TRIMS OF OPENINGS OTHER THAN SIDE DOORS
Exterior hood trim
Fold the hood in its housing.
Immobilise the hood cover in the case of the elec-
trohydraulic model.
73
PRE7301
RR R R
EE E E
MM M M
OO O O
VV V V
AA A A
LL L L
Before carrying out any work, protect the seats
and the rear wings.
Open the hood, raise the front section beyond the
pushing point (neutral position).
Remove the front frame cover clamps.Unscrew the pin (1) and remove the locking han-
dle.
Unclip and remove the cover.
12431S
12432R
73-1
INTERIOR BODY TRIM
Headlining
71B
After removing the front and rear head restraints,
protect the seats and remove:
- the four door seals,
- the boot seal,
- the windscreen pillar linings (A),
- the upper centre pillar linings (B),
- the front rear quarter panel linings (C) (see
section 71C),
- the rear rear quarter panel linings (D) (see sec-
tion 71D),
- the sun visors and their retaining clips,
- the grab handles and their blanking plugs for
the driver’s position,
- the roof console (E),
- the courtesy lights,
- the rear speaker grilles (F),
- the tailgate mounting plugs (G),
- the centre retaining clip (H),
- the third rear seat belt (see section 59B).
INTRODUCTION
This headlining is bonded to the roof using a single pot adhesive used for bonding windows.
The rear side edges of the headlining are held in place with velcro (1).
REMOVAL
PRE7113
PRE7114
71-2
