1995 PONTIAC FIREBIRD Owners Manual

r
NOTICE:
Engine damage from running your engine without coolant isn’t covered by your warranty.
If there seems to be no leak, check to see if the electric
engine fans are running.
If the engine is overheating,
both fans should be running.
If they aren’t, your vehicle
needs service.
How to Add Coolant to the Coolant
Recovery Tank
If you haven’t found a problem yet, but the coolant level
isn’t at
FWLL COLD, add a 50/50 mixture of clean
water (preferably distilled) and a proper antifreeze at the
coolant recovery tank. (See “Engine Coolant”
in the
Index for more information about the proper coolant
mix.)
ProCarManuals.com

NOTICE:
In cold weather, water can freeze and crack the
engine, radiator, heater core and other parts. Use the recommended coolant.
I I
engine parts. Coolant contains ethylene gly
and it will burn if the engine narts arp hnt
When the coolant in the coolant recovery tank is at
WLL COLD, start your vehicle.
If the overheat warning continues, there’s one more
thing you can
try. You can add the proper coolant mix
directly to the radiator, but be sure the cooling system is 1
cool before you do it.
5-21
ProCarManuals.com

5-22
ProCarManuals.com

How to Add Coolant to the Radiator
(V6 Engines)
2. Then keep turning the pressure cap, but now push
down as you turn it. Remove the pressure cap.
1. You can remove the radiator pressure cap when the
cooling system, including the radiator pressure cap
and upper radiator hose, is no longer hot. Turn the
pressure cap slowly to the left until it first stops.
(Don’t press down while turning the pressure cap.)
If you hear a hiss, wait for that to stop. A hiss means
there is still some pressure left.
5-23
ProCarManuals.com

3. Fill the radiator with the proper mix, up to the base
of the filler neck.
4. Then fill the coolant recovery tank to mJLL COLD.
5-24
ProCarManuals.com

5. Put the cap back on the coolant recovery tank, but
leave the radiator pressure cap off.
6.
7.
Start the engine and let it run until you can feel the
upper radiator hose getting hot. Watch out for the
engine fan(
s) .
By this time the coolant level inside the radiator
filler neck may be lower.
If the level is lower, add
more
of the proper mix through the filler neck until
the level reaches the base of the filler neck.
5-25
ProCarManuals.com

How to Add Coolant to the Radiator - LTl
(Code P) Engine Only
NOTICE:
The LTl Engine (Code P) has a specific radiator
fill procedure. Failure to follow this procedure
could cause your engine to overheat and be
severely damaged.
8. Then replace the pressure cap. At any time during
this procedure
if coolant begins to flow out of the
filler neck, reinstall the pressure cap. Be sure the
arrows on the pressure cap line up like this.
5-26
ProCarManuals.com

1. You can remove the radiator pressure cap when the
cooling system, including the radiator pressure cap and upper radiator hose, is no longer hot.
Turn the
pressure cap slowly to the left until it first stops. (Don’t press down while turning the pressure cap.)
If you hear a hiss, wait for that to stop. A hiss means
there is still some pressure left.
2. Then keep turning the pressure cap, but now push
down as you
turn it. Remove the pressure cap. 3. After the engine cools, open the air bleed valves on
the heater return hose and water pump inlet.
5-27
ProCarManuals.com