15.6.2.2 Programmed Wash / Wipe Operation
The end of the switch lever must be pressed inwards for the windscreen wash and wipe operation. Wash / wipe con- tinues for as long as the lever is pressed.
When released, the windscreen wiper stops immediately and the wiper blades sweep for
a further three wipes.
On pressing the end of the switch lever inward and then releasing
it, the windscreen washers operate for approximately
two seconds before stopping, whilst the wiper blade continues for a further three wipes.
N&: If the end of the switch lever is pressed while the washer fluid warning light is illuminated, the windscreen
washers, but not the wiper blade continues to operate.
0
15.6.2.3 Headlamp Power Wash Operation (where fitfed)
The headlamp power wash operates only when the programmed washer/ wipe function is selected and the side lights
are 'ON'
The headlamp power wash does not operate if the windscreen washer reservoir fluid lever is low. This is indicated
by the washer fluid level warning light illuminating.
&&: The headlamp power wash only operates on the 1st and every 6th succeeding cycle of the programme wash /wipe switch, after the ignition switch has been turned to position '11'.
X300 VSM 17 Issue 1 August 1994
