehicle maintain the selected speed when driving up
steep grades.
*
[SC09100(ALL)05/95]
RWARNING
Do not use the speed control in heavy traffic or on roads
that are winding, slippery, or unpaved.
[SC09200(ALL)09/93]
Accelerating With the Speed Control On
[SC09300(ALL)03/94]
If you want to speed up momentarily, or regain preset speed on
hills when the speed control is on, accelerate using the
accelerator pedal. Manually accelerating to a higher speed does
not interfere with the speed control. When you take your foot
off the accelerator, your vehicle returns to the set speed.
File:wnscs.ex
Update:Tue Mar 19 08:22:27 1996

Features
159
[FV09935(ALL)11/93]
Make certain that you close the liftgate door before driving your
vehicle. Possible damage may occur to the liftgate door lift
cylinders and attaching hardware if the liftgate door is not
closed prior to driving.
[FV09940(ALL)05/95]
RWARNING
Make sure that the liftgate door is closed to prevent
exhaust fumes from being drawn into the vehicle. This
will also prevent passengers and cargo from falling out.
If you must drive with the liftgate door open, keep the
vents open so outside air comes into the vehicle.
*
[FV09950(ALL)01/89]
Liftgate closing procedure
*
[FV09960(ALL)01/89]1.
To make the liftgate swing downward, reach up and pull the
lower edge of the liftgate (or the loop handle on the inner
trim panel of vehicles with this option) and pull downward.
*
[FV09970(ALL)01/89]2.
When you have pulled down the liftgate enough so that you
can reach the license plate light shield, push the shield down
and forward to close the latch and liftgate. At this point, the
latch is not locked.
[FV09980(ALL)03/94]3.
You can lock the liftgate latch by pushing down the
night-lock button (located on the inside of the liftgate at the
bottom of the window) before you pull down and close the
liftgate. You can also lock the liftgate latch by inserting your
vehicle's door key and turning it counterclockwise after you
have closed the liftgate, or by using the power door locks on
the front doors or the power lock switch in the cargo area.
*
[FV09990(ALL)12/93]
The liftgate area is only intended for cargo, not passengers. You
can open and close the liftgate from outside the vehicle. It
cannot be opened from inside the cargo area.
File:wnfvs.ex
Update:Tue Mar 19 08:21:54 1996

160
%*
[FV10050(ALL)02/95]
Windows
[FV10300(ALL)10/93]
Power Windows with Accessory Delay (If equipped)
[FV10400(ALL)11/93]
Both of the front doors have a power control that opens and
closes the window on that door. The driver's door has master
controls that operate both front door windows. You must
initially place the ignition switch in the ON or ACC position to
use your power window controls. The Accessory Delay function
also allows the power windows to be operated for up to 30
seconds after the ignition key is removed or taken out of the
ON or ACC position. Accessory Delay will be cancelled,
however, if either of the front doors are opened.
[FV10500(ALL)03/94]
To open a window, press the recessed area of the switch. To
close it, press the raised area of the switch.
*
[FV10600(ALL)05/95]
RWARNING
Do not let children play with the power windows. They
may seriously hurt themselves. Make sure occupants are
clear of the window(s) before closing.
[FV10700(ALL)11/93]
10-1/2 pica
art:0050030-B
The power window switches
File:wnfvs.ex
Update:Tue Mar 19 08:21:54 1996

Features
163
[FV11800(ALL)09/93]
10-1/2 pica
art:0050034-A
The power quarter window switches
%*
[FV13000(ALL)01/95]
Seats
*
[FV13100(ALL)01/95]
Adjusting the Seats
[FV13150(ALL)03/94]
Adjusting the front seats manually
*
[FV13200(ALL)04/95]
To move the front seats forward or backward:
[FV13300(ALL)09/93]1.
Find the adjustment bar at the lower cushion of the front
seat.
[FV13400(ALL)10/93]2.
Pull the bar up to unlatch the seat.
*
[FV13500(ALL)04/95]3.
Move the seat to the desired position.
[FV13600(ALL)10/93]4.
Release the bar to latch the seat in its new position. Make
sure the seat locks securely in place.
*
[FV13900(ALL)05/95]
RWARNING
Never adjust the driver's seat or seatback when the
vehicle is moving.
File:wnfvs.ex
Update:Tue Mar 19 08:21:54 1996

164
*
[FV14000(ALL)05/95]
RWARNING
Do not pile cargo higher than the seatbacks to avoid
injuring people in a collision or sudden stop.
*
[FV14025(ALL)05/95]
RWARNING
To reduce the risk of serious injury in a collision, always
drive and ride with your seatback upright and the lap
belt snug and low across the hips.
*
[FV14050(ALL)05/95]
RWARNING
To reduce the risk of serious injury in a collision,
children should always ride with the seatback upright.
[FV14075(ALL)02/96]
Tip Slide Seat (If equipped)
[FV14085(ALL)02/96]
This feature allows convenient access into the second row seats
through the driver's door.
[FV14090(ALL)02/96]
To operate the tip slide seat:
[FV14095(ALL)02/96]1.
Lift the tip slide release lever located at the base of the
driver's seatback. The seatback tilts forward and the tip slide
seat latch mechanism is released.
File:wnfvs.ex
Update:Tue Mar 19 08:21:54 1996

Features
167
[FV14125(ALL)02/96]
7-1/2 pica art:0050292-A[FV14130(ALL)02/96]2.
Continue pushing to return the seatback to its previously
locked position.
[FV14135(ALL)02/96]
NOTE: When returning the seatback to its original position,
you may experience a slight hesitation. If so, stop
pushing the seatback momentarily, then resume. The
seatback will only return to its original position after
the seat is safely latched.
[FV14140(ALL)02/96]
Your Windstar tip slide seat has been equipped with a lock-out
safety feature which prevents the seatback from returning to its
original position until the seat pedestal latches in the tracks. If
the seat has not latched check under the seat and in the rear
tracks for possible obstructions.
[FV14145(ALL)02/96]
RWARNING
DO NOT DRIVE THE VEHICLE WITH THE TIP SLIDE
SEAT UNLATCHED.
[FV14150(ALL)02/96]
To move the seat forward or backward:
[FV14155(ALL)02/96]1.
Find the adjustment bar underneath the front part of the
seat.
[FV14160(ALL)02/96]2.
Lift the bar to unlatch the seat.
File:wnfvs.ex
Update:Tue Mar 19 08:21:54 1996