1995 CADILLAC ELDORADO check engine light

Downloaded from www.Manualslib.com manuals search engine AIR BAG
There is an air bag readiness light on the instrument panel, which shows
AIR
BAG. The system checks the air bag’s electrical system for
malfunctions.
The light tells you if there is an electrical problem. See “Air
Bag Readiness Light”
in the Index for more information.
How the Air Bag System Works
.A
1-24

Downloaded from www.Manualslib.com manuals search engine If a door or the trunk is opened without the key or Keyless Entry System,
the alarm will
go off. It will also go off if the trunk lock is damaged. Your
vehicle’s lights will flash and the horn will sound
for three minutes and
then the alarm will
go off to save battery power.
Remember, the theft deterrent system won’t arm
if you lock the doors
with
a key or use the manual door lock. It arms only if you use a power
door lock switch or the Keyless Entry System.
Here’s how to avoid setting
off the alarm by accident:
If you don’t want to arm the theft deterrent system, the vehicle should
Always unlock a door with a key, or use the Keyless Entry System.
be locked with the door key after the doors are closed.
Unlocking
a door any other way will set off the alarm.
If you set off the alarm by accident, unlock any door with your key. You
can also turn
off the alarm by using the Keyless Entry System. The alarm
won’t stop
if you try to unlock a door any other way.
How to Test the Alarm
e From inside the vehicle roll down your window, then get out of your
vehicle, keeping the door open.
0 From outside the vehicle with the door open, lock the vehicle using the
Reach in and unlock the door using the manual lock and open the
power
door lock or the Keyless Entry System and close the door.
door. The horn will sound and your headlamps will flash.
If the alarm does not sound when it should, check to see if the horn
works. The horn fuse may be blown.
To replace the fuse, see “Fuses and
Circuit Breakers” in the Index.
If the fuse does not need to be replaced
you may need to have
your Cadillac serviced.
To reduce the possibility of theft, always arm the theft deterrent system
when leaving your vehicle.
2-16

Downloaded from www.Manualslib.com manuals search engine PASS-KEY’II
I Your vehicle is equipped with the PASS-Key@II (Personalized Automotive
Security System) theft deterrent system. PASS-Key@II is a passive theft
deterrent system. This means
you don’t have to do anything different to
arm
or disarm the system. It works when you insert or remove the key
from the ignition. PASS-Key@II uses
a resistor pellet in the ignition key
that matches a decoder in your vehicle.
When the PASS-Key@II system senses that someone is using the wrong
key, it shuts down the vehicle’s starter and fuel systems. For about three
minutes, the starter won’t work and
fuel won’t go to the engine. If
someone tries to start your vehicle again or uses another key during this
time, the vehicle will not start. This discourages someone from randomly
trying different keys with different resistor pellets in an attempt to make a
match.
The ignition key must be clean and dry before it’s inserted in the ignition
or the engine may not start. If the engine does not start and the
SECURITY light comes on, the key may be dirty or wet. Turn the ignition
off.
Cle2n and dry the key. Wait about three minutes and try again. The
security light may remain
on during this time. If the starter still won’t
work, and the key appears
to be clean and dry, wait about three minutes
and try another ignition key. At this time, you may also want to check the
fuses (see “Fuses and Circuit Breakers” in the Index). If the starter won’t
work with the other key, your vehicle needs service. If your vehicle does
start, the first ignition key may be faulty. See your Cadillac dealer or a
locksmith who can service the PASS-Key%.
If you accidentally use a key that has a damaged or missing resistor pellet,
the starter won’t work and the SECURITY light will flash. But you don’t
have to wait three minutes before trying another ignition key.
See your Cadillac dealer or a locksmith who can service the PASS-Key@II
to have a new key made.
2-17

Downloaded from www.Manualslib.com manuals search engine 2. If it doesn’t start right away, hold your key in START for about three
seconds at a time until your engine starts. Wait about
15 seconds
between each try to help avoid draining your battery.
Your left headlamp and left taillamp may be on as you start your
engine, but the right headlamp and taillamp
won’t. This provides some
light as you start but doesn’t drain your battery as much.
flooded with too much gasoline.
Try pushing your accelerator pedal all
the way to the floor and holding it there as you hold the key in
START
for about three seconds. If the vehicle starts briefly but then stops
again, do the same thing.
3. If your engine still won’t start (or starts but then stops), it could be
NOTICE:
Your engine is designed to work with the electronics in your
vehicle.
If you add electrical parts or accessories, you could
change the way the fuel injection system operates. Before
adding electrical equipment, check with your dealer.
If you
, don’t, your engine might not perform properly.
1 If you ever have to have your vehicle towed, see the part of this
~ See “Towing Your Vehicle” in the Index.
I manual that tells how to do it without damaging your vehicle.
DmNG THROUGH DEEP STANDING
WATER
NOTICE:
If you drive too quickly through deep puddles or standing water,
water can come in through your engine’s air intake and badly
damage your engine. Never drive through water that is slightly
lower than the underbody of your vehicle.
If you can’t avoid
deep puddles
or standing water, drive through them very slowly.
2-2 1

Downloaded from www.Manualslib.com manuals search engine As you signal a turn or a lane change, if the arrows don’t flash but just stay on
a signal bulb may be burned
out and other drivers won’t see your turn signal.
If
a bulb is burned out, rcplacc it to help avoid an accident. If the green
arrows don’t go on at all when you signal
a turn, check the fuse (see
“Fuses’’ in
the Index) and for burned-out bulbs.
Wiper Activated Headlumps
This feature activates the headlamps and parking lamps after the
windshield wipers have been in use
for approximately 23 seconds.
In order
to operate the wiper activated headlamps, the twilight sentinel
must
be in the ON position. This feature lights the way in poor weather
and
it also makes your vehicle more visible to other drivers. If the wiper
activated headlamps are
on, and the ignition switch is turned off, the
wiper activated headlamps
will immediately turn off.
The wiper activated headlamps will deactivate if you turn off the twilight
sentinel
or if the windshield wipers have been turned off for a period of
one or two seconds.
Headlamp High-Low Beam
To change the
headlamps from low
beam
to high or high to
low, pull the turn signal
lever all
the way toward
you. Then releasc it.
When the high beams
are on, this blue
light
on thc instrument
panel
will also be on.
Flash-To-Pass Feature
This lets you use your high beam headlamps to signal a driver in front of
you that you want to pass. It works even if your headlamps are off.
2-40

Downloaded from www.Manualslib.com manuals search engine When one of the warning lights comes on and stays on when you are
driving, check the section that tells you what to do about it. Please follow
this manual’s advice. Waiting to
do repairs can be costly -- and even
dangerous.
So please get to know your warning lights. They’re a big help.
Your vehicle may also have a Driver Information Center that works along
with the warning lights. See “Driver Information Center’’ in the Index.
Safety Belt Reminder Light
c
When the key is turned to RUN or START, a chime will come on for about
eight seconds to remind people to fasten their safety belts. The safety belt
light
will also come on and stay on for about 75 seconds. If the driver’s belt
is already buckled, neither the chime nor the light
will come on.
2-73

Downloaded from www.Manualslib.com manuals search engine Air Bag Readiness Light
There is an air bag readiness light on the instrument panel, which shows
AIR BAG. The system checks the air bag’s electrical system for
malfunctions. The light tells
you if there is an electrical problem. The
system check includes the air
bag sensors and modules, the wiring and the
diagnostic module. For more information
on the air bag system, see “Air
Bag”
in the Index.
You will see this light flash for a few seconds when you turn your ignition
to RUN or START Then the light should go out. This means the system is
ready.
If the air bag readiness light doesn’t come
on when you start your vehicle,
or stays on, or comes on when you are driving, your air bag system may
not work properly. Have your vehicle serviced right away.
2- 74

Downloaded from www.Manualslib.com manuals search engine Engine Temperature Warning Light (Canadian Only)
This light tclls you that
your engine has
overheated. You
should stop the car
and
turn the engine off as
soon as possible. A
warning chime should
also sound if this light
comes on.
As a check, the light should come on for a few seconds when you start
your engine.
HOT COOLANT CAN BURN YOU BADLl’!
In the section “Problems on the Road,” this manual explains what to do.
See “Engine Overheating”
in thc Index.
Mammction Indicator Lamp (Service Engine Soon Light)
I
w
A computer monitors
operation
of your
fuel, ignition and
emission control
systems. One
of these
lights should come
on
when the ignition is
on, but the engine is
not running, as a
check to show you it is
working.
If one of
these lights doesn’t
come
on, have it fixed
right away.
If it stays on or it comes on while you are driving, the computer is indicating
that you have a problem. You should take your vehicle in
soon for service.
2-78