1996 FORD ASPIRE maintenance

232
*
[SV48700(ALL)02/92]
Never use a metal exhaust collector when you
service your vehicle. If the metal collector
contacts any of your vehicle's plastic trim or
bumper parts they could melt or deform.
*
[SV48800(ALL)01/95]
Do not drive your vehicle if it does not operate
properly. See your dealer if the engine runs on
for more than five seconds after you shut it off
or if it misfires, surges, stalls, or backfires.
%*
[SV48900(ALL)05/95]
Information about your vehicle's emission
control system is on the Vehicle Emission
Control Information decal located on or near the
engine. This decal identifies engine displacement
and gives some tune-up specifications.
%*
[SV48910(ALL)07/95]
Readiness for Inspection/Maintenance
Testing
*
[SV48920(ALL)07/95]
In some localities it may become a legal
requirement to pass an Inspection/
Maintenance (I/M) test of the On-Board
Diagnostic (OBD) II system. If the vehicle's
powertrain system or its battery has just been
serviced, the OBD II system is reset to a not
ready for I/M testing condition. To prepare for
I/M testing, the law specifies a ªneed for
additional mixed city and highway driving to
complete the checkº of the OBD II system. As
soon as all of the OBD II system checks are
successfully completed, the OBD II system is set
to the ready condition. The amount of driving
required to reach the ready condition varies with
individual driving patterns. To complete this
requirement in the minimum amount of time,
refer to the OBD II Drive Cycle defined below. If
the vehicle owner cannot or does not want to do
the additional driving required by law, a service
center can perform this drive cycle as it would
any other type of repair work.
File:15icsvf.ex
Update:Wed Jan 24 14:56:41 1996

235
*
[SV49500(ALL)05/95]
Motorcraft Parts
[SV49800(ALL)05/94]
twelve pica chart:0030288-H*
[SV49900(ALL)01/89]
Lubrication Specifications
*
[SV50000(ALL)07/93]
The transaxle and steering systems in your
vehicle are filled at the factory with high-quality,
long-lasting lubricants or fluids that do not
require periodic draining or refilling except
under severe-duty conditions. However, when
refilling or adding is required, it should be with
the proper lubricant or fluid meeting Ford
technical specifications. See theMaintenance
Schedule and Recordbooklet for instructions on
maintaining proper fluid levels.
File:15icsvf.ex
Update:Wed Jan 24 14:56:41 1996

238
*
[SV50700(ALL)01/95]
Vehicle Storage
*
[SV50800(ALL)01/95]
Maintenance Tips
*
[SV50900(ALL)01/95]
If you plan on storing your vehicle for an
extended period of time (60 days or more), refer
to the following maintenance recommendations
to ensure your vehicle stays in good operating
condition.
*
[SV51000(ALL)01/95]
General
*
[SV51100(ALL)01/95]
q
Store all vehicles in a dry, ventilated place.
*
[SV51200(ALL)01/95]
q
Protect from sunlight, if possible.
*
[SV51300(ALL)01/95]
q
If vehicles are stored outside, they require
regular maintenance to protect against rust
and damage.
*
[SV51400(ALL)01/95]
Body
*
[SV51500(ALL)01/95]
q
Wash vehicle thoroughly to remove dirt,
grease, oil, tar or mud from exterior surfaces,
rear wheel housing and underside of front
fenders.
*
[SV51600(ALL)01/95]
q
Periodically wash vehicles stored in exposed
locations.
*
[SV51700(ALL)01/95]
q
Touch-up raw or primed metal to prevent
rust.
*
[SV51800(ALL)01/95]
q
Cover chrome and stainless steel parts with a
thick coat of auto wax to prevent
discoloration. Re-wax as necessary when the
vehicle is washed.
*
[SV51900(ALL)04/95]
q
Lubricate all hood, door and trunk lid hinges
and latches with a light grade oil.
*
[SV52000(ALL)01/95]
q
Cover interior soft trim to prevent fading.
*
[SV52100(ALL)01/95]
q
Keep all rubber parts free from oil and
solvents.
File:15icsvf.ex
Update:Wed Jan 24 14:56:41 1996