1995 PONTIAC FIREBIRD Owners Manual

Installing the Boot Cover
After lowering the convertible top, you may want to
install the boot cover. The three-piece boot cover is
stored
in a bag in the trunk.
3. Be sure no one or nothing is on or around the top.
Push and hold the bottom
of the convertible top
switch. The switch
is on the left side of your console.
The top will automatically lower into the storage
area.
1. Open the trunk and remove the two side covers from
the storage bag.
2. Install the two side covers by engaging the tab into
the front seatbelt cover. Lower the covers onto the
car.
2-82
ProCarManuals.com

To Raise Your Convqtible Top
1. Park on a level surface. Set the parking brake firmly.
If you have an automatic transmission, shift into
PARK (P). If you have a manual transmission, shift
into
REVERSE (R). The ignition must be in the
ACC or RUN position. Lower both sun visors.
Lower both windows at least three inches.
If the boot
cover is in place, it must be removed first.
3. Insta the middle section of the cover by sliding the
tabs ilifo the slots on right side cover. Lower the
cover and engage latch.
4. Close the trunk.
2. Open the trunk. Remove the middle piece of the
cover by pushing in on the latch and lifting up on the
cover.
2-83
ProCarManuals.com

3. Remove the two side pieces of the boot cover by
lifting the rear cover and sliding them out of their
slots.
4. Store each piece of the cover in its separate
compartment in the storage bag. Store in the trunk
and close the trunk.
2-84
ProCarManuals.com

5. Push and hold
the top of the
convertible top switch. ~~~
6. Pull down on the latches and align hooks with
holes.
hsh forward on the larger part of the latch until it
clicks.
Do not force the latch. If it is hard to lock, the
top is not properly aligned.
If your vehicle suffers a power loss, such as a dead
battery, you
can still raise or lower the top manually by
rotating the valve in the left side of the
trunk.
Open the trunk and find the tab along the left side trim
panel. Lift up the tab and turn the valve clockwise to
release the hydraulic pressure.
Turn the ignition key to
the
LOCK position. You can now raise or lower your top
manually. Be
sure to close the valve after installing your
top
so you can raise or lower it electronically later.
2-85
ProCarManuals.com

NOTES
2-86
ProCarManuals.com

Section 3 Comfort Controls and Audio Systems
In this section you’ll find out how to operate the comfort \
control systems and audio systems offered with your
Pontiac. Be sure to read about the particular system
supplied with your vehicle.
Comfort Controls
With this system, you can control the heating and ventilation in your Pontiac. If you have the air
conditioning option, you can also control cooling.
Your vehicle also has the flow-through ventilation
system described later in this section.
Heater Controls
Fan Control Knob
* FAN: Turn this knob to select the force of air
you want.
Temperature Control Knob
Turn the knob to change the temperature of the air flowing
from the heating system. Turn it to the right for warmer
air
and to the left for cooler air. The temperature of the air can
not be less than the temperature of the outside
air.
Air Control Knob
OFF:
The system is off.
4.
~9 BI-LEVEL: Air is directed through the upper air d.
vents and the heater ducts.
9 VENT: Air flows through the upper air vents.
3-1
ProCarManuals.com

d HEATER: This setting directs most of the air
through the heater ducts and some of the air through the
windshield defroster vents.
z2 BLEND: Air is directed through the windshield
defroster vents and the heater ducts.
9 DEFROST: This setting directs most of the air
through the windshield defkoster vents and some of the
air through the heater ducts.
Heating
The heater works best if you keep your windows closed
while using it.
1. Turn the air control knob to HEATER.
2. Turn the fan control knob to the desired speed.
3. Turn the temperature control knob to a comfortable
During initial start-up only, if your vehicle is equipped
with an optional engine coolant heater, you can use it in
cold weather (around
+20 O F/-8 O C or lower) to improve
heater performance on
start up. Because an engine
coolant heater warms the engine coolant, your vehicle’s
setting.
heating system can more efficiently provide heat for the
passenger area of
your vehicle. See “Engine Coolant
Heater” in the Index.
Bi-Level Heating
You may want to use bi-level heating on cool, but sunny
days. This setting directs cool air toward your body and
warmer air toward your feet.
1. Turn the air control knob to BI-LEVEL.
2. Turn the temperature control knob to a comfortable
3. Turn the fan control knob to the desired speed.
Ventilation
For mild outside temperatures when little heating or
cooling
is needed, you can still direct outside air through
your vehicle.
1. Turn the air control knob to VENT.
2. Turn the temperature control knob to a comfortable
3. Turn the fan control knob to the desired speed.
setting.
setting.
3-2
ProCarManuals.com

Defogging and Defrosting the Windshield
1. Turn the air control knob to DEFROST.
2. Turn the temperature control knob to the desired
setting.
3. Turn the fan control knob to the desired speed.
Air Conditioner Controls (Option)
The air conditioning system uses the same controls as the
heating system, except that the
slir control knob has two
extra settings, described below. For an explanation of all
the controls, see “Heater Controls” earlier in this part.
MAX: Provides maximum cooling or quick cool-down
on very hot days.
This setting recirculates most of the air
inside your vehicle. If it is used for long periods of time,
the
air may become dry. This setting directs air through
the upper air vents.
A/C: Use for normal cooling on hot days. This setting
cools outside
air and directs it through the upper air vents.
The air conditioner compressor operates in MAX, A/C,
BI-LEVEL, BLEND and DEFROST when the outside
temperature is above freezing. When the
air conditioner
is on, you may sometimes notice slight changes in your
vehicle’s engine speed and power.
This is normal because
the system is designed to cycle the compressor on and
off
to keep the desired cooling and help fuel economy.
Cooling
The air conditioner works best if you keep your
windows closed. On very hot days, open the windows
just long enough for the hot air to escape.
1. Turn the air control knob to A/C for normal cooling.
For faster cooling move the knob to MAX.
2. Turn the temperature control knob to a comfortable
3. Move the fan cdfitrol knob to the desired speed.
setting.
3-3
ProCarManuals.com