Door Lock Switch Test
1. Remove the inner handle trim.
2. Disconnect the 3P connector from the door lock
switch.
3P
CONNECTOR
INNER HANDLE TRIM
3. Check for continuity between the terminals in each
switch position according to the table.
DOOR LOCK SWITCH
TERMINAL SIDE OF MALE TERMINALS
Remote Transmitter Replacement
Use the following procedure when replacing one or both
remote transmitters:
1. Open the driver's door.
2. Press and hold the driver's master door lock switch
up in the UNLOCK position.
3. Quickly insert and remove the key from the ignition
switch five times, then insert the key the sixth time,
and leave it in the ignition switch.
(This routine must be done within 10 seconds.)
All the doors will lock and unlock to indicate that
the control unit is in the program mode.
4. Press either button on the replacement transmitter.
All the doors except the driver's door will lock and
unlock to indicate that the control unit has accepted
the transmitter into its memory. If either transmitter
button is pressed again, all the doors will lock and
unlock.
5. To program a second transmitter, press either but-
ton on that transmitter. The doors should lock and
unlock as described in step 4.
6. Release the driver's master door lock switch.
7. To exit the program mode, close the driver's door
or remove the key from the ignition switch.ProCarManuals.com
